KERN HCB Series Bedienungsanleitung

KERN & Sohn GmbH

Ziegelei 1

D-72336 Balingen

E-Mail: info@kern-

sohn.com

Tel: +49-[0]7433- 9933-0

Fax: +49-[0]7433-9933-149

Internet: www.kern-

sohn.com

Servicemanual

KERN HCB

Version 1.0

06/2014

HCB-SH-e-1410 - 2 -

KERN HCB

Version 1.0 04/2014

Servicemanual

Inhaltsverzeichnis

1Basic Information...........................................................................................- 3 -

2Introdution......................................................................................................- 3 -

3Introduction....................................................................................................- 4 -

3.1 Features..................................................................................................................................- 4 -

4Span Calibration.............................................................................................- 4 -

4.1 Internal Calibration Procedure...........................................................................................- 4 -

5Trouble Shooting ...........................................................................................- 5 -

6Schematics.....................................................................................................- 6 -

7Components Layout ......................................................................................- 7 -

8Spare part list.................................................................................................- 8 -

- 3 - HCB-SH-e-1410

1 Basic Information

The device must be repaired only by trained specialist staff or personnel with professional formation

(such as a repair-specialist accredited by law concerning verification). The service manual is

obligatory for repair work. After repair, original conditions of the device have to be restored. Only

original spare parts should be used.

Instructions about conformity-evaluated scales:

Repair must be carried only at 100% compliance with the type approval. A violation of this

specification will result in a loss of the type approval! After successful repair the balance will have to

be reverified before it can be used again in a statutorily regulated field.

Detailed instructions about conformity-evaluated scales:

Repair must be carried only at 100% compliance with the type approval. A violation of this

specification will result in a loss of the type approval!

After successful repair the balance will have to be reverified before it can be used again in a

statutorily regulated field.

2 Introdution

This service manual covers the HCB series and is edited for the authorized servicing personnel.

Note all rights are reserved. Copying any part of this manual is prohibited without our permission.

In this lineup it is an eco product, therefore, it is not intended to represent the repair manual in detail,

since the construction of the balance is very simple. It is therefore only referring to the list of related

to disposal spare parts.

Bei dieser Modelreihe handelt es sich um eine ECO Produkt, daher entfällt der detaillierte Teil der

Reparaturanleitung.

HCB-SH-e-1410 - 4 -

3 Introduction

3.1 Features

Tare function

Display segment test function

Display Hold function (6 modes)

Negative value indication

Low battery indicator

Auto zero

Auto off function (selectable)

Zero Tracking selectable

Overload indication

Digital Internal calibration

Solder pads to prevent end user internal calibration

Operated by 3 x AA size alkaline batteries

4 Span Calibration

1. Turn scale on by pressing the [ON/TARE/OFF] key.

2. Press the [UNIT] key for 3 seconds. Display will show [CAL] and then the required

calibration weight.

3. Hang the standard weight onto the scale. Wait until display shows [ F ] then turn off. In

case [ E ] is display instead of [ F ], this indicates a calibration procedure error, unstable

or wrong calibration weight applied for calibration. Reset the scale and repeat the

procedures.

4.1 Internal Calibration Procedure

1. Remove battery compartment door and the two screws inside. Disassemble the rear

housing of the scale.

2. Connect J1 on the PC board.

3. Install batteries. With scale on its weight position, turn scale on. Display will show the

internal counts. The reading shall fall into the range of 3000 to 5000. In case out of this

range, connect J9 to increase or decrease reading. Connect or disconnect J5, J6, or J7 to

adjust the reading to the required range.

4. Press [ON/TARE/OFF] key once. Display will show the required calibration weight. Hang

weight onto the scale accordingly until scale show [ F ] and turn off.

5. Disconnect J1. Calibration completed. Check the accuracy at different weight.

6. Install the rear housing of scale with the two screws.

- 5 - HCB-SH-e-1410

5 Trouble Shooting

Power on



Full Segments?

If no display, check batteries; keyboard / overlay; connection between

battery—main board.

If wrong segments, check fixing of LCD, zebra connector under LCD.



Display Zero?

If display [LO], check battery>3.5V.

If display [ E] , check internal count.



Proper readout?

If unstable reading, check hook, loadcell, Clearance between metal sensor

and lower plastic housing



Correct reading?

If not accurate, perform span calibration.

If cannot reach full capacity, loadcell, and internal zero point.

If always zero, check internal zero point. Internal calibration if necessary.



Normal operation.

HCB-SH-e-1410 - 6 -

6 Schematics

- 7 - HCB-SH-e-1410

7 Components Layout

HCB-SH-e-1410 - 8 -

8 Spare part list

KERN

Nummer /

KERN part

no.

Beschreibung

Description

Model

RHCB-4001

Folientastatur

Key panel

HCB

20K10

RHCB-4002

Folientastatur

Key panel

HCB

20K50

RHCB-4003

Folientastatur

Key panel

HCB

50K20

RHCB-4004

Folientastatur

Key panel

HCB

50K100

RHCB-4005

Folientastatur

Key panel

HCB

99K50

RHCB-4006

Folientastatur

Key panel

HCB

100K200

RHCB-4007

Folientastatur

Key panel

HCB

200K100

RHCB-4008

Folientastatur

Key panel

HCB

200K500

RHCB-4009

Folientastatur

Key panel

HCB 0.5T-3

RHCB-4010

Folientastatur

Key panel

HCB 1T-3

RHCB-3001

LC-Display

LC-display

RHCB-8001

Batteriedeckel

Battery

cover

Andere Handbücher für HCB Series

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere KERN Skala Handbücher

KERN

KERN KFP_V20 Bedienungsanleitung

KERN

KERN MCB 300K100M Bedienungsanleitung

KERN

KERN 572 Bedienungsanleitung

KERN

KERN FTC Bedienungsanleitung

KERN

KERN TABP-A02-A Bedienungsanleitung

KERN

KERN MH5K5 Bedienungsanleitung

KERN

KERN CXB 3K0.2 Bedienungsanleitung

KERN

KERN EMB 6000-1 Bedienungsanleitung

KERN

KERN KERN MBB-M series Bedienungsanleitung

KERN

KERN CXB 3K0.2 Bedienungsanleitung

KERN

KERN MFB Bedienungsanleitung

KERN

KERN OEX 6K-3HM Bedienungsanleitung

KERN

KERN ITS 600K200M Bedienungsanleitung

KERN

KERN HDB 5K5N Bedienungsanleitung

KERN

KERN MGB 150K100 Bedienungsanleitung

KERN

KERN EOA Series Bedienungsanleitung

KERN

KERN KFP V30 Bedienungsanleitung

KERN

KERN PES Bedienungsanleitung

KERN

KERN PKS 200-3 Bedienungsanleitung

KERN

KERN FES 17K-4 Bedienungsanleitung

KERN

KERN FIS Bedienungsanleitung

KERN

KERN CGB Bedienungsanleitung

KERN

KERN KERN DE Bedienungsanleitung

KERN

KERN DS 3K0.01S Bedienungsanleitung

Beliebte Skala Handbücher anderer Marken

AWS

AWS ZEO-50 Bedienungsanleitung

Gima

Gima Glass Body Fat Analyzer Stücklistenhandbuch

Seca

Seca 374 Bedienungsanleitung

TEC

TEC TEC SL59 SERIES Bedienungsanleitung

Axis

Axis B/E Series Bedienungsanleitung

Alecto

Alecto ACW-40 Bedienungsanleitung

Rice Lake

Rice Lake MSI-4260 IS Bedienungsanleitung

IKA

IKA RCT basic safety control Bedienungsanleitung

ADE

ADE M20011 Bedienungsanleitung

Duronic

Duronic KS3000 Bedienungsanleitung

Digi

Digi SM-720 Bedienungsanleitung

Cardinal

Cardinal CS Series Bedienungsanleitung

Korona

Korona Kastella Bedienungsanleitung

A&D

A&D FC-50Ki Bedienungsanleitung

BDA

BDA CAMARGUE Bedienungsanleitung

Tanita

Tanita HD-357 Bedienungsanleitung

Leifheit

Leifheit 03173 Bedienungsanleitung

Lumme

Lumme LU-1340 Bedienungsanleitung