Kohler K-6918 Montageanleitung

Installation and Care Guide

Wall-Hung Toilet

Français, page “Français-1”

Español, página “Español-1”

K-6918

1287824-2-A

Tools and Materials

Before You Begin

NOTE: This product is designed for installation with the water

supplies located through the wall.

Observe all local plumbing and building codes.

Carefully inspect the new bowl for damage.

NOTE: Lifting and handling the bowl is more efficient with two

people.

Consult the online users guide at us.kohler.com for more

information.

For service parts information, visit kohler.com/serviceparts.

• Rug or Protective Material

• Silicone Plumbers Grease

• Level or Straight Edge

Plus:

File

3/4"

1287824-2-A 2 Kohler Co.

1. Mark the Pipes - Bowl Side

IMPORTANT! If silicone plumbers grease is not applied to the

gaskets, they will bind during ﬁtting, which will result in the pipes

cut to incorrect lengths.

NOTE: This step is easier with the bowl upside down.

Install the gasket on the ribbed end of the inlet pipe.

NOTE: The outlet pipe gasket comes positioned on the thin portion

of the outlet pipe. Remove the gasket and reinstall it as shown.

Install the outlet pipe gasket on the ﬂared end of the outlet pipe.

Apply silicone plumbers grease to the outlet pipe gasket.

Firmly ﬁt the outlet pipe and gasket over the bowl outlet,

pushing until it contacts the bowl.

Position a level or other straight edge device across the back of

the bowl.

Mark the outlet pipe at the back edge of the bowl using the level

as a guide.

Straight Edge

or Level

Gasket

Inlet Pipe

Outlet

Pipe

Gasket

Silicone

Plumbers

Grease

Outlet Pipe

Inlet Pipe

Silicone

Plumbers

Grease

Kohler Co. 3 1287824-2-A

Mark the Pipes - Bowl Side (cont.)

Apply silicone plumbers grease to the outside of the inlet pipe

gasket.

Firmly insert the gasket end of the inlet pipe into the water inlet,

pushing until it contacts the bowl.

Position a level or other straight edge device across the back of

the bowl.

Mark the inlet pipe at the back edge of the bowl using the level

as a guide.

Remove the inlet and outlet pipes.

1287824-2-A 4 Kohler Co.

2. Mark the Pipes - Wall Side

Remove and discard the plaster guards from the inlet and outlet

holes.

Apply silicone plumbers grease to the gasket in the opening of

the inlet and outlet holes.

Firmly insert the inlet pipe completely into the inlet hole.

NOTE: If the ﬁnished wall aligns with any portion of the gasket

section of the inlet pipe, no mark or cut is required.

Use a level or other straight edge to mark the inlet pipe even

with the front edge of the ﬁnished wall.

Firmly insert the outlet pipe completely into the outlet hole.

NOTE: If the ﬁnished wall aligns with the wide part of the outlet

pipe, no mark or cut is required.

Use a level or other straight edge to mark the outlet pipe even

with the front edge of the ﬁnished wall.

Remove the inlet and outlet pipes.

Finished Wall

Inlet Hole

Plaster

Guard

Outlet Hole

Outlet Pipe

Inlet Pipe

Kohler Co. 5 1287824-2-A

3. Cut the Pipes

Measure the distance between the two marks on the inlet pipe to

determine ″X.″

Measure and mark ″X″from the end opposite the gasket on the

inlet pipe.

Cut the inlet pipe at this location.

Measure the distance between the two marks on the outlet pipe

to determine ″Y.″

Measure and mark ″Y″from the end opposite the gasket on the

outlet pipe.

Cut the outlet pipe at this location.

Use a ﬁle to remove all rough areas on the cut end of each pipe.

Outlet Pipe

Inlet Pipe

1287824-2-A 6 Kohler Co.

4. Install the Pipes

NOTE: Be sure that the gaskets on the inlet and outlet holes are still

well lubricated with silicone plumbers grease. Apply more grease if

necessary.

Insert the inlet pipe into the inlet hole

Insert the outlet pipe into the outlet hole

Inlet Hole

Inlet Pipe

Outlet Pipe

Outlet Hole

Apply silicone

plumbers

grease.

Kohler Co. 7 1287824-2-A

5. Adjust the Carriage Bolts

Adjust the threaded rods until they each extend 3″(76 mm) from

the ﬁnished wall.

Place a washer onto each threaded rod.

Thread one of the jam nuts over each threaded rod and tighten

down to lock the rods in position.

Threaded Rod

(76 mm)

1287824-2-A 8 Kohler Co.

6. Install the Wall Kit

Thread the notched pegs onto the threaded rods, leaving a 3/8″

(10 mm) gap on the rods.

Position the pegs with the notches facing down.

Insert the hex shaft into the receiver, then position the assembly

into the underside of the bowl and align with the holes in the

back of the bowl.

Install the retainer into the holes on the back of the toilet bowl,

and snap into the end of the receiver.

3/8" (10 mm) Hex Shaft

Retainer

Kohler Co. 9 1287824-2-A

7. Install the Bowl

NOTE: This step is easier when performed by two people.

NOTE: Be sure all gaskets are well lubricated with silicone

plumbers grease. Reapply grease if necessary.

Conﬁrm the gasket on the inside of the inlet elbow has correctly

engaged with the inlet pipe.

Conﬁrm the gasket on the inside of the outlet elbow has correctly

engaged with the outlet pipe.

Carefully lift the bowl up and align the threaded rods and pipes

with the corresponding holes.

Make sure the pegs are oriented with the notches facing down.

Slide the bowl onto the threaded rods, inlet pipe and outlet pipe.

Make sure the bowl fully engages the gaskets on the inlet and

outlet pipes.

Slide the bowl back until it makes contact with the wall.

From the underside of the bowl, attach the tool to the hex shaft

and turn counterclockwise to secure the bowl.

Notch

1287824-2-A 10 Kohler Co.

Inhaltsverzeichnis

Sprachen:

Andere Kohler Toilette Handbücher

Kohler

Kohler K-3322 Montageanleitung

Kohler

Kohler K-3654 Montageanleitung

Kohler

Kohler CABERNET WATER-GUARD K-3401 Bedienungsanleitung

Kohler

Kohler K-3900X Montageanleitung

Kohler

Kohler S-TRAP K-3869T Bedienungsanleitung

Kohler

Kohler K-23628H-0 Montageanleitung

Kohler

Kohler SAN SOUCI K-21865T-HC Bedienungsanleitung

Kohler

Kohler Sterling Windham 402015 Bedienungsanleitung

Kohler

Kohler K-3384 Montageanleitung

Kohler

Kohler K-3466 Montageanleitung

Kohler

Kohler REVIVAL Bedienungsanleitung

Kohler

Kohler K-3519 Montageanleitung

Kohler

Kohler K-3589 Montageanleitung

Kohler

Kohler EIR K-77798T-0 Bedienungsanleitung

Kohler

Kohler K-29918T-NSHC Bedienungsanleitung

Kohler

Kohler Englefield EVORA Back-to-Wall Bedienungsanleitung

Kohler

Kohler K-3357 Bedienungsanleitung

Kohler

Kohler K-3598 Montageanleitung

Kohler

Kohler MODERN LIFE K-77739T-TFSL Bedienungsanleitung

Kohler

Kohler PANACHE K-18182T-2 Bedienungsanleitung

Kohler

Kohler Escale K-25091T-S Bedienungsanleitung

Kohler

Kohler VEIL K-5401T Bedienungsanleitung

Kohler

Kohler WELLWORTH LITE K-3414-PB Bedienungsanleitung

Kohler

Kohler K-31636-0 Bedienungsanleitung

Beliebte Toilette Handbücher anderer Marken

Toto

Toto Washlet TCF4911 Series Bedienungsanleitung

Grohe

Grohe Sensia ARENA Bedienungsanleitung

Geberit

Geberit AQUACLEAN MERA CLASSIC Bedienungsanleitung

Better Bathrooms

Better Bathrooms BUN/BeBa 27555/78725 Bedienungsanleitung

American Standard

American Standard CONCEPT Cube TF-2704 Bedienungsanleitung

BIOLAN

BIOLAN ECO Stücklistenhandbuch

Thetford

Thetford C260 Series Bedienungsanleitung

KELISS

KELISS T162A Series Bedienungsanleitung

BIOLAN

BIOLAN GARDEN TOILET Stücklistenhandbuch

washloo

washloo Prestige Bedienungsanleitung

JABSCO

JABSCO 37010 Series Bedienungsanleitung

Olympia

Olympia EPOQUE 69209 Bedienungsanleitung

DENCK

DENCK PURE-D Bedienungsanleitung

Silent Venus

Silent Venus SVP600 Wartungs- und Serviceanleitung

InBe

InBe IB/04.06050 Bedienungsanleitung

Swiss Madison

Swiss Madison Carré SM-1T264 Bedienungsanleitung

agape

agape PEAR 2 Bedienungsanleitung

Roca

Roca DAMA SENSO COMPACT Bedienungsanleitung