5
Opening and closing the walker
Attaching the anti-fall blocks
To open, or raise the height, hold either side of the upper part of
the walker and pull upwards until you hear a click. The walker will
automatically lock open.
WARNING! NEVER adjust the height when your child is in the walker. DO
NOT place your child in until you have adjusted the height and ensured
the height adjustment block (R) is in its sideways locked position.
3
To close or lower the height, twist block (R) clockwise 90°, push it
upwards whilst at the same time pulling the block forward. Close
the walker or lower it to your desired height. When at the desired
height release the block and check the walker has locked in position.
WARNING! Never use the walker if the height adjustment block (R) is not in
its sideways locked position.
Ensure the walker is completely closed before attempting to
attach the anti-fall blocks.
Turn the walker upside down and push two of the anti-fall blocks
(F) into the xing points (M) at the front of the walker, ensuring the
three plastic stems on each block are correctly inserted into the
holes on the walker’s underside.
With the walker still upside down, push another two of the anti-fall
blocks (F) into the xing points (N) on each side of the walker.
Lastly, push the remaining two anti-fall blocks (F) into the xing
points (O) on each side of the walker.
IMPORTANT:Ifyoucannotpushtheanti-fallblocksintothexingpoints
check that they are the correct way round and try again. DO NOT force
them in - this may damage the stems.
4
5
6
7
8
