Kohler 1341257-2 Bedienungsanleitung

Français, page “Français-1”

Español, pagina “Español-1”

1341257-2-C

Installation Instructions

Cleansing Seat

Tools and Materials

Before You Begin

WARNING: Risk of electric shock. Connect only to a circuit

protected by a Class A Ground-Fault Circuit-Interrupter

(GFCI)*, which protects against line-to-ground shock hazard.

Use 120 V, 15 A, 60 Hz service.

WARNING: Risk of electric shock. Do not immerse or ﬂush

the product with water.

CAUTION: Risk of property damage. A single extension cord

may be used provided that the cord type begins with “SJ”, is

12-gauge, grounded (12/3), not longer than 25 feet (7.6

meters), and plugged into a GFCI* electrical outlet. Promptly

replace any extension cord that exhibits any sign of damage.

IMPORTANT! Risk of product damage. Do not install this product

in a location exposed to excessive moisture where condensation

might form on the product surface. Provide adequate ventilation

when bathing to avoid damage to the electronic components due to

high humidity levels.

IMPORTANT! Risk of product or property damage. Pushing or

pulling on the water supply connection may cause water leakage.

IMPORTANT! Risk of product damage. Do not supply electrical

power to the unit until the plumbing installation work has been

completed, as it may cause the product to malfunction.

NOTE: The thermal protectors may trip during storage or

transportation in warm weather causing the unit to not operate.

Allow the unit to cool to room temperature before installation or

operation.

Plastic Wrap

1341257-2-C2 Kohler Co.

Before You Begin (cont.)

Kohler Co. 3 1341257-2-C

Observe all local plumbing, electrical, and building codes.

Only connect the seat to a cold water supply of drinking quality

with a pressure of 20 (139 kPa) - 80 psi (551 kPa).

*Outside North America, this device may be known as a Residual

Current Device (RCD).

Grounding Instructions

WARNING: Risk of electric shock. Connect only to a circuit

protected by a Class A Ground-Fault Circuit-Interrupter

(GFCI)*, which protects against line-to-ground shock hazard.

Use 120 V, 15 A, 60 Hz service.

*Outside North America, this device may be known as a Residual

Current Device (RCD).

This product should be grounded. In the event of an electrical

short circuit, grounding reduces the risk of electric shock by

providing an escape wire for the electric current. This product is

equipped with a cord having a grounding wire with a grounding

plug. The plug must be plugged into an outlet that is properly

installed and grounded.

DANGER: Risk of electric shock. Improper use of the

grounding plug can result in a risk of electric shock.

If repair or replacement of the cord or plug is necessary, do not

connect the grounding wire to either ﬂat blade terminal. The wire

with insulation having an outer surface that is green with or without

yellow stripes is the grounding wire.

Check with a qualiﬁed electrician or service personnel if the

grounding instructions are not completely understood, or if in doubt

whether the product is properly grounded.

Grounded

Outlet

Cover

Screw

Adapter

Grounding

Plug

Grounding

Screw Tab

Temporary ConnectionPreferred Connection

1341257-2-C4 Kohler Co.

Grounding Instructions (cont.)

NOTICE: Follow local codes when determining the connection type.

The temporary connection may not be permitted by local electrical

codes.

NOTICE: To avoid possible product malfunction, do not plug in the

seat until instructed.

Preferred Connection

Connect the grounding plug into a grounded outlet that has the

same conﬁguration as the plug.

Temporary Connection

NOTICE: Unless the outlet cover screw is grounded through the

house wiring, attaching the adapter grounding screw tab to the

cover screw will NOT ground the unit. If there is any doubt

whether the cover screw is grounded, have it checked by a qualiﬁed

electrician or service professional.

A temporary connection with a two-prong adapter may be used if

a properly grounded outlet is not available.

The temporary adapter should be used only until a properly

grounded outlet can be installed by a qualiﬁed electrician.

The green colored rigid ear, lug, and the like extending from the

adapter must be connect to a permanent ground such as a

properly grounded outlet box cover. Whenever the adapter is

used, it must be held in place by the screw.

Kohler Co. 5 1341257-2-C

CAUTION: Risk of property damage. A single extension cord

may be used provided that the cord type begins with “SJ”, is

12-gauge, grounded (12/3), not longer than 25 feet (7.6

meters), and plugged into a GFCI* electrical outlet. Promptly

replace any extension cord that exhibits any sign of damage.

1. Preparation

If applicable, remove the existing toilet seat.

Turn off the water supply to the toilet.

Flush the toilet to relieve any pressure from the water supply

hose.

Disconnect the water supply hose from the toilet ﬁll valve.

Determine the installation location for the remote control docking

station on the wall.

Remote Dock

36"

(914 mm)

38" (965 mm) Min

66" (1676 mm) Max

1341257-2-C6 Kohler Co.

2. Install the Remote Dock

Position the remote dock at the desired mounting location.

Conﬁrm that the remote dock is level.

Using a pencil, mark the two mounting-hole locations. Set the

remote dock aside.

For installation into a stud or other wood surface: Drill a 1/16″

hole at each of the marked locations.

For installation using wall anchors: Drill a 1/4″hole at each of

the marked locations. Install the provided wall anchors into the

holes.

Position the remote dock over the anchors or marks. Secure the

remote dock with the provided screws.

Open the battery compartment on the remote control. Install the

four provided AA batteries in the orientation shown.

Position the remote control on the remote dock.

1/16"

or 1/4"

Holes

Remote Dock

Remote Control

Batteries

Kohler Co. 7 1341257-2-C

3. Install an Electrical Outlet

WARNING: Risk of electric shock. Connect only to a circuit

protected by a Class A Ground-Fault Circuit-Interrupter

(GFCI)*, which protects against line-to-ground shock hazard.

Use 120 V, 15 A, 60 Hz service.

*Outside North America, this device may be known as a Residual

Current Device (RCD).

NOTICE: Do not use an extension cord with the product.

NOTE: Follow local codes when determining the electrical outlet

location.

Install a 120 V GFCI- or RCD-protected electrical outlet within 32″

(813 mm) of the toilet to accommodate the length of the power

cord.

Do not plug in the seat until instructed to do so.

Supply Stop

GFCI/RCD-Protected

Receptacle

1341257-2-C8 Kohler Co.

4. Install the Mounting Plate

Position the mounting plate over the mounting holes on the bowl.

Position the left and right inserts in the grooves on the mounting

plate.

For toilets with threaded mounting holes: Insert the bolts

through the inserts and thread into the mounting holes. Do not

fully tighten at this time.

For all other installations: Insert the bolts through the inserts and

into the mounting holes. Thread a nut onto each bolt. Do not

fully tighten at this time.

Left Insert

Nut

Right

Insert Mounting Plate

Kohler Co. 9 1341257-2-C

5. Install the Seat

Connect Supply Hose

IMPORTANT! Use only the supply hose included with the

cleansing seat. Using a different supply hose may damage the seat

components.

Connect the supply hose to the cleansing seat inlet. Do not

overtighten.

Fold the inlet ﬂat so that the supply hose exits the side of the

seat.

Position the Seat

Slide the seat onto the mounting plate until you feel it snap into

place.

Check the positioning of the seat. Adjust the position if needed.

Adjust the Seat

Remove the seat by pressing in the release button and sliding the

seat forward.

Reposition the mounting plate as needed.

Install the Seat

Securely tighten the mounting plate bolts and nuts.

Slide the seat onto the mounting plate until you feel it snap into

place.

Mounting Plate

Inlet

1341257-2-C10 Kohler Co.

Inhaltsverzeichnis

Sprachen:

Andere Kohler Badezimmerarmatur Handbücher

Kohler

Kohler K-792 Kurzanleitung

Kohler

Kohler C3-500/K-31331T-HC-0 Bedienungsanleitung

Kohler

Kohler K-8052 Montageanleitung

Kohler

Kohler K-706145 Montageanleitung

Kohler

Kohler K-1717 Montageanleitung

Kohler

Kohler K-102 Montageanleitung

Kohler

Kohler K-6236 Montageanleitung

Kohler

Kohler SLIM K-15227T Bedienungsanleitung

Kohler

Kohler TAUT 74013T-4 Bedienungsanleitung

Kohler

Kohler K-1643 Bedienungsanleitung

Kohler

Kohler PureWash E700 Bedienungsanleitung

Kohler

Kohler STRAYT 37337M Bedienungsanleitung

Kohler

Kohler K-28214-CP Bedienungsanleitung

Kohler

Kohler K-14406 Bedienungsanleitung

Kohler

Kohler K-5250 Bedienungsanleitung

Kohler

Kohler K-8298 Montageanleitung

Kohler

Kohler K-9694 Bedienungsanleitung

Kohler

Kohler Rada PA-TF Bedienungsanleitung

Kohler

Kohler K-T398 Bedienungsanleitung

Kohler

Kohler K-16281 Bedienungsanleitung

Kohler

Kohler K-1663-CP Bedienungsanleitung

Kohler

Kohler EXHALE 77361T-E Bedienungsanleitung

Kohler

Kohler K-702400 Bedienungsanleitung

Kohler

Kohler K-994 Bedienungsanleitung

Beliebte Badezimmerarmatur Handbücher anderer Marken

DURAVIT

DURAVIT C.1 C15240 0090 Handbuch

Sunshower

Sunshower PURE SOLO Bedienungsanleitung

Heatstore

Heatstore HSTRL500WTN Bedienungsanleitung

Delabie

Delabie Delabie Sporting 714700 Bedienungsanleitung

ESS

ESS Container TCL-11 Bedienungsanleitung

Mustee

Mustee 22C Bedienungsanleitung

VITRA

VITRA V-Flow Bedienungsanleitung

Malmet

Malmet B105BT Bedienungsanleitung

bathstore

bathstore Transition H1690MM Leitfaden

baliv

baliv DUK-80.30 T Bedienungsanleitung

baliv

baliv DU-5160 Bedienungsanleitung

BELLOSTA

BELLOSTA Edward 0800/M Bedienungsanleitung

Franke

Franke PRTR0006 Bedienungsanleitung

Gessi

Gessi RILIEVO 59011 Bedienungsanleitung

noken

noken VITAE 100188525-N299998810 Bedienungsanleitung

Allen + Roth

Allen + Roth 1142VA-30-201 Bedienungsanleitung

Britex

Britex HBDA Bedienungsanleitung

GRE

GRE DSALC32W Bedienungsanleitung