La Crosse Technology 433 MHz RADIO CONTROLLED PROJECTIONALARM... Bedienungsanleitung

433 MHz RADIO CONTROLLED PROJECTION

ALARM CLOCK

Instruction manual

INTRODUCTION:

Congratulations on purchasing this innovative 433MHz Projection alarm clock which

also displays indoor temperature and humidity. To enjoy the full benefits of this

innovative product, please read this operating manual.

Adapter

socket

Stand

Battery

com

artment

LCD

Dis

Function

FEATURES

•Radio-controlled time and date

•Projection of time

•EL backlight

•Displays time with seconds, indoor temperature & humidity

•Time alarm wit snoozeh

•Table-standing

TO INSTALL AND REPLACE BATTERIES IN THE PROJECTION ALARM

The Projection Alarm uses 2 x AA, IEC LR6, 1.5V batteries. To install and replace the

batteries, please follow the steps below: 1. Insert finger or other solid object in

the space at the bottom center of the

battery compartment and lift up to

remove the cover.

2. Insert batteries observing the correct

polarity (see marking).

3. Replace compartment cover.

In addition or instead of inserting batteries, the AC adapter can be used:

1. Connect the power adapter to a wall socket

2. Insert the adapter into the jack at the bottom of the clock

3. The Projection clock will now start receiving the DCF time signal. After

approximate 3 to 5 minutes, the DCF time will be displayed (see Notes at below

clause).

Important!

Use only the adapter provided with the projection clock and make sure that your

household voltage is appropriate to the working voltage of the transformer. Otherwise

your projection clock may be damaged.

BATTERIES POWERED WITH THE USE OF AC/DC ADAPTER

If the Projection clock is first powered by batteries and the power adapter is

subsequently used for extended period of time, the main power source of the Projection

clock will switch to AC/DC power. The batteries will then act as a backup power source

in case of power failure.

Notes:

•After the projection clock is powered, there will be a beep sound and the LCD

(Liquid Crystal Display) will activate.

•The indoor temperature/humidity and the remote temperature will be displayed.

Also, the time will be displayed as 0:00.

•The DCF time reception will automatically be initiated, and a tower icon will

appear (no tower icon will appear if the time reception is too weak to be detected,

and the time display will start from 0:00).

•When DCF time has not been received, user may use the MODE/MIN key to

manually enter a time and date initially. The clock will automatically attempt to

receive the DCF time at each full hour. When this is successful, the received time

will override the manually set time. The date is also updated with the received

time. (Please refer also to notes on “DCF-77 RADIO CONTROLLED TIME” and

“Manual time setting”).

TO RESET THE PROJECTION CLOCK

To reset the Projection clock to the factory default setting or in case of a malfunction,

please remove all batteries from the unit and unplug the AC/DC adapter from any

power source. Wait at least for 3 minutes before powering up the Projection clock

again.

BATTERY CHANGE:

It is recommended to replace the batteries in all units on an annual basis to ensure

optimum accuracy of these units.

Please participate in the preservation of the environment. Return

used batteries to an authorized depot.

PROJECTION OF TIME

Note:

The projection is a red light, not harmful under normal usage, yet care should be taken

to avoid looking directly into the light.

1. When plugged into an AC outlet, the projection alarm can continuously project

the time

2. When operating on batteries alone, the projection alarm will only project when

the SNOOZE button is pressed or the alarm is sounding.

3. The projection will auto-focus for display from about 1.7 to 2.0 meter away. A

dark surrounding will be necessary to clearly see the projection.

The direction of the display can also be rotated 360°in 90°increments by pressing the

Projection Direction button. The projector case can be rotated 180°to further help

orient the projected display.

TOGGLE BETWEEN THE DISPLAY OF INDOOR TEMPERATURE/

HUMIDITY, PRESET ALARM TIME AND CALENDAR

By pressing shortly the MODE/MIN key, user may toggle between the following displays:

1. Indoor temperature and humidity;

2. Preset alarm time;

3. Day and weekday;

4. Month and day

DCF-77 RADIO CONTROLLED TIME

The time base for the radio controlled time is a Cesium Atomic Clock operated by the

Physikalisch Technische Bundesanstalt Braunschweig which has a time deviation of

less than one second in one million years. The time is coded and transmitted from

Mainflingen near Frankfurt via frequency signal DCF-77 (77.5 kHz) and has a

transmitting range of approximately 1,500 km. Your radio-controlled Projection clock

receives this signal and converts it to show the precise time in summer or wintertime.

The quality of the reception depends greatly on the geographic location. In normal

cases, there should be no reception problems within a 1500km radius of Frankfurt.

Once the outdoor reception test period is completed, the DCF tower icon in the clock

display will start flashing in the upper center. This indicates that the clock has detected

that there is a radio signal present and is trying to receive it. When the time code is

received, the DCF tower becomes permanently lit and the time will be displayed.

If the tower icon flashes, but does not set the time or the DCF tower does not appear at

all, then please take note of the following:

•Recommended distance to any interfering sources like computer monitors or TV

sets is a minimum of 1.5 - 2 meters.

•Within ferro-concrete rooms (basements, superstructures), the received signal is

naturally weakened. In extreme cases, please place the unit close to a window

and/ or point its front or back towards the Frankfurt transmitter.

During nighttime, the atmospheric disturbances are usually less severe and reception is

possible in most cases. A single daily reception is adequate to keep the accuracy

deviation below 1 second.

FUNCTION KEYS

There are three function buttons located on the front of the projection alarm and one on

the top. The function buttons are: AL/HOUR button MODE/MIN button, Projection

direction button, and SNOOZE button.

SNOOZE button

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere La Crosse Technology Wecker Handbücher

La Crosse Technology

La Crosse Technology T83721 Abmessungen

La Crosse Technology

La Crosse Technology W88723 Bedienungsanleitung

La Crosse Technology

La Crosse Technology RADIO CONTROLLED PROJECTION ALARM CLOCK Bedienungsanleitung

La Crosse Technology

La Crosse Technology 617-3314 Bedienungsanleitung

La Crosse Technology

La Crosse Technology 617-1485Bv2 Bedienungsanleitung

La Crosse Technology

La Crosse Technology WT-5130ER Bedienungsanleitung

La Crosse Technology

La Crosse Technology K85236 Abmessungen

La Crosse Technology

La Crosse Technology WT-5130 Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS8010 Bedienungsanleitung

La Crosse Technology

La Crosse Technology WT-2160U Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS-8256U Bedienungsanleitung

La Crosse Technology

La Crosse Technology 617-148v2 Bedienungsanleitung

La Crosse Technology

La Crosse Technology WT-2100 Bedienungsanleitung

La Crosse Technology

La Crosse Technology 616A-56647 Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS-8017U Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS-9412U Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS-8056U Bedienungsanleitung

La Crosse Technology

La Crosse Technology C85135 Abmessungen

La Crosse Technology

La Crosse Technology 616-1950 Bedienungsanleitung

La Crosse Technology

La Crosse Technology 616-146 Bedienungsanleitung

La Crosse Technology

La Crosse Technology C75785-AU Bedienungsanleitung

La Crosse Technology

La Crosse Technology 617-106 Abmessungen

La Crosse Technology

La Crosse Technology WW85760 Abmessungen

La Crosse Technology

La Crosse Technology 317-1909 Abmessungen

Beliebte Wecker Handbücher anderer Marken

Steren

Steren CLK-210 Bedienungsanleitung

COP-USA

COP-USA ALCDVR32-SL Bedienungsanleitung

Philips

Philips HF3505/70 Technisches Handbuch

Casio

Casio PQ-70 Bedienungsanleitung

iHome

iHome IA63 Bedienungsanleitung

Coopers

Coopers 9765 Bedienungsanleitung

ANJANK

ANJANK AC-190 Leitfaden

TFA

TFA 98.1075 Bedienungsanleitung

Sharper Image

Sharper Image 204050 Bedienungsanleitung

Lumie

Lumie Zest Bedienungsanleitung

Dexford

Dexford RCT200 Bedienungsanleitung

Philips

Philips AJL303/37B Bedienungsanleitung

RST

RST Q754 Bedienungsanleitung

iHome

iHome iKT50 Bedienungsanleitung

Sony

Sony dash HID-B7 Bedienungsanleitung

SVINZ

SVINZ SCC009 Bedienungsanleitung

Clas Ohlson

Clas Ohlson 918863 Bedienungsanleitung

IKEA

IKEA FNURRA Bedienungsanleitung