Jura Impressa e Bedienungsanleitung

Impressa E Quick Reference Guide

This Guide does not replace the Operating Instructions.

For details and cautions you must read all instructions.

Traces of Coffee Grounds in New Machine?

This is normal! Grinder was tested during assembly with beans.

Despite cleaning, traces of ground coffee may be found.

RED TEXT represents information in the display.

A) First Time Ever Preparation

Place machine on flat, hard surface. Remove sticker from

LED display.

1. Fill water in tank and beans in bean container.

2. DO NOT install the Water Filter Cartridge now!

3. Push ON/OFF button. OPEN TAP.Place a cup under-

neath the frother and turn the SELECTOR to the water

symbol. FILLING.Water pumps through the frother into

the cup and stops automatically. SHUT TAP.Turn the

SELECTOR to the Cup Symbol. SYSTEM FILLING.

HEATING.After two minutes PRESS RINSE.

4. Place a cup underneath the coffee spouts and push the

RINSE button. READY.Place a large cup underneath the

coffee spout and press the 1-CUP button. The machine

starts grinding and brews coffee. Discardthe first two

cups. READY.You can only brew coffee when the display

shows READY.

B) Daily Preparation

• Fill fresh water in tank and check bean container.

• Push ON/OFF button: HEATING.RINSE.

• Place a cup under the coffee spouts and press the RINSE

button. READY.

C) FactorySettings:

Filter: –

Hardness: Level 2

Aroma: ROBUST

Auto Off: 2 HRS

Stats:

Language: English

ML / OZ: OZ.

Rinse: ✔

a. Coffee

b. Steam/Hot Water

Selector

f.Rinse

g. Steam

h. Pre-Ground

Coffee

e. Programming

a. On/Off

b. 1-Cup

mild

normal

strong

d. 2-Cup

e. Dial

READY

LED

Display

Frother

sleeve

slides up

and down

D) Grinding and Brewing

• Push the DIAL.Display shows the cup size, e.g. 4.0 OZ.

• Turn the DIAL to change the cup size from 1.0 to 8.0 OZ.

• Coffee Strengths: Push the 1-CUP button once: MILD,

twice NORMAL,three times STRONG.

• When pushing the 2-CUP button, the machine will brew

twice as much coffee as set with the 1-CUP button.

HOTTER COFFEE? Pre-warm cup with hot water through

frother. See chapter F "Using Hot Water". Empty cup and

brew coffee.

E) Changing the Grinder Fineness

Important: You can only adjust the fineness during the actual

grinding process.

• Open the bean container lid and turn the dial while grinding:

thicker bars: coarser grind; thinner bars: finer grind.

• For darker, oily beans – grind somewhat coarser.

For lighter beans – grind somewhat finer.

F) Using Hot Water

• Place a cup underneath the frother. Turn the SELECTOR

to the water symbol, e.g. 5 OZ.

• Turn the DIAL to select to desired amount of water.

WATER.SHUT TAP. Turnthe SELECTOR to the Coffee

Symbol. You can always stop the hot water flow before

the display shows SHUT TAP.

G) Using Steam (Frothing and Steaming)

Important: Frother parts must be tightly connected and clean.

•Cappuccino:One shot espresso plus ~4 oz. of steamed

and frothed milk. Frother sleeve DOWN.

•Latte:One shot espresso plus ~4 to 5 oz. of steamed

milk. Frother sleeve UP: steaming only (no frothing).

1. Push the STEAM button. HEATING.After ~20 sec.:

STEAM READY.

2. Immerse the frother into a pitcher with milk and turn the

SELECTOR to the water symbol, e.g. 40 SEC. Turnthe

DIAL to select to desired steaming time (3 to 120 sec).

STEAM.Steam pushes into the milk.

3. SHUT TAP. Turn the SELECTOR to the Cup Symbol. You

can always stop the steam output with the SELECTOR.

4. Repeat process for additional steam.

5. After steaming you can immediately brew coffee.

Knocking Noise during Frothing: The pumps dispenses

water droplets into the heating system.

Please note: Skim and 1% milk will produce more froth

than 2% and regular milk.

HOTTER MILK? After frothing the milk, use the steaming

position (Frother sleeve UP) to increase the milk temperature.

H) Cleaning the Frother

Within 10 min. after last use, place a cup under the frother.

Turn the SELECTOR for 5 sec. to the Hot Water symbol. For

thorough cleaning see page 15 of the Operating Instructions.

J) Programming

Push and hold the Pbutton until the display shows FILTER -.

Turn the DIAL to access the other functions: HARDNESS,

AROMA,AUTO OFF,STATS,LANGUAGE,ML/OZ,RINSE ✔.

Select the function, push the DIAL,turn DIAL to see or

select option. Push DIAL to confirm. Push Pbutton to get

back to READY.For details see Operating Instructions.

K) Installing and Activating the Clearyl Water Filter

NOTE: Using the Clearyl Water Filter avoids decalcifying.

1. Rinse cartridge under running water. Insert cartridge

into water tank reception and close the cartridge holder.

2. Fill tank with cold water. Push and hold the Pbutton:

FILTER -.Push the DIAL:NO -.Turn DIAL:YES ✔.

3. Push DIAL.INSERT / OPEN TAP.Place a container

(20 oz.) under the frother. Turn the SELECTOR to the

water symbol. FILTER RINSING.

4. After 90 sec.: SHUT TAP.Turn the SELECTOR to the cup

symbol. HEATING.READY.

The display will remind you when to replace the filter.

Please note: When the filter program is activated, the

decalcifying program (HARDNESS) is turned off.

Important: Do not let the filter dry out. Filter needs to be

submersed in water. See page 16, Operating Instructions.

L) Replacing and Activating the Clearyl Water Filter

When display shows CHANGE FILTER / MACHINE READY

• Remove old filter, rinse new filter under running water and

insert(see above). Place a large container (20 oz.) under

the frother and push the RINSE button. The DIAL illuminates.

• Turn the DIAL until the display shows FILTER.

• Push the DIAL.the display shows REPLACE OPEN TAP.

• Turn the SELECTOR to the water symbol. FILTER

RINSING. See Chapter K,4 above.

Important: If message CHANGE FILTER / MACHINE READY

does not show up after 3 months, you must replace the filter.

M) Cleaning with Special Tablet

This cleaning cycle removes coffee oils inside the machine.

This message will appear after 200 cups of coffee: CLEAN

MACHINE / MACHINE READY.Takes less than 15 minutes!

Important: Only use the special white round cleaning tablet!

Important: Once started, do not interrupt the program!

1. Fill water tank. Push the RINSE button. EMPTY DRAWER.

Please note: You must remove the drawer for 20 seconds

even if it is empty. Replace complete drawer.

2. PRESS RINSE.Push the RINSE button. CLEANING.After

amoment the display shows ADD TABLET / PRESS RINSE.

3. Drop one white tablet into the "ground coffee funnel."

Push the RINSE button. CLEANING.After a few minutes:

EMPTY DRAWER.Carefully lift, remove and empty drawer

and replace. READY.The machine resets itself and

reminds you to clean again after the next 200 cups.

N) Decalcifying DESCALE MACHINE / MACHINE READY

For different water hardness levels see Operating Instructions.

If a water hardness level is selected, the decalcifying monitor

is active. Decalcify when above message appears.

Important: If you use the Clearyl Filter and the above

message appears, then the Clearyl Installation procedure

was not performed properly. See chapter K2 to K4 above.

Important: The decalcifying program must not be interrupted.

• Use only the special decalcifying tablets (not the cleaning

tablets!). For decalc tablet supply see below.

1. Push the RINSE button; the display shows EMPTY

DRAWER.

2. Remove and empty drawer. You must remove the drawer

for 20 seconds, even if it is empty. Replace complete

drawer.

Decalcifying Session:

3. SOLVENT IN TANK.Dissolve three large square tablets in

16 oz. of water,remove tank and pour mixture into empty

water tank and replace.

4. Place a container (at least 16 oz.) underneath frother.

SOLVENT IN TANK OPEN TAP.Turn the SELECTOR to

the water symbol. DECAL ON.After a few minutes:

SHUT TAP.Turn the SELECTOR to the cup symbol.

DECAL ON.After a few minutes EMPTY DRAWER.

5. Carefully remove container and drawer, empty and

replace.

Cleaning Session:

6. FILL WATER.Rinse water tank and fill with cold water

(16 oz.) and replace. Place a container under the frother.

7. OPEN TAP. Turnthe SELECTOR to the water symbol.

DECAL ON.After a few minutes: SHUT TAP.Turn the

SELECTOR to the cup symbol. DECAL ON.After a few

minutes EMPTY DRAWER.Carefully remove container

and drawer,empty and replace.

8. PRESS RINSE.Push the RINSE button. The machine

returns to READY and resets itself.

CAPRESSO CUSTOMER SERVICE 1-800-220-5701

Monday – Thursday: 9AM – 9PM EST

Friday: 9AM – 8PM EST

Saturday: 9AM – 5PM EST

email: [email protected]

Fax: 201-767-9684

O) Supplies can be ordered through:

Customer Service or Mail Order Form or www.capresso.com:

•Clearyl Water Filter Cartridge: #64553

•Special Cleaning Tablets: #62205

•Decalcifying Tablets: #61848

•Cappuccino Cleaner: #63801, removes milk fat from frother

•Grand Aroma Coffee Beans: #921, regular, decaf, espresso

64716R2/1006

Inhaltsverzeichnis

Andere Jura Kaffeemühle Handbücher

Jura

Jura P.A.G. Bedienungsanleitung

Beliebte Kaffeemühle Handbücher anderer Marken

SOLAC

SOLAC All4Coffee MC6253 Bedienungsanleitung

Teesa

Teesa TSA4011 Bedienungsanleitung

Somogyi Elektronic

Somogyi Elektronic home HG KD 40 Bedienungsanleitung

tomado

tomado TM-1287 Bedienungsanleitung

Aicok

Aicok CG9220 Bedienungsanleitung

Zelmer

Zelmer ZCG7925 Bedienungsanleitung

Baratza

Baratza Vario Bedienungsanleitung

Baratza

Baratza Forté Bedienungsanleitung

Isomac

Isomac ROBY Bedienungsanleitung

Eldom

Eldom Dott MK60 Bedienungsanleitung

Bunn

Bunn SAFETY-FRESH 1 GPR Bedienungsanleitung

Baratza

Baratza Forté AP Bedienungsanleitung

FAMITEC

FAMITEC BOLD Bedienungsanleitung

Santos

Santos SC55 Betriebsanleitung

Lumme

Lumme LU-2601 Bedienungsanleitung

TREVIDEA

TREVIDEA Girmi MC02 Bedienungsanleitung

Eureka

Eureka Zenith E Bedienungsanleitung

Baratza

Baratza Maestro Bedienungsanleitung

Jura impressa e Bedienungsanleitung

Beliebte Kaffeemühle Handbücher anderer Marken