9
Control panel - Fig. 1 -
a. "ON" indicator light
b. Light ON-OFF button
c. Motor OFF button
d. e. f. Motor speed buttons
speed 1 (d.), speed 2 (e.), speed 3 (f.)
Use of the hood
It is advisable to switch on the extractor
hood a few minutes before starting cooking
andthentoleaveitrunningforapproximately
5minutesafterwardstoensurethatallodours
are extracted.
Maintenance
Before performing any maintenance
operation,isolatethehoodfromtheelectrical
supplybyswitchingoffattheconnectorand
removing the connector fuse.
Or if the appliance has been connected
through a plug and socket, then the plug
must be removed from the socket.
Metal grease filter
The metal grease filter lasts forever and
must be washed either by hand or in the
dishwasher(65°C)withsuitabledetergents.
The grease filters must be washed at least
once a month.
Let the filter dry without damaging it before
putting it back into place.
To remove the metal grease filter - Fig. 2:
1. Disconnect the hood from the electricity.
2. a - push toward the centre
b- pull the filters downwards.
Carryouttheabovestepsinreverseorderto
put the filters back after having washed
them.
Carbon filter
(“recirculation mode only”, see next pages)
The carbon filter cannot be washed nor
regenerated.
Thecarbonfilter shouldbereplacedevery6
months under normal use.
To fit the carbon filter - Fig. 3:
1. Disconnect the hood from the electricity.
2. Remove the metal filters.
3. Fitthecarbonfilterandfixittothebodyof
the hood with two supplied screws
4. Put the metal filter back into place.
To replace the carbon filter - Fig. 3:
1. Disconnect the hood from the electricity.
2. Remove the metal filters.
3. Remove the old carbon filter and replace
it.
4. Put the metal filter back into place.
Cleaning
To clean the outside of the hood use a cloth
moistenedwithdenaturedalcoholorneutral
liquid detergents. Never use products
containing abrasive.
Wipe brushed stainless steel in the same
directionasthebrushingtoavoidscratching.
Attention
Failure to observe the instructions for
cleaning the appliance and changing and
cleaning the filters may cause fires.
Therefore, we recommend observing these
instructions.
Replacing the lamp - Fig. 4
1. Disconnect the hood from the electricity.
2. Unscrew the lamp cover.
3. Replace the damaged lamp with a new
halogen lamp of 20Watt max.
4. Screwthelampcoveronitsproperplace.
Beforecallingforrepairservicebecausethe
hood fails to light up, make sure the lamps
are well inserted.
GB
