Keystone G220 Bedienungsanleitung
INSTRUCTIONS FOR Radio Control Operator
Single entry transmitter G220
Read the following instructions thoroughly before using the remote.
This transmitter must be adjusted so that the coding switches match the coding on your present operating
transmitters or receiver
FCC Regulations: This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Programming Remote Controller to the Opener
1. Remove the Transmitter Cover
Remove the access cover from the front of the transmitter by sliding the cover
away from the top of the transmitter (Figure A). This will expose the battery
and the dip switches. The code can now be changed using a small screwdriver.
2. Setting the codes
You may set your transmitter to any code you desire, but be sure the code you
set matches both your transmitter and receiver.
There are twelve (12) dip switches, each of which can be placed in two
different positions (+,-). DO NOT set all switches in the same position, such as
all +, all -, (Figure B). WARNING: No other adjustments should be made
inside the transmitter.
3. Terminal block for 9 dip switches receiver
For some receivers which only have 9 dip Switches, it will be necessary for
you to move the small black code terminal (Open the housing with cross-shaped screwdriver (Figure C) to
find terminal block (Figure D) ) to PINS in the middle and 9 .Therefore, the code selection of the 9 dip
switches receiver model and the dip switches on your transmitter 1 thru 9 should be set exactly the same.
The same as those on your receiver, switches 10, 11,12 on the transmitter should be set in the off position.
Open the housing with cross-shaped screwdriver
Figure C
Slider the cover for
battery replacement
Battery Type: 23A
Figure A
Figure B
For 9 dip switches receiver, you have to move the small black code terminal
to PINS in the middle and 9.
Figure D
Warning
To avoid possible serious injury or death from a garage door or moving gate:
-Keep all remote controls out of children’s reach at all times. Never allow children near batteries!
-Only activate door or gate when it is in clear view and is in proper working condition.
-Always completely monitor garage door and gate opener until completely opened or closed.
-Never allow anyone to cross area of opening and closing of moving garage door or gate.
-Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate this equipment.
Copyright@ Keystone/Heddolf Remotes 2015
ME-71-0001
Inhaltsverzeichnis
Andere Keystone Sender Handbücher
Beliebte Sender Handbücher anderer Marken
Dejero
Dejero EnGo 3x Bedienungsanleitung
Rosemount
Rosemount 4600 Bedienungsanleitung
Speaka Professional
Speaka Professional 2342740 Bedienungsanleitung
trubomat
trubomat GAB 1000 Bedienungsanleitung
Teledyne Analytical Instruments
Teledyne Analytical Instruments LXT-380 Bedienungsanleitung
Rondish
Rondish UT-11 Bedienungsanleitung
