Kenwood KNA-G421 Bedienungsanleitung

Warning

Failure to avoid the following potentially hazardous situations could result in serious injury or re.

• Do not attempt to install or service the KNA-G421 by yourself. Installing or servicing the unit without training and experience in

electronic equipment and automotive accessories may be dangerous and could expose you to the risk of electric shock or other hazards.

• When extending ignition, battery, or ground wires, use automotive-grade wires or other wires with AWG 18 (0.75 mm

gauge) or

greater to prevent wire deterioration and damage to the wire coating.

• If the unit starts to emit smoke or strange smells, turn off the power immediately and consult your Kenwood dealer.

• Keep small articles (like screws or batteries) out of the reach of children. If any such object is accidentally swallowed, consult a doctor

immediately.

Caution

Failure to avoid the following potentially hazardous situations may result in injury or property damage.

• Make sure to ground the unit to the chassis of your vehicle.

• Secure all wiring with cable clamps or electrical tape. Insulate unconnected wires; do not allow any bare wiring to remain exposed.

• Do not let unconnected wires or terminals touch metal on the vehicle or anything else that can conduct electricity.

• Do not open the top or bottom covers of the unit.

• The KNA-G421 is not waterproof.

August 2007 Part Number 190-00834-03 Rev. A Printed in Taiwan

KNA-G421 INSTALLATION MANUAL

B54-4617-08

GPS NAVIGATION SYSTEM

- 2 -

English

What’s Included

GPS antenna and

metal plate

main unit screws (4) wiring harness hook and loop

fasteners (2)

Installing the Main Unit

Use the screws or the hook and loop fasteners provided to mount the main unit in the vehicle. Select a location that allows you to

access the unit’s SD card slot. Be sure to place the unit horizontally (at) and secure it completely for best performance.

Caution

• Do not install the unit where it will be exposed to direct sunlight, excessive heat or humidity, dust, spills, or liquids. Use only the

screws provided. If you use the wrong screws, you could damage the unit.

• Check for cables or other parts underneath the oor mat before cutting the oor mat.

Installing the GPS Antenna

Caution

• Do not paint the antenna. This will impair or disable signal reception.

• Remove any object or accumulated snow, etc., from the top of the antenna. It will reduce reception strength.

• Do not pull the cord when removing the antenna or adjusting its position. This can cause a short or snap the wires.

• The permanent adhesive on the back of the metal plate is extremely difcult to remove after it is installed.

The GPS antenna can be installed either inside or outside the vehicle. It should be placed horizontally for best GPS reception.

The GPS antenna must have a clear view of the sky. If you install the antenna inside the vehicle, place it close to a window; GPS

signals can pass through glass but not through metal. Refer to the image on the next page for recommended places to install the

antenna. Place the GPS antenna on a metallic surface, such as the roof of your vehicle, for best reception. If a metallic surface is not

available, mount the GPS antenna to the enclosed metal plate. See the next page for further instructions.

Installing Optional Accessories

For information on installing the optional FM trafc receiver (such as the GTM 10), refer to the installation guide included with the

trafc receiver.

- 3 -

English

Red

To ignition (12 V)

Yellow

To battery (12 V)

Light green

Black

Ignition key switch

Car fuse box

(main fuse)

To vehicle chassis

To parking brake

detection switch

Optional accessory:

FM traffic receiver

To display unit (NAV I/F terminal)

GPS antenna

Do not connect the yellow wire

lead directly to the vehicle battery.

Connecting directly to the battery

may cause the wire insulation to

fail and may pose a risk of short

circuit and electric shock.

WARNING

If your vehicle’s ignition does not have

an ACC position, connect the ignition

wires to a power source that can be

turned on and off with the ignition key. If

you connect the ignition wire to a power

source with a constant voltage supply,

as with battery wires, the vehicle’s

battery may die.

CAUTION 2 A

2 A

Best (roof of

vehicle)

Good (inside car

on dashboard)

Better (trunk

of vehicle)

Installing the GPS antenna

SD card

WARNING

Be sure to connect the parking

brake wire to ensure safe

navigation.

Steps to Install the

KNA-G421

1. Remove the key from the vehicle’s ignition

and disconnect the negative battery cable.

2. Install the GPS antenna. Refer to the tips

on the previous page.

3. Connect the wiring harness to your vehicle

in the following order: ground, battery,

ignition.

4. Connect the wiring harness to the

main unit.

5. Install the main unit. Refer to the tips on the

previous page.

6. Reconnect the negative battery cable.

To mount the GPS antenna inside your vehicle:

1. Clean your dashboard or other surface.

2. Peel the backing off of the adhesive on the bottom of the metal plate.

3. Pressthemetalplatedownrmlyonyourdashboardorother

mounting surface. You can bend the metal plate to conform to a

curved surface, if necessary.

4. Place the GPS antenna on top of the metal plate.

- 4 -

English

Acquiring GPS Signals

The rst time you turn on the KNA-G421, you must wait while the system acquires satellite signals for the rst time. This process

could take up to several minutes. Make sure your vehicle is outdoors in an open area away from tall buildings and trees for fastest

acquisition. After the system acquires satellites for the rst time, it will acquire satellites quickly each time thereafter.

Changing the Fuses

If you need to replace a fuse on the red or yellow wires, make sure the wires are not touching to prevent a short circuit. Then replace

the old fuse with a new 2 Amp fuse.

Caution

When replacing a fuse, use only a new fuse with the prescribed rating. Using a fuse with the wrong rating may cause your unit to

malfunction. Disconnect the wiring harness before replacing a fuse to prevent short circuits.

Specications

General

Operating Temperature: -15°C to 70°C

Storage Temperature: -40°C to 85°C

Operating Voltage: 9.5 V to 25 V

Current Consumption: 0.13 A typical at 13 V (Max 1.0 A at 13 V)

ACC off Current: 60 uA typical at 13 V

Dimensions: 30 mm H x 120 mm W x 117 mm L

Weight: 184 g

Map Storage: Internal non-removable memory and optional removable SD card (City Navigator™ map data)

Connectors: System/power,GPSantenna,SDcardslot,Mini-BforoptionalFMtrafcreceiver

Navigation

Receiver: SiRF STAR III high-sensitivity GPS receiver

Frequency: 1,575.42 MHz

Acquisition Times*:

Warm: < 1 second

Cold: < 38 seconds

AutoLocate®:< 45 seconds

*On average for a stationary receiver with an open sky view

Update Rate: 1/second, continuous

GPS Accuracy:

Position: < 10 meters, typical

Velocity: 0.05 meter/sec RMS

DGPS (WAAS) Accuracy:

Position: < 5 meters, typical

Velocity: 0.05 meter/sec RMS

Antenna: External GPS antenna requires metal surface 60 mm x 60 mm or larger, such as a car roof or the included metal

plate. A larger metal mounting surface improves GPS reception.

Andere Handbücher für KNA-G421

Inhaltsverzeichnis

Andere Kenwood GPS Handbücher

Kenwood

Kenwood KNA-G630 Bedienungsanleitung

Kenwood

Kenwood DNX7330BT Bedienungsanleitung

Kenwood

Kenwood DNX9210BT Bedienungsanleitung

Kenwood

Kenwood KNA-G520 Bedienungsanleitung

Kenwood

Kenwood DNX994S Bedienungsanleitung

Kenwood

Kenwood DNX9280BT Bedienungsanleitung

Kenwood

Kenwood DNX512EX Bedienungsanleitung

Kenwood

Kenwood DNN9330BT Bedienungsanleitung

Kenwood

Kenwood DNX9980HD Bedienungsanleitung

Kenwood

Kenwood DNX9210BT Bedienungsanleitung

Kenwood

Kenwood DNN992 Bedienungsanleitung

Kenwood

Kenwood KNA-NT100 Bedienungsanleitung

Kenwood

Kenwood DNX521DAB Bedienungsanleitung

Kenwood

Kenwood Specifications Bedienungsanleitung

Kenwood

Kenwood KNA-V10 Bedienungsanleitung

Kenwood

Kenwood DNX6140 - Navigation System With DVD player Bedienungsanleitung

Kenwood

Kenwood DNX9990HD Bedienungsanleitung

Kenwood

Kenwood DNX210EX Bedienungsanleitung

Kenwood

Kenwood DNX7340BT Bedienungsanleitung

Kenwood

Kenwood KNA-G630 Bedienungsanleitung

Kenwood

Kenwood DNX890HD, DNX7700BT, DNX690HD, Bedienungsanleitung

Kenwood

Kenwood DNX 9140 - Excelon - Navigation System Bedienungsanleitung

Kenwood

Kenwood DNX4150BTR Bedienungsanleitung

Kenwood

Kenwood DNX6460BT Bedienungsanleitung

Beliebte GPS Handbücher anderer Marken

Raven

Raven Cruizer II Handbuch

Hama

Hama 53118 Bedienungsanleitung

Garmin

Garmin SOUNDER 125 Bedienungsanleitung

Garmin

Garmin DEZL 580 Bedienungsanleitung

Jigabot

Jigabot EX Bedienungsanleitung

Pointer

Pointer Cellocator CelloTrack XT LTE Installationsanleitung

Queclink

Queclink GV55LITE Bedienungsanleitung

Voxson

Voxson Voxtrack GPS500 Gebrauchsanweisung

Garmin

Garmin ECHOMAP PLUS Bedienungsanleitung

Starcom Systems

Starcom Systems Kylos Compact Bedienungsanleitung

Garmin

Garmin 15 H Series Bedienungsanleitung

Cobra

Cobra Marine MC 600Ci Bedienungsanleitung

Cellocator

Cellocator CelloTrack T Bedienungsanleitung

Enfora

Enfora Mini-MT GSM2228UG001 Bedienungsanleitung

Magellan

Magellan eXplorist 100 Bedienungsanleitung

LTE

LTE G50B Bedienungsanleitung

Garmin

Garmin DEZL OTR500 Bedienungsanleitung

SkyGolf

SkyGolf SkyCaddie SG1 Bedienungsanleitung