Kero-Sun KPT/R 2000 Bedienungsanleitung
CERAMIC HEATER
INSTRUCTION MANUAL
Model: KPT/R 2000
READ AND SAVE THIS INSTRUCTION
Please read these instructions carefully and keep for future reference.
In order to prevent the risks of a fire, an electrical shock, burns and other injuries, It is
imperative to observe basic safety measures when using electrical appliances.
IMPORTANT NOTES
1.The specified voltage must match the mains voltage. Use an adequate wire cross-
section.
2.The appliance air inlet and outlet openings must not be obstructed in any way!
3.Never move the heater during operating, always unplug heater when not in use.
4.Never use the appliance if the appliance or cord is damaged. The appliance may only
be opened up and repaired by authorized qualified personnel.
SAFETYINSTRUCTIONS
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE USING THE PRODUCT.
WARNING -to reduce the risk of fire, electrical shock or injury to persons or property:
1.Always operate the product from a power source of the same voltage, frequency and rating as
indicated on the product identification plate.
2.Remove the unit from its packaging and check to make sure it is in good condition before
using.
3.Do not let children play with parts of the packing (such as plastic bags)
.
4.Close supervision is necessary when the product is used by or near children or infirm persons.
Do not allow children to use it as a toy.
5.Do not operate any product with a damaged cord or plug, or after the product malfunctions, or
is dropped or appears damaged in any way. Return the complete product to the service depart-
ment for inspection, repair or replacement.
6.Before unplugging the power cord, be sure to turn the power off. When touching the unit, be
sure your hands are dry to prevent electrical shock.
7.Ensure the cord is fully extended before use and arrange it so that it is not in contact with any
part of the heater.
8.In use, some parts of the heater are hot. When moving, hold the heater only by the handle
provided.
9.Do not use the heater in areas such as garages where petrol, paint or other flammable
substances are used or stored.
10.Do not use near or point the heater to furniture, animals, curtains or other inflammable
objects. Keep combustible materials such as furniture, bedding and any other combustible
materials at least 1 metre from the front and sides, and from the rear of the heater.
11.Do not place the cord under carpet or cover with throw rugs or furniture.
12.Do not place the heater on bedding or on thick and long pile carpet where the openings may
be blocked.
2
13.To reduce the risk of electric shock, do not immerse or expose the product or flexible cord to rain,
moisture or any liquid other than those necessary for correct operation of the product.
14.This product should not be used in the immediate vicinity of water, such as bathtub, washbowls,
bathroom swimming pool etc. where the likelihood of immersion or splashing could occur.
15.Switch off and unplug from outlet when not in use, before assembling or disassembling parts and
before cleaning. Remove by grasping the plug - do not pull on the cord.
16.A common cause of overheating is deposits of dust and fluff entering the heater. Ensure these depos-
its are removed regularly by unplugging the heater, allowing it to cool and cleaning as described in the
Care, Cleaning and Storage section.
17.Be sure that no other high current appliances are plugged into the same circuit with your heater as an
overload can occur.
18.Avoid the use of an extension cord as the extension cord may overheat and cause a risk of fire.
19.Do not use the appliance for other than its intended use.
20.Do not use outdoors. FOR INDOOR USE ONLY.
21.Do not leave the appliance unattended when switched on.
22.Do not place objects on the product or allow objects to obstruct the inlet or outlet openings, or
operate in close proximity to walls or curtains, etc. Do not cover the unit when in operation.
23.Do not locate the heater immediately below a socket-outlet.
24.The use of attachments or accessories not recommended or sold by the product distributor may cause
personal or property hazards or injuries.
25.This product is intended for normal domestic/household use only.
26.Use this heater as described in this manual. Any other uses, not recommended by the manufacturer,
may cause fire, electric shock, or injury to persons and may void the warranty.
LOCATION
The appliance should be placed with a minimum distance 1m away from flammable objects (e.g.
curtains), walls or other structures!
3
SUPPLY CABLE
1.Use only an approved extension cord that is suitable for the appliance rating!
2.Do not lay the cord under a carpet.
3.Never pull the plug out of the socket at the cord!
4.Always disconnect the mains plug when the appliance is not in use. Attention! The appliance may
only be used for normal domestic use and not for industrial purpose.
BEFORE USE
1.Before use, remove all packaging and inspect the appliance for any damages. If there are
appears to be any damages, please take it back to place of purchase for an inspection or
replacement.
2.Ensure that all the accessories are included as per diagram above before you can continue
with the installation.
3.Ensure that the location of the heater installed is not directly under a power socket and that
a power socket is available to power the appliances for use.
4.Refer to the installation guide for further instruction.
USING THE HEATER
1.Carefully remove the heater from the plastic bag and the carton.
2.Place the heater on a firm level surface
3.Setting the main switch button to OFF position” ”, on the base of the unit, plug the
cord set into a 220-240v~AC electrical outlet.
4.Switch the power point to the on position then turn the main switch button on the
heater to the on ‘’1 position’’.
4
Turn the heater ON by pressing the ON/OFF button The unit will display the current Room
temperature. The unit is now in ‘’FAN” mode. This will conduct recirculation of the room air.
6.Upon pressing the ” “ , button the unit will be in the low heat mode.
7.Pressing the” “ button second time will put the heater into high heat mode.
8.Pressing the” “ button once more will return the unit to “FAN” mode.
9.To turn the heater OFF, press the ON/OFF button” “.
NOTE: To assist in maintaining the internal components, after pressing the “0” button the fan will
continue to operate for a period of 30-60 seconds before shutting down to standby.
OSCILLATING BUTTON
This heater has an oscillation function. To switch the function on, press
the button .To stop it, press the oscillation button again.
TIMER FUNCTION
5
This function will work in any mode. The timer function allows you to set the
length of operation from 1 to 8 hours. To set the timer, press the button. The
display screen will show 1 h, indicating the heater will operate for 1 hour before
shutting down to standby. To increase the operation time, continue to press the
button until the desired operation time is displayed. To cancel the timer feature
press the button until 0h is displayed. This returns the heater to continuous
running.
THERMOSTAT INSTRUCTIONS
1.Press the”+” or”-” button until the display shows “(A).”
2.To adjust temperature, press ‘’+” to increase the desired temperature and”-” to
decrease the desired temperature.
3.When the air temperature reaches 3 degrees above the set temperature, the heater will
cut off
4.When the air temperature drops 1 degree below the set temperature, the unit will come
back on.
5.Temperature range can be set from 15 degree to 32 degree.
Remote control
1.Install two ‘’AAA”(not included) batteries as shown in the right photo.
2.The remote control power button is labeled as such (left).
All the functions performed with the remote control work identically to the
manual controls.
Battery
The remote control use 2 x AAA battery. We recommend the use of Lithi-
um type battery for longer use.
Note: Please follow battery disposal instruction on battery packaging, or
contact your local councils for safely disposal of batteries.
SAFETYSYSTEM
In the event of abnormal overheating, a safety device shuts down the appliance
automatically. After a short cooling down phase, the appliance is ready for use again.
If you still notice the same defect as above mentioned, remove the plug from the
socket and consult your after-sales service department.
During use, do not touch or cover the air outlet. This may cause the unit to over heat,
and the safety device to operate.
The unit is also fitted with a safety tip over switch. Do not use on thick and long pile
carpets, as the heater may not work, due the tip over switch activation.
6
INCREASE
DECREASE
MAINTENANCE
1.Your appliance must be switch OFF via the main power supply and unplugged before
proceeding with any cleaning work.
2.Clean the housing with a lightly damp cloth, a vacuum cleaner or a dusting brush.
3.Never use flammable or abrasive cleaning agents such as benzene or spirit to clean the
appliance.
4.Never immerse the appliance in water!
5.Clean the air inlet and outlet regularly with a vacuum cleaner.
6.If the appliance is not used for an extended period it must be protected against excessive dust
and dirt. Please dismount the heater and store in a dry place away from sunlight and dirt.
WARRANTY&SERVICE
Your heater is warranty from workmanship and material defects, please refer to the warranty
statement card enclosed with your heater.
Your heater can only be serviceable by a qualified electrician. Do not attempt to repair your
heater as this will compromise our safety and the safety construction of your heater.
SPECIFICATIONS
7
8
.
: KPT/R2000
, ,
o .
,
.
1. .
, . 2.
. 3.
, .
() . 4.
, .
service (Siba ., 210 5386490, fax: 210
5313349) .
,
, :
, . :
,
:
1.
.
2. ,
.
3. (
).
4.
. .
5. , ,
. ,
service , .
6. ,
ON/OFF. ,
.
7.
.
8. , . ,
.
9. .
10
Inhaltsverzeichnis
Sprachen:
Andere Kero-Sun Heizung Handbücher
Kero-Sun
Kero-Sun LC-3000 Bedienungsanleitung
Kero-Sun
Kero-Sun KHFN-2021 Bedienungsanleitung
Kero-Sun
Kero-Sun Omni 105 Type N Bedienungsanleitung
Kero-Sun
Kero-Sun Moonlighter Bedienungsanleitung
Kero-Sun
Kero-Sun KBH-TG200IP7L Bedienungsanleitung
Kero-Sun
Kero-Sun LC-54 Bedienungsanleitung
Kero-Sun
Kero-Sun LC-56 Bedienungsanleitung
Kero-Sun
Kero-Sun KOR-09 Bedienungsanleitung
Kero-Sun
Kero-Sun KCF-70 Bedienungsanleitung
Kero-Sun
Kero-Sun LME-900M Bedienungsanleitung
Kero-Sun
Kero-Sun KTMC-15 Bedienungsanleitung
Kero-Sun
Kero-Sun Omni 105 Type M Bedienungsanleitung
Kero-Sun
Kero-Sun KSC-960A Bedienungsanleitung
Kero-Sun
Kero-Sun RS-220 Bedienungsanleitung
Kero-Sun
Kero-Sun LC-43 Bedienungsanleitung
Kero-Sun
Kero-Sun LC-300 Bedienungsanleitung
Kero-Sun
Kero-Sun Radiant Fan 111 Bedienungsanleitung
Kero-Sun
Kero-Sun LC-45 Bedienungsanleitung
Kero-Sun
Kero-Sun KRMC-15 Bedienungsanleitung
Kero-Sun
Kero-Sun Omni 105 Type L Bedienungsanleitung
Beliebte Heizung Handbücher anderer Marken
Empire Heating Systems
Empire Heating Systems WCC65 Bedienungsanleitung
Wetekom
Wetekom 92 86 43 Bedienungsanleitung
Desa
Desa SPC170-F Bedienungsanleitung
Watlow
Watlow Watrod Electric Tubular Heaters Bedienungsanleitung
Haverland
Haverland ECO-DRY GPS Series Stücklistenhandbuch
Stelpro
Stelpro ASILVC2060 Series Bedienungsanleitung