JVC KD-S5050 - In-Dash CD Player Bedienungsanleitung
SERVICE MANUAL
COPYRIGHT © 2003 VICTOR COMPANY OF JAPAN, LIMITED No.MA026
2003/11
CD RECEIVER
MA026200311 KD-S5050
TABLE OF CONTENTS
1 PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3
2 SPECIFIC SERVICE INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-5
3 DISASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-6
4 ADJUSTMENT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-24
5 TROUBLESHOOTING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-25
Area suffix
J -------------- Northern America
SEL
DISP
78 910 11 12
KD-S5050
DIRECT TRACK ACCESS
1-2 (No.MA026)
SPECIFICATION
Design and specifications are subject to change without notice.
AUDIO AMPLIFIER SECTION
Maximum Power Output Front 45 watts per channel
Rear 45 watts per channel
Continuous Power Output (RMS) Front 17 watts per channel into 4 Ω, 40 Hz to 20 000 Hz at no
more than 0.8% total harmonic distortion.
Rear 17 watts per channel into 4 Ω, 40 Hz to 20 000 Hz at no
more than 0.8% total harmonic distortion.
Load Impedance 4 Ω(4 Ωto 8 Ωallowance)
Tone Control Range Bass ±10 dB at 100 Hz
Treble ±10 dB at 10 kHz
Frequency Response 40 Hz to 20 000 Hz
Signal-to-Noise Ratio 70 dB
Line-Out Level/Impedance 2.0 V/20 kΩload (full scale)
Output Impedance 1 kΩ
TUNER SECTION
Frequency Range FM 87.5 MHz to 107.9 MHz
AM 530 kHz to 1 710 kHz
[FM Tuner] Usable Sensitivity 11.3 dBf (1.0 µV/75 Ω)
50 dB Quieting Sensitivity 16.3 dBf (1.8 µV/75 Ω)
Alternate Channel Selectivity (400 kHz) 65 dB
Frequency Response 40 Hz to 15 000 Hz
Stereo Separation 35 dB
Capture Ratio 1.5 dB
[AM Tuner] Sensitivity 20 µV
Selectivity 35 dB
CD PLAYER SECTION
Type Compact disc player
Signal Detection System Non-contact optical pickup (semiconductor laser)
Number of channels 2 channels (stereo)
Frequency Response 5 Hz to 20 000 Hz
Dynamic Range 90 dB
Signal-to-Noise Ratio 95 dB
Wow and Flutter Less than measurable limit
GENERAL
Power Requirement Operating Voltage DC 14.4 volts (11 volts to 16 volts allowance)
Allowable Working Temperature 0 º C to +40 º C (32 º F to 104 º F)
Grounding System Negative ground
Dimensions (W ×H ×D) Installation Size 182mm×52mm×150mm(7-3/16" ×2-1/16"×5-15/16")
Panel Size 188 mm ×58 mm ×11 mm (7-7/16" ×2-5/16" ×7/16")
Mass 1.3 kg (2.9 lbs) (excluding accessories)
(No.MA026)1-3
SECTION 1
PRECAUTIONS
1.1 Safety Precautions
!Burrs formed during molding may be left over on some parts of the chassis. Therefore,
pay attention to such burrs in the case of preforming repair of this system.
!Please use enough caution not to see the beam directly or touch it in case of an
adjustment or operation check.
1-4 (No.MA026)
1.2 Preventing static electricity
Electrostatic discharge (ESD), which occurs when static electricity stored in the body, fabric, etc. is discharged, can destroy the laser
diode in the traverse unit (optical pickup). Take care to prevent this when performing repairs.
1.2.1 Grounding to prevent damage by static electricity
Static electricity in the work area can destroy the optical pickup (laser diode) in devices such as CD players.
Be careful to use proper grounding in the area where repairs are being performed.
(1) Ground the workbench
Ground the workbench by laying conductive material (such as a conductive sheet) or an iron plate over it before placing the
traverse unit (optical pickup) on it.
(2) Ground yourself
Use an anti-static wrist strap to release any static electricity built up in your body.
(3) Handling the optical pickup
• In order to maintain quality during transport and before installation, both sides of the laser diode on the replacement optical
pickup are shorted. After replacement, return the shorted parts to their original condition.
(Refer to the text.)
• Do not use a tester to check the condition of the laser diode in the optical pickup. The tester's internal power source can easily
destroy the laser diode.
1.3 Handling the traverse unit (optical pickup)
(1) Do not subject the traverse unit (optical pickup) to strong shocks, as it is a sensitive, complex unit.
(2) Cut off the shorted part of the flexible cable using nippers, etc. after replacing the optical pickup. For specific details, refer to the
replacement procedure in the text. Remove the anti-static pin when replacing the traverse unit. Be careful not to take too long a
time when attaching it to the connector.
(3) Handle the flexible cable carefully as it may break when subjected to strong force.
(4) It is not possible to adjust the semi-fixed resistor that adjusts the laser power. Do not turn it.
1.4 Attention when traverse unit is decomposed
*Please refer to "Disassembly method" in the text for the CD pickup unit.
• Apply solder to the short land before the flexible wire is disconnected from the connector on the CD pickup unit.
(If the flexible wire is disconnected without applying solder, the CD pickup may be destroyed by static electricity.)
• In the assembly, be sure to remove solder from the short land after connecting the flexible wire.
1M
(caption)
Anti-static wrist strap
Conductive material
(conductive sheet) or iron plate
Pickup
Short-circuit point
(Soldering)
Flexible wire
(No.MA026)1-5
SECTION 2
SPECIFIC SERVICE INSTRUCTIONS
This service manual does not describe SPECIFIC SERVICE INSTRUCTIONS.
1-6 (No.MA026)
SECTION 3
DISASSEMBLY
3.1 Main body
3.1.1 Removing the front panel assembly
(See Fig.1)
(1) Push the detach button in the lower right part of the front
panel assembly and remove the front panel assembly.
Fig.1
3.1.2 Removing the bottom cover
(See Fig.2)
(1) Turn the main body up side down.
(2) Insert a screwdriver under the joints to release the two
joints aon the left side, two joints bon the right side and
joint con the back side of the main body, then remove the
bottom cover from the main body.
CAUTION:
When releasing the joints using a screwdriver, do not damage
the main board.
Fig.2
3.1.3 Removing the front chassis assembly
(See Fig.3)
• Prior to performing the following procedures, remove the front
panel assembly and bottom cover.
(1) Remove the screw Aon the left side of the main body.
(2) Release the two joints dand two joints eon the both sides
of the main body, then remove the front chassis assembly
toward the front.
Fig.3
Front panel assembly
Detach button
Bottom cover
Joint b
Joint b
Joint c
Joint a
Joint a
Joint d
Front chassis
A
Joint e
Joint d Joint e
(No.MA026)1-7
3.1.4 Removing the side panel
(See Fig.4)
• Prior to performing the following procedure, remove the front
panel assembly as required.
(1) Remove the screw B and two screws Cattaching the heat
sink on the left side of the main body, and remove the side
panel.
Fig.4
3.1.5 Removing the rear bracket
(See Fig.5)
• Prior to performing the following procedure, remove the bottom
cover.
(1) Remove the three screws D, three screws Eand two
screws Fattaching the rear bracket on the back side of the
main body.
(2) Remove the rear bracket.
Fig.5
3.1.6 Removing the main board
(See Fig.6)
• Prior to performing the following procedure, remove the front
panel assembly, front chassis assembly, side panel, bottom
cover and rear bracket.
(1) Remove the two screws Gattaching the main board.
(2) Disconnect the connector CN501 and remove the main
board.
Fig.6
Side panel
㧯㧮㧯
EF
DD
E
Rear bracket F
Main board assembly
G
G
CN501
1-8 (No.MA026)
3.1.7 Removing the CD mechanism assembly
(See Fig. 7)
• Prior to performing the following procedure, remove the front
panel assembly, front chassis assembly, side panel, bottom
cover, rear bracket, main board and CD mechanism board.
(1) Remove the three screws Hattaching the top chassis.
(2) Take out the CD mechanism assembly.
Fig.7
3.1.8 Removing the front board
(See Figs.8 to 10)
• Prior to performing the following procedure, remove the front
panel assembly.
(1) Remove the four screws Jon the back side of the front
panel assembly. (See Fig.9.)
(2) Release the eleven joints f. (See Fig.9.)
(3) Release the joint gand take out the front board.(See
Fig.10)
Fig.8
Fig.9
Fig.10
H
H
CD mechanism assembly Top chassis
J
J
J
Joints f
Joint fJoints f
Joints f
Joints
f
Joint f
Front board
Front panel assemb
ly
(No.MA026)1-9
3.2 CD Mechanism Assembly
3.2.1 Removing the top cover
(See Figs.1 and 2)
(1) Remove the two screws Aon the both side of the body.
(2) Lift the front side of the top cover and move the top cover
backward to release the two joints a.
Fig.1
Fig.2
A
A
A
Joints a
Top cover
Joints a
Top cover
1-10 (No.MA026)
3.2.2 Removing the connector board
(See Figs.3 to 5)
CAUTION:
Before disconnecting the flexible wire from the pickup, solder
the short-circuit point on the pickup. No observance of this in-
struction may cause damage of the pickup.
(1) Remove the screw Bfixing the connector board.
(2) Solder the short-circuit point on the connector board.
(3) Disconnect the flexible wire from the pickup.
(4) Move the connector board in the direction of the arrow to
release the two joints b.
(5) Unsolder the wire on the connector board if necessary.
CAUTION:
Unsolder the short-circuit point after reassembling.
Fig.3
Fig.4
Fig.5
B
Connector board
Pickup
Short-circuit point
Joints b
Wires
Pickup
Short-circuit point
(Soldering)
Flexible wire
B
Flexible wire
Connector board
Frame
Andere Handbücher für KD-S5050 - In-Dash CD Player
1
Inhaltsverzeichnis
Andere JVC Autoempfänger Handbücher
JVC
JVC KD-S52 Bedienungsanleitung
JVC
JVC KD-R538 Bedienungsanleitung
JVC
JVC KD-SH9105 Bedienungsanleitung
JVC
JVC KS-FX385S Bedienungsanleitung
JVC
JVC KS-FX901 Bedienungsanleitung
JVC
JVC CD Receiver KD-G417 Bedienungsanleitung
JVC
JVC KD-DV9406 Bedienungsanleitung
JVC
JVC KD-G120 - Radio / CD Player Bedienungsanleitung
JVC
JVC KD A60S Bedienungsanleitung
JVC
JVC KD-S721R Bedienungsanleitung
JVC
JVC KD-G455 Leitfaden
JVC
JVC KS-FX490 - Radio / Cassette Player Bedienungsanleitung
JVC
JVC KD-S34 Bedienungsanleitung
JVC
JVC KD-PDR31 Bedienungsanleitung
JVC
JVC KS-FX832R Systemhandbuch
JVC
JVC KW NX7000 - Double Din Navigation Leitfaden
JVC
JVC KW-R900BT Bedienungsanleitung
JVC
JVC KD-BT22 Bedienungsanleitung
JVC
JVC KW NX7000 - Double Din Navigation Bedienungsanleitung
JVC
JVC LVT2088-001B Bedienungsanleitung
Beliebte Autoempfänger Handbücher anderer Marken
Sound Storm
Sound Storm STM93R Bedienungsanleitung
Soundstream
Soundstream VIR-5000 Bedienungsanleitung
Avson
Avson MKT Platform Bedienungsanleitung
Sony
Sony MEX-1HD - Audio Library System Bedienungsanleitung
Pioneer
Pioneer DVH-P500UB Bedienungsanleitung
Blaupunkt
Blaupunkt SANTIAGO CR 87 Bedienungsanleitung
