Operating instructions
1. Connect the pads to the wire by snapping them on,
then remove the protective film.
2. Place pads where the massage sensations are desired. And plug
into one of the ports on the device.For additional relief use the
second port and repeat procedure to put on another two pads.
Make sure both pads on the skin and not overlapping. Make sure
your skin is free from any dirt, oil or lotion.
3. Turn the device on by sliding the on/ off switch on the top of the
unit. The unit will be now activated.
4. The "M" cycles through the 6 big
modes, the silver middle button allows choices (from 2 to 4 varietie
s) within that mode, totally 16 small modes.Remember the strength
will default to the lowest setting by each mode selection.
Note: Center button can also be used as a lock key.Press and hold
it for 3 seconds to lock the screen, 3 seconds again to unlock.
5. Once you select a mode, gradually increase the intensity by
pressing the + button; decrease it by pressing ‐button.
6. Recommended application is 10-60 minutes. Increase 10
minutes by each setting. The time remaining is automatically
counted down. Then the unit will automatically turn off after time
finish.
