Kohler K-3492 Bedienungsanleitung

Installation Guide

Toilet

Mproduct numbers are for Mexico (i.e. K-12345M)

Los números de productos seguidos de Mcorresponden a México

(Ej. K-12345M)

Français, page “Français-1”

Español, página “Español-1”

K-3492

1035530-2-C

Tools and Materials

Thank You For Choosing Kohler Company

We appreciate your commitment to Kohler quality. Please take a few minutes to review this manual before

you start installation. If you encounter any installation or performance problems, please don’t hesitate to

Company.

Before You Begin

DANGER: Risk of electric shock. Disconnect power before servicing.

DANGER: Risk of electrical shock. For plug-in installations/wall-mounted electrical supply: Connect

only to a properly-grounded, grounding-type receptacle which is protected by a Ground-Fault

Circuit-Interrupter (GFCI). Do not remove the grounding pin or use a grounding adapter.

DANGER: Risk of electrical shock. For hardwire installations/through-ﬂoor electrical supply:

Connect only to a properly-grounded, dedicated 120 VAC, 15 A, 60 Hz circuit protected by a Class A

Ground-Fault Circuit-Interrupter (GFCI) or Earth-Leakage Circuit-Breaker (ELCB).

CAUTION: Risk of hazardous gases. If a new toilet is not installed immediately, temporarily place a

rag in the ﬂoor ﬂange opening.

NOTICE: Follow all local plumbing and electrical codes.

NOTICE: The Canadian Electric Code requires receptacles installed in bathrooms to be located at least 1

meter from a bath or shower if practical, but in no case less than 500 mm. If the installation is in Canada,

install this unit in accordance with the Canadian Electrical Code, Part 1.

Observe all local plumbing and building codes.

Carefully inspect the new toilet for damage.

Water and electrical supplies may installed through either the wall or the ﬂoor. For a more aesthetic

look, installation of the supplies through the ﬂoor is recommended.

There is a wiring schematic on the inside of the junction box cover.

Wax Seal Assorted

Screwdrivers

T-Bolts

Adjustable

Wrench

Tape

Measure Knife

Masking

Tape

Supply Stop

1035530-2-C 2 Kohler Co.

1. Roughing-In

DANGER: Risk of electric shock. Disconnect power before servicing.

DANGER: Risk of electrical shock. For plug-in installations/wall-mounted electrical supply: Connect

only to a properly-grounded, grounding-type receptacle which is protected by a Ground-Fault

Circuit-Interrupter (GFCI). Do not remove the grounding pin or use a grounding adapter.

DANGER: Risk of electrical shock. For hardwire installations/through-ﬂoor electrical supply:Connect

only to a properly-grounded, dedicated 120 VAC, 15 A, 60 Hz circuit protected by a Class A

Ground-Fault Circuit-Interrupter (GFCI) or Earth-Leakage Circuit-Breaker (ELCB).

NOTE: This product is designed for installation with the electrical and water supplies located through

either the wall or the ﬂoor.

24-5/8" (62.5 cm)

L of Outlet

16-1/2" (41.9 cm)

16-5/8"

(42.2 cm)

18-1/4"

(46.4 cm)

Wall

14-1/8"

(35.9 cm)

12"

(30.5 cm)

Front of Bowl

3/8" Compression

Supply

6-5/8"

(16.8 cm)

15-7/8"

(40.3 cm)

7-1/4"

(18.4 cm)

4-3/8"

(11.1 cm)

38-3/4"

(98.4 cm)

Hardwire

Electrical Supply

Both the electrical and water supplies

can be installed on either the wall or

the floor. Follow the information for

your particular installation.

3/4" (1.9 cm)

Kohler Co. 3 1035530-2-C

2. Install the Electrical Service and Water Supply

DANGER: Risk of electric shock. Disconnect power before servicing.

DANGER: Risk of electrical shock. For plug-in installations/wall-mounted electrical supply: Connect

only to a properly-grounded, grounding-type receptacle which is protected by a Ground-Fault

Circuit-Interrupter (GFCI). Do not remove the grounding pin or use a grounding adapter.

DANGER: Risk of electrical shock. For hardwire installations/through-ﬂoor electrical supply:

Connect only to a properly-grounded, dedicated 120 VAC, 15 A, 60 Hz circuit protected by a Class A

Ground-Fault Circuit-Interrupter (GFCI) or Earth-Leakage Circuit-Breaker (ELCB).

Install the Electrical Service

NOTE: This product is designed for installation with the electrical supply located through either the wall

or the ﬂoor. Both types are illustrated. Refer to the dimensional information for your chosen installation.

Follow the dimensional information exactly when installing a hardwire electrical supply.

Install the electrical supply for your chosen installation.

Install the Water Supply

NOTE: This product is designed for installation with the water supply located through either the wall or

the ﬂoor. Both types are illustrated. Refer to the dimensional information for your chosen installation.

NOTE: A ﬂoor mounted water supply stop may be no higher than 2-3/4″(7 cm) from the ﬂoor.

Install the water supply. If you are installing a ﬂoor supply, study the dimensional information

illustrated carefully.

Maximum incoming water pressure, 552 kPa (80 psi).

Minimum incoming water pressure, 138 kPa (20 psi).

7-1/4" (18.4 cm)

GFCI-

Protected

Receptacle

The wall locations of the

electrical and water supply

are interchangeable.

T-Bolts

(15.2 cm)

12" (30.5 cm)

2-3/4" (7 cm)

3/4" (1.9 cm)

2-3/4" (7 cm)

Maximum Height

Supply Stop

Hardwire

Electrical Supply

Floor Flange

1035530-2-C 4 Kohler Co.

3. Install the T-Bolts

NOTE: T-bolts are not included.

Install two 5/16″diameter T-bolts into the ﬂoor ﬂange.

4. Install the Wax Ring

Place the wax ring in the putty ring located on the tank.

T-Bolts

Floor

Flange

Kohler Co. 5 1035530-2-C

5. Position the Tank

CAUTION: Risk of product damage. Do not push down on any part of the tank assembly other than

the cylinder. Damage may occur.

CAUTION: Risk of product damage. Do not rock or lift the tank after placement. The seal created by

the wax ring may be broken, resulting in leaking.

Remove the outlet gasket.

Mark the centerline on the ﬂoor.

Align the tank over the ﬂoor ﬂange.

Lower the tank onto the ﬂoor ﬂange. The T-bolts should align with the mounting slots in the base of

the tank.

Carefully align the tank on the centerline.

Position the tank on the T-bolts.

Press down on the cylinder where the gasket was mounted. Do not press anywhere else on the tank

assembly.

Replace the outlet gasket.

Position the loose end of the reﬁll tube in the outlet ring.

Outlet Ring

Remove outlet

gasket.

Centerlines

T-Bolts

Tank

Floor Flange

Replace

outlet

gasket.

Press here on cylinder.

Refill Tube

1035530-2-C 6 Kohler Co.

6. Secure the Tank

CAUTION: Risk of product damage. Do not overtighten the mounting nuts. Do not shorten the

T-bolts.

Place a washer on each T-bolt.

Thread a nut onto each T-bolt.

Hand tighten the nuts.

7. Connect the Water

IMPORTANT! If this installation replaces an existing toilet, a hose other than the one shipped with the

water supply may be used. Use a stainless steel, burst-resistant hose.

NOTE: This installation is conﬁgured to accept a ﬂoor water supply. A wall supply is also acceptable.

Connect the water.

Open the shut-off valve.

Nut

Washer

T-Bolt

Base of

Tank Unit

Flexible Hose

Floor supply shown.

Kohler Co. 7 1035530-2-C

8. Check the Waterline

CAUTION: Risk of property damage. Before use, return the inlet valve lever to the unlocked (closed)

position to avoid overﬂow.

NOTE: The waterline is marked inside the tank by a notch and a label.

Turn on the water supply.

Move the lever on the motorized inlet valve into the locked (open) position.

Check the water level in the tank. If the water level is at the marked waterline, return the lever to

the unlocked (closed) position. If adjustments are needed, proceed to the next step.

To adjust the water level, use a ﬂat-blade screwdriver to gently turn the adjustment rod on the inlet

valve. Turning the rod counterclockwise will lower and clockwise will raise the water level.

Return the lever to the unlocked (closed) position.

Locked

Unlocked

Waterline

Adjust waterline.

1035530-2-C 8 Kohler Co.

9. Install the Collar

Place the wiring harness plug, level switch wire, and reﬁll tube on the ﬂoor so they extend out the

rear access opening.

Tape them to the ﬂoor so they will not be pinched or damaged.

Install the collar onto the tank.

Clip the spray shield into place over the ﬁll valve.

Tape

Level

Switch

Wire

Electrical

Plug

Centerline

Refill Tube

Wiring Harness Plug

Spray Shield

Collar

Tank

Kohler Co. 9 1035530-2-C

10. Install the Vitreous Shell

WARNING: Risk of personal injury. The vitreous shell weighs 80 lbs (36 kg). Use proper lifting

technique when handling the vitreous shell.

CAUTION: Risk of product damage. Do not set the shell down hard. Gently lift and move the shell if

it is not placed correctly. If handled harshly, the shell may chip or break.

Carefully pick up the vitreous shell and place it over the tank.

Make sure the trapway seats fully in the outlet gasket. If the vitreous shell does not sit evenly on

the ﬂoor, the trapway is not properly seated.

Make all adjustments gently until the trapway is properly seated.

Vitreous

Tank

Collar

1035530-2-C 10 Kohler Co.

Andere Handbücher für K-3492

Inhaltsverzeichnis

Sprachen:

Andere Kohler Toilette Handbücher

Kohler

Kohler BRAZN K-EX22381T-SL Bedienungsanleitung

Kohler

Kohler K-5401TW-2-0 Montageanleitung

Kohler

Kohler K-18751 Bedienungsanleitung

Kohler

Kohler Wellworth K-4468 Bedienungsanleitung

Kohler

Kohler K-76395 Bedienungsanleitung

Kohler

Kohler K-3589 Montageanleitung

Kohler

Kohler K-3575 Montageanleitung

Kohler

Kohler K-77797T-0 Bedienungsanleitung

Kohler

Kohler S-TRAP K-23188T-ITHC Bedienungsanleitung

Kohler

Kohler KARAT K-2462X Montageanleitung

Kohler

Kohler K-5401X Montageanleitung

Kohler

Kohler ODEON K-8752K-W Bedienungsanleitung

Kohler

Kohler K-5401TW-2-0 Bedienungsanleitung

Kohler

Kohler K-3506 Montageanleitung

Kohler

Kohler EIR Montageanleitung

Kohler

Kohler ESCALE K-32771T-NS Bedienungsanleitung

Kohler

Kohler K-11489X Montageanleitung

Kohler

Kohler KARING 2.0 K-77780T-0 Bedienungsanleitung

Kohler

Kohler K-8297KR-HC-0 Bedienungsanleitung

Kohler

Kohler Novita BD-N450US Montageanleitung

Kohler

Kohler Heated French Curve K-4649 Montageanleitung

Kohler

Kohler C3-129 Montageanleitung

Kohler

Kohler K-8298 Bedienungsanleitung

Kohler

Kohler K-29918T-NSHC Bedienungsanleitung

Beliebte Toilette Handbücher anderer Marken

Toto

Toto Washlet TCF4911 Series Bedienungsanleitung

Grohe

Grohe Sensia ARENA Bedienungsanleitung

Geberit

Geberit AQUACLEAN MERA CLASSIC Bedienungsanleitung

Better Bathrooms

Better Bathrooms BUN/BeBa 27555/78725 Bedienungsanleitung

American Standard

American Standard CONCEPT Cube TF-2704 Bedienungsanleitung

BIOLAN

BIOLAN ECO Stücklistenhandbuch

Thetford

Thetford C260 Series Bedienungsanleitung

KELISS

KELISS T162A Series Bedienungsanleitung

BIOLAN

BIOLAN GARDEN TOILET Stücklistenhandbuch

washloo

washloo Prestige Bedienungsanleitung

JABSCO

JABSCO 37010 Series Bedienungsanleitung

Olympia

Olympia EPOQUE 69209 Bedienungsanleitung

DENCK

DENCK PURE-D Bedienungsanleitung

Silent Venus

Silent Venus SVP600 Wartungs- und Serviceanleitung

InBe

InBe IB/04.06050 Bedienungsanleitung

Swiss Madison

Swiss Madison Carré SM-1T264 Bedienungsanleitung

agape

agape PEAR 2 Bedienungsanleitung

Roca

Roca DAMA SENSO COMPACT Bedienungsanleitung