Kogan SMARTERHOME KASHPTFISCB Bedienungsanleitung

KOGAN SMARTERHOME™

INDOOR PAN AND TILT

SECURITY CAMERA

KASHPTFISCB

Safety & Warnings 3

Components 4

Overview 5

Installation 6

Connect to Kogan SmarterHome™ App 8

Google Home Control 14

Amazon Alexa 17

Operation 20

Troubleshooting 24

Notes 25

Ensure to read all instructions and warnings in this user guide prior to first use. Retain this

user guide for future reference.

•This camera is not intended for use by persons (including children) with reduced

physical, sensory or mental capabilities or lack of experience and knowledge, unless

they have been given supervision or instruction concerning the use of the camera by

a person responsible for their safety.

•This camera is intended for consumer use.

•Do not expose the USB power cord to water, heat, or direct sunlight.

•Do not allow the USB power cord to overhang where it can be pulled, damaged, or

pose a hazard.

•Do not attempt to disassemble or repair the camera yourself.

•If the camera is damaged, stop use immediately and contact help.Kogan.com for

assistance.

•Images used in this user guide are for reference only.

SAFETY & WARNINGS

ACamera (x1)

BPower adapter (x1)

CUSB power cord (x1)

DMounting bracket (x1)

ERound adhesive (x1)

FScrew (x2)

GUser guide (x1)

HPin (x1)

COMPONENTS

Front view

Back view

OVERVIEW

Status light

microSD card slot

Reset button

Microphone

Speaker

Power port

Camera lens

Plug one end of the USB power cord into the power port located on the bottom of the

camera. Plug the other end into the power adapter.

From here, there are two methods the camera can be installed:

•Using the mounting brackets

•Using the round adhesive

Mounting bracket installation method

1. Align the mounting bracket onto a clean stable surface. With a pen or pencil, mark

the location of the two holes of the mounting bracket onto the surface. Remove the

mounting bracket from the surface.

2.Using a drill (not supplied), form holes on the marked locations. Align the mounting

bracket with the drilled holes, then secure the mounting bracket with the provided

screws into the holes.

3.Align and twist the camera onto the grooves of the mounting bracket to secure it into

place.

INSTALLATION

Round adhesive installation method

1. Peel off the backing from the round adhesive and stick the adhesive onto a clean flat

surface.

2.Firmly stick the camera onto the round adhesive.

After installing the camera with either mounting bracket or round adhesive, insert the power

adapter into a socket and switch the socket on. The status light on the camera will start

blinking red and the camera will emit a tone.

Note:

The camera will remain on as long as it is connected to power. It cannot remotely be

turned on or off.

Install App

Download the “Kogan SmarterHome” app from the Play Store (Android) or App Store (iOS).

If you do not have a Kogan SmarterHome™ account, register or sign in with a verification

code sent by SMS.

To register:

1. Ta p to enter registration page.

2.The system automatically recognises your country/area. You can also select your

country code manually. Enter your email address and tap ‘Next.’

3.Alternatively, you can select ‘Register by mobile number’ and enter the verification

code sent to you by SMS.

4.Create a profile on the next page to define your location and room.

CONNECT TO SMARTERHOME™ APP

Set device in pairing mode

When the device is first turned on, it may automatically enter pairing mode (status light is

flashing).

If not automatically in pairing mode when powered on, you can manually set the device in

pairing mode by using the pin and pressing and holding the reset button for 5–10 seconds.

The camera will emit a tone, then wait until the camera emits a different second tone. The

status light will then be flashing.

Add device through network

5.Once registered, tap “+” in the upper right corner of the app’s home page to add a

new device through the network.

6.Select the product type from the list of options in the app (Home Security > Cameras).

7. Ensure that the device is in pairing mode, with the status light flashing, and tap

“Confirm light is rapidly flashing”.

8.Upon successfully confirming pairing mode, enter your Wi-Fi details. It is important

that your SmarterHome™ device and the app are connected to the same Wi-Fi

network during setup.

9.Tap ‘Continue’. The mobile device will display a QR code. Hold the camera 15–20cm

away from the mobile device to allow the camera lens to scan the QR code. Tap ‘I

Heard a Prompt’ when you hear an audio tone from the camera.

10. The device will commence the pairing process and connect to the app. Ensure your

Wi-Fi router, mobile phone, and the SmarterHome™ device are kept close until

connection is complete.

11. After successfully being added, you will have the option to rename the device and

assign it to a location. It will now be listed on the app’s home page. Tap the device

listing to enter its control page.

If you are unable to connect the camera after several repeated attempts using this method,

try connecting the camera using the AP mode connection steps outlined below.

Notes:

•The device and the app have to use the same Wi-Fi network.

•The device is only compatible with 2.4Ghz networks.

Inhaltsverzeichnis

Andere Kogan Sicherheitskamera Handbücher

Kogan

Kogan KAFXIDIPCNB Bedienungsanleitung

Kogan

Kogan SMARTERHOME KASMBMPT09A Bedienungsanleitung

Kogan

Kogan SMARTERHOME KASMSCPT12A Bedienungsanleitung

Kogan

Kogan SMARTERHOME KAFXIDIP3MA Bedienungsanleitung

Kogan

Kogan KAIPCHDSLVA Bedienungsanleitung

Kogan

Kogan SMARTERHOME KAODPNTSP2C Bedienungsanleitung

Kogan

Kogan SMARTERHOME KSOBCAMWGAB Bedienungsanleitung

Kogan

Kogan KAODPNTSP2A Bedienungsanleitung

Kogan

Kogan SMARTERHOME KAFXIDIPCWA Bedienungsanleitung

Beliebte Sicherheitskamera Handbücher anderer Marken

Okina USA

Okina USA SIR36-870VF650LP Bedienungsanleitung

Divio

Divio NDR155PA Bedienungsanleitung

Easy Access

Easy Access EasyGuard Bedienungsanleitung

Vivotek

Vivotek FD9389-EHV-v2 Bedienungsanleitung

TUYA

TUYA COSMO W2 Bedienungsanleitung

Eusso

Eusso UNC7500-IR Einrichtungshandbuch

urmet domus

urmet domus 1096/204 Bedienungsanleitung

VC VC20 series Bedienungsanleitung

Axis

Axis Q1614 Bedienungsanleitung

ieGeek

ieGeek DD201 Bedienungsanleitung

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Bedienungsanleitung

Vicon

Vicon V662-D-1 Betriebsanleitung

Grundig

Grundig GCH-K0274P Bedienungsanleitung

Lorex

Lorex VANTAGE LBC7032 Bedienungsanleitung

4xem

4xem WPT Bedienungsanleitung

Samsung

Samsung SCV-3082 Bedienungsanleitung

Vitek

Vitek VTC-C544 Bedienungsanleitung

Lumens

Lumens VC-A50PNW Bedienungsanleitung