JL Audio Stealthbox SB-GM-TRKEXT/10W1v2/BK Bedienungsanleitung

Sheet SKU#011120 Revision 8/8/00

SB-GM-TRKEXTP/10W1, JL AUDIO, Inc 1997 • Page 1

SB-GM-TRKEXTP/10W1 Stealthbox™

Fits 1988 - 1998 Extended-Cab

Full-Size GM Pickup Trucks

Installation Guide:

This Stealthbox is a product which requires professional installation skills and tools. Please read this

installation guide thoroughly before beginning the project. It will guide you step by step through the

installation. Several of the steps in this process may require two people to accomplish.

It is absolutely vital that the enclosure be properly mounted to the vehicle according to these instruc-

tions. Failure to mount the enclosure properly presents two problems: 1) the sub-bass performance

will suffer due to the movement of the enclosure caused by the force exerted by the woofer and 2) A

loose enclosure presents a serious safety hazard in the event of a collision or sudden deceleration.

This enclosure can be used independently or in conjunction with Stealthbox model SB-GM-TRKEXTD/

10W1, which fits on the driver's side under the rear bench seat.

STEP 1: Fold the rear bench seat up.

STEP 2: Permanently remove the under-seat tool box. All

holes used for mounting the tool kit should be sealed with

rubber plugs or silicone (not included). The mounting area

must not have any protrusions rising up from the floor.

STEP 3: Run speaker wires to the rear of the cab under the bench seat.

STEP 4: Peel the backing from the supplied square of wax and

place it on the floor of the cab, covering the factory tool kit

mounting hole as shown.

STEP 5: Thread the bolt into the threaded insert in the Stealthbox. Tighten Fully.

Sheet SKU#011120 Revision 8/8/00

3/8" Bolt

Split Lock Washer

Flat Washer Car's Sheet Metal

Enclosure Wall (fiberglass) Threaded Insert

Molded into

Enclosure

Bead of Silicone Sealant

STEP 6: Place the Stealthbox in its mounting location on the floor of the cab. Press down on the

enclosure firmly to make an impression on the wax sheet with the head of the mounting bolt.

STEP 7: Remove the enclosure. There should be a clear mark where the bolt pressed into the wax

square.

CAUTION: The mounting hole is near the exhaust system of the vehicle. Make sure that it has had

time to cool before proceeding with the following steps.

STEP 8: Check under the truck for any loose brake lines, fuel lines or other hazards before drilling.

STEP 9: Drill a 1/2" diameter hole through the floor pan of

the truck using the indentation in the wax square as a guide.

Make sure you hold the drill straight and that the hole you are

drilling is centered on the wax mark. Always wear eye protec-

tion when drilling.

STEP 10: Trim speaker wire to length and connect to the enclosure's barrier strip observing correct

polarity. Positive is designated by the red wire on the barrier strip.

STEP 11: Place the Stealthbox into its mounting location, tucking the excess wire neatly out of sight.

Turn on the system and test the enclosure's operation before bolting it down.

STEP 12: While one person holds the Stealthbox in place inside the truck, bolt the enclosure into place

from underneath the truck, using the supplied hardware. Before tightening the bolt, apply a bead of

silicone sealant between the flat washer and the vehicle's floor pan. Then tighten the enclosure fully.

See diagram below:

Silicone Sealant

Supplied Hardware:

(1) 4" sheet wax square

(1) 3/8" x 1" Bolt

(1) Flat washer

(1) Split lock washer

IMPORTANT!!!

Once the bolts are tightened, spray undercoating onto the bolt heads to prevent rust, leaks and

loosening of the bolts over time. Failure to do so may result in severe corrosion and may present a

serious safety hazard.

SB-GM-TRKEXTP/10W1, JL AUDIO, Inc 1997 • Page 2

Sheet SKU#011120 Revision 8/8/00

10369 N. Commerce Pkwy, Miramar, Florida 33025-3921 Voice: (954) 443-1100 Fax: (954) 443-1111

Specifications:

Enclosure Type: Acoustic Suspension (Sealed)

Driver Type: JL AUDIO 10W1-4 Subwoofer

Cont. Power Handling: 125 Watts

Nominal Impedance: 4Ω

Special Information on using this Stealthbox with its partner enclosure, the SB-GM-TRKEXTD/10W1:

Both enclosures are shipped with 4 ohm 10W1

subwoofers. Should you wish to run both to a single ampli-

fier, we recommend running them in stereo (one box to

each amplifier channel). In some cases, your amplifier may

be capable of driving a 2 ohm mono load which is achiev-

able by wiring the two boxes in parallel and connecting them

to the mono-bridged amplifier. Before attempting this make

sure that the amplifier is designed to drive an impedance

this low.

If you would like to achieve a 4 ohm mono load, the 4 ohm

10W1's may be replaced with 8 ohm 10W1's with no

penalty in performance. To achieve a 4 ohm mono load

with two 8 ohm 10W1's connect them in parallel to the

mono-bridged amplifier.

SB-GM-TRKEXTP/10W1, JL AUDIO, Inc 1997 • Page 3

Both Enclosures Installed

SB-GM-TRKEXTD and SB-GM-TRKEXTP

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere JL Audio Subwoofer Handbücher

JL Audio

JL Audio M6-10IB-L Bedienungsanleitung

JL Audio

JL Audio 10IB4 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-GM-SLVCRW/10W1v2 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-GM-BURBCNSL/10W3v2 Bedienungsanleitung

JL Audio

JL Audio MX10IB3 Bedienungsanleitung

JL Audio

JL Audio FATHOM ICS-SYS-108 Bedienungsanleitung

JL Audio

JL Audio Fathom IWS-SYS-2 Bedienungsanleitung

JL Audio

JL Audio Fathom f212 Bedienungsanleitung

JL Audio

JL Audio M10IB5 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-N-PTHFNDR/10W Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-B-X5/10W1v2 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-N-370/10W3v3 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-H-S2000/10W3 Bedienungsanleitung

JL Audio

JL Audio 12TW1-2 Bedienungsanleitung

JL Audio

JL Audio FS110-W5 Bedienungsanleitung

JL Audio

JL Audio 10W1v2-4 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-GM-CLREXT/10W3v2 Bedienungsanleitung

JL Audio

JL Audio Dominion d110 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-GM-ESC/10W1v2 Bedienungsanleitung

JL Audio

JL Audio 10W6AE Bedienungsanleitung

JL Audio

JL Audio 10TW1-2 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-T-4RNR/10W Bedienungsanleitung

JL Audio

JL Audio 6W3v3-4 Bedienungsanleitung

JL Audio

JL Audio 12W6v3 Bedienungsanleitung

Beliebte Subwoofer Handbücher anderer Marken

Sony

Sony XS-AW8 Bedienungsanleitung

Sony

Sony XS-L836 Bedienungsanleitung

B&C Speakers

B&C Speakers 15 HPL 76W Bedienungsanleitung

Velodyne

Velodyne DD-18+ Bedienungsanleitung

Sonance

Sonance Cinema Series SUB 10-150 Bedienungsanleitung

Hifonics

Hifonics HW-12 Kurzanleitung

Magnat Audio

Magnat Audio ADR 130 BP Bedienungsanleitung

Blitz

Blitz BZP106 Bedienungsanleitung

Technics

Technics SB-AS500 Bedienungsanleitung

Lyngdorf

Lyngdorf BW-2 Bedienungsanleitung

Lyngdorf

Lyngdorf BW-3 Bedienungsanleitung

Pyle Pro

Pyle Pro PYLE PRO PDW15125 Bedienungsanleitung

REL Acoustics

REL Acoustics Q Series Bedienungsanleitung

L-Acoustics

L-Acoustics KIVA SB15M Kurzanleitung

Pioneer

Pioneer Elite S-W1EX Bedienungsanleitung

B&C Speakers

B&C Speakers Woofer 12 HPL 76 Bedienungsanleitung

KEF

KEF KUBE 200 Bedienungsanleitung

Yamaha

Yamaha SW500 Bedienungsanleitung