JOCCA 1463 Bedienungsanleitung
(EN) Instructions manual
(ES) Manual de instrucciones
(FR) Manuel d’instructions
(IT) Istruzioni per l’uso
(PT) Manual de instruções
(DE) Gebrauchsanweisung
Ref: 1463N
DESCRIPTION/ DESCRIPCIÓN/ DESCRIPTION/
DESCRIZIONE / DESCRIÇÃO/
BESCHREIBUNG
k.
f.
e.
j.
c.
p.
d.
g.
o.
h.
m.
n.
l.
b.
q.
EN
3
STAND FAN
PURCHASE ACKNOWLEDGEMENT
Thank you for your purchase we are confident that you will be satisfied
with this item.
PRODUCT DESCRIPTION
a-Support base
b-Front protecting grid
c-Rear protecting grid
d-Blades
e-Motor
f-Motor suport axle
g-Safety clips
h-Height regulator
j-Stop/Turn button
k-Speeds
SAFETY WARNINGS
-These instructions are highly important, please
read this instruction manual before using the
device and save it for future reference.
-JOCCA is only responsible for proper use of this
product as describe in this manual.
- Before using the device for the first time, unpack
and verify that it is in perfect condition, if not,
do not use the device and go to JOCCA as the
warranty covers all manufacturing defects.
-This product is only suitable for domestic use.
Do not use the device outdoors. Do not leave the
device upon exposure to outside factors such as
rain, snow, sun, etc.
-This appliance can be used by children of 8 and
above, and people with reduced physical, sensory
Accessories
l-Plastic embellisher 1
m-Plastic embellisher 2
n-4 screws
o-Screw for blades
p-Rear grid fixing nut
q-Blade fixing nut
EN
4
or mental capabilities or lack of experience or
knowledge if they are supervised or instructed in
an appropriate and safe way about the use of the
appliance and understand the hazards involved.
Any cleaning and maintenance must be carried
out by the user or if they are carried out by a child
of 8 or above they must be supervised.
-Keep the appliance and its cable out of the reach
of children under 8 years old.
-Children should be supervised to ensure they do
not play with the device.
-If the power supply cable or the plug are
damaged, do not use the appliance or try to
replace the cable yourself. Contact the customer
service where they will replace it correctly for you.
-Do not pull the cable to unplug the appliance
from the mains, always pull from the plug.
-Do not immerse the appliance or any part of it in
water or any other liquid.
-The electricity supply cable should always be
completely unro- lled to avoid overheating.
-If your appliance has been dropped or fallen into
water or any other liquid do not use it or try to
repair it. Take it to the JOCCA technical service.
-For your safety and for the appliance to work
correctly, always use JOCCA spare parts and
accessories.
-Do not use the cable to transport or to raise the
appliance.
EN
5
-Please make sure that the 0/ OFF is pressed
before plugging into the mains electricity supply.
-The appliance should always be unplugged when
not in use, before cleaning the same, of if it does
not operate correctly.
-The appliance must not be wall or ceiling
mounted. It must always be placed on a dry flat
surface in a well ventilated area.
-Please do not use the appliance near a source of
heat, such as a fireplace, kitchen stove, heating
appliance etc....
-Do not cover the air vent with the appliance in
operation.
-Do not use the fan without the protection grids or
if the protection grids are not correctly installed.
-Do not use the appliance with wet hands or
barefoot.
-Never touch the moving parts of the appliance.
Never put your fingers or any other object in the
air inlet or outlet. Never insert any object that
might block or break the appliance.
- Do not use the appliance in association with a
programmer, timer or other device that
automatically switches it on.
INSTRUCTIONS FOR USE
Appliance assembly and start up:
-Before starting any assembly operation, please ensure that the
appliance is in the O position and that it is not connected to the mains
electricity supply.
EN
6
-Put the two long supports in a crossed position to form the base
support.
-Then screw down the height adjustment spindle on the base of the
cross with the 4 screws supplied.
-Put embellisher 1 on the base and then screw on embellisher 2 and
adjust to the desired height.
-Take the motor and place it on the spindle. To fix it in place tighten
the butterfly nut and bolt that is supplied with this part.
-Put the rear protecting grid in place in the holes and tighten down the
fixing nut to the right as far as possible, then put the blades in place
and tighten down the blade fixing nut to the left.
-Finally put the front protecting grid in place in the two top holes fixing
the same with the protection clips.
-Once the two protecting grids are in place, tighten them down with the
nut and bolt and close all the safety clips.
To put the fan blades in place, please take the following steps:
1.-Put in place the rear protecting grille by pushing the studs through
the holes in the grille support.
2.-Screw the fixing nut down tightly to the right (“p”)
3.-Put the fan blades in place on the motor spindle, taking into
consideration that the blades themselves fit in perfectly with the two
spindle stops (please see illustration)
4.-Screw the blade fixing nuts down tightly (“q”) towards the left 5.-Put
in place the front protecting grille by fitting together the hole and the
protection clips.
6.-Once the two protecting grilles are in place, fix them down with the
screw and snap down all the safety clips.
Starting up the appliance:
-Please ensure that the ON/OFF switch is in the 0/ OFF position before
plugging it into the mains electricity supply.
-Connect the appliance to the mains electricity supply.
-Please choose the airflow speed you require. Three positions can be
selected:
“1” – low airflow.
“2” – medium airflow.
“3” – maximum airflow.
-For the fan to sweep from left to right, press down the stop/sweep
button located on the rear of the fan. If you want to stop the fan from
sweeping pull the button upwards gently and it will stop sweeping
immediately.
EN
7
-The tilting of the fan can be done manually. To do this, turn off the
fan, take hold of the motor body in your hands and adjust the fan
head by pushing gently to the angle desired. Once this has been
done you can turn on the fan again.
-Please always unplug the appliance once you have finished using the
same.
CLEANING AND STORAGE
-Before cleaning, please ensure that the appliance is disconnected from
the mains electricity supply.
-Clean the appliance firstly with a slightly dampened cloth and then
with a dry cloth.
-Clean the grid from time to time with a brush to eliminate any dust
that might have accumulated on the same.
-Dismantle the fan in the opposite way to which it was assembled and
clean the blades with soapy water.
-Please do not use abrasive detergents or products that might damage
the appliance.
-Please use a damp cloth to clean the motor base.
-NEVER SUBMERGE THE MOTOR BASE IN WATER OR ANY OTHER
LIQUID.
-Store the appliance in a dry place.
TECHNICAL DATA
220-240V ~ 50/60Hz 40W
This appliance conforms to the safety requirements and provi- sions
of directives 2014/35/EU on Low tension devices and 2014/30/EU on
Electromagnetic Compatibility.
PROTECTION OF THE ENVIROMENT DIRECTIVE 2012/96/EC
This product has been designed and manufactured with high quality
materials and components that can be recycled and reused. When you
see the symbol of a crossed out litter bin on wheels next to a product,
this means that the product conforms to the European Directive
2012/96/EC. Please obtain information about the local recycling
system for electric and electronic products. Follow the local rules and
do not dispose of used products by throwing them in the normal bins
at home.
Proper recycling of your used product will help avoid negative impacts
on the environment and people’s health.
EN
8
Description Symbol Value Unit
Maximun fan flow rate F 29.88 m3 /min
Fan power input P 39.8 W
Service value SV 0.75 (m3 /min) W
Stand by /off power
consumption PSB 0W
Fan sound power level LWA 52.6 dB(A)
Maximium air velocity C 2.02 meters/sec
Seasonal Electricity
consumption Q12.736 kWh/a
PRODUCT RECYCLING – ENVIROMENT
Packaging
The materials used in the package of thi item areincluded
in a system of waste collection, sorting and recycling. If you
wish to dispose of these materials, you should use rubbish
bins or other means of waste collection that are appropriate
for each type of material.
Electrical and Electronic Product
This symbol means that if you wish to dispose of this product
at the end of its life, you must take it to a waste collection
company authorized for the selective collection of Waste
Electronic and Electrical Equipment (WEEE). This product does
not contain concentrations of materials considered harmful to
the environment.
9
ES
VENTILADOR DE PIE
AGRADECIMIENTO DE COMPRA
JOCCA, le agradece la confianza depositada en nuestros productos y
estamos seguros que quedará completamente satisfecho con cualquiera
de éstos. Para atender mejor todas sus dudas y necesidades, el servicio
de atención al cliente de JOCCA, queda a su plena disposición para
solucionar cualquier consulta.
DESCRIPCIÓN DE PRODUCTO
a-Base soporte
b-Rejilla protección delantera
c-Rejilla protección trasera
d-Aspas
e-Motor
f-Eje soporte motor
g-Clips de seguridad
h-Regulador de altura
j-Botón de paro/giro
k-Velocidades
ADVERTENCIAS DE SEGURIDAD
-Estas instrucciones son muy importantes lea
atentamente este manual de instrucciones antes
de utilizar el aparato, y guárdelo para posteriores
consultas.
-JOCCA no se responsabilizará de las posibles
consecuencias derivadas de un uso inadecuado
del producto, u otro uso que no estuviera descrito
en este manual.
-Antes de utilizar el producto por primera vez,
desembale el producto y compruebe que está
en perfecto estado. De no ser así, no utilice el
aparato y diríjase a JOCCA ya que la garantía
Accesorios
l-Embellecedor de plástico 1
m-Embellecedor de plástico 2
n-4 tornillos
o-Tornillo para rejillas
p-Tuerca de fijación rejilla
trasera
q-Tuerca de fijación aspa
10
ES
cubre cualquier daño de origen o defecto de
fabricación.
-Este producto sólo está indicado para un
uso doméstico. No uti- lizar el aparato en la
intemperie. No deje el aparato bajo la expo- sición
de agentes climáticos como la lluvia, nieve, sol,
etc., que puedan deteriorar su funcionamiento.
-Este aparato pueden utilizarlo niños con edad
de 8 años y superior y personas con capacidades
físicas, sensoriales o mentales reducidas o falta
de experiencia y conocimiento, si se les ha dado
la supervisión o instrucción apropiadas respecto
al uso del aparato de una manera segura y
comprenden los peligros que implica. Los niños
no deben jugar con el aparato. La limpieza y el
mantenimiento a realizar por el usuario no deben
realizarlos los niños a menos que sean mayores
de 8 años y estén bajo supervisión.
-Mantener el aparato y su cable fuera del alcance
de los niños menores de 8 años.
-Este aparato está pensado para que lo usen los
adultos. No permita que lo usen personas no
familiarizadas con este tipo de producto, personas
discapacitadas o niños.
-Antes de conectar el aparato a la red eléctrica
compruebe que el cable y el enchufe están en
perfecto estado, además compruebe que la
tensión indicada en el aparato es válida para su
instalación eléctrica.
Inhaltsverzeichnis
Sprachen:
Andere JOCCA Lüfter Handbücher
