Larson Electronics LEDLB-4-IR Bedienungsanleitung

QUICK DISCONNECT

DEUTSCH CONNECTOR

LEDLB-4-IR

IR LED Light Emitter

12 watts - 4 LEDs - 90'L X 70'W Beam - 9-42 Volts DC

Instruction Manual

IMPORTANT

READ CAREFULLY BEFORE INSTALLING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTURE

REFERENCE. THE LEDLB-4-IR MUST BE WIRED IN ACCORDANCE WITH NATIONAL ELECTRICAL CODE AND

ALL APPLICABLE LOCAL CODES. PROPER GROUNDING IS REQUIRED FOR SAFETY.

WE STRONGLY ENCOURAGE ONLY A LICENSED ELECTRICIAN INSTALL, OPERATE AND MAINTAIN THIS

PRODUCT. IF YOU ARE NOT QUALIFIED OR UNFAMILIAR WITH ANY ASPECT OF THIS INSTRUCTION SHEET,

CONSULT AN ELECTRICIAN. THERE ARE NO SERVICEABLE PARTS INSIDE.

WARNING: MAKE SURE POWER IS TURNED OFF BEFORE STARTING THE

INSTALLATION OR PERFORMING ANY MAINTENANCE.

RISK OF FIRE/ELECTRIC SHOCK –DISCONNECT POWER AT BREAKER BEFORE INSTALLING OR SERVICING.

RISK OF PERSONAL INJURY –FIXTURE MAY BECOME UNSTABLE OR DAMAGED IF NOTINSTALLED PROPERLY.

RISK OF BURN –ALLOW FIXTURE TO COOL BEFORE SERVICING.

INFRARED LIGHT MAY CAUSE DAMAGE TO EYES IN VERY INTENSE CONCENTRATIONS.

RISK OF EYE DAMAGE AT SHORT DISTANCES. TURN LIGHT SOURCE OFF BEFORE SERVICING.

The Larson Electronics LEDLB-4-IR LED Light Bar offers high infrared light output and a compact profile combined with

versatile mounting and power options. This IP67 rated IR LED light bar is waterproof to one meter and produces 750

lumens of infrared light while drawing only 12 watts of power @1 amp from a 12 volt electrical system. This light can run

on any voltage from 9 to 42 volts and produces an infrared light beam that can only be seen through the use of night

vision goggles. 750Nm, 850Nm or 940Nm versions. This light provides a compact and powerful infrared lighting solution

that is ideal for use in commercial and industrial security applications as well as military environments.

Mounting

This fixture offers aluminum mounting blocks which slide within the

aluminum housing to allow users to adjust their positioning to match

existing or user drilled mounting holes. Each aluminum mounting

block has an integrated rubber bushing to absorb vibrations and

shocks. To secure the lights in place, simply slide the mounting bolts

through the aluminum mounting block and rubber isolator, through to

the mounting surface, then secure the bolt with a locking nut on the

opposite side of the mounting surface. This mounting system

enables mounting to flat or round surfaces and allows for minimal 7

degrees of flexibility of angle placement of the light. In this LED

emitter light bar model, an additional mounting option is provided.

The adjustable, shock insulated mounts are attached to a simple,

inverted u-bracket type mount. The LED light bar can then be

mounted via a single 3/8 bolt through the center of the bracket. To

adjust, loosen bolts on either side just enough to adjust light head.

Tighten bolts once desired position is achieved.

Larson Electronics, LLC Phone: (877) 348-9680 Fax: (903) 498-3364 www.larsonelectronics.com 1of 2

POWER

Connect power to power supply outputting low voltage between 9-42 volts DC.

This variable voltage allows greater versatility without affecting light output.

Ensure deutsch connectors are properly connected.

DETACHABLE CORDS

•Cordis attached via a weatherproof 2-pinDeutsch connector.

•The cord is detachable by depressing the tab on the top of the connectors.Thisenables the operator to remove

and store the light while leaving the cordconnected to the power source.

•Additionalor replacement cords canbe ordered from our website. Contact us or visit LarsonElectronics.com for more

information.

Larson Electronics, LLC Phone: (877) 348-9680 Fax: (903) 498-3364 www.larsonelectronics.com 2of 2

LEDLB-4-IR

MAINTENANCE

Caution: To avoid personal injury, disconnect power to the light and allow the unit to cool down before

performing maintenance.

Warning: No user serviceable parts inside of fixture. Risk of electric shock. Removal of the lens will void

the warranty.

1. Perform visual, mechanical and electrical inspections on a regular basis. We recommend routine

checks to be made on a yearly basis. Frequency of use and environment should determine this. It is

recommended to follow an Electrical Preventive Maintenance Program as described in NFPA 70B:

Recommended practice for Electrical Equipment.

2. The lens should be cleaned periodically as needed to ensure continued photometric performance.

Clean the lens with a damp, non-abrasive, lint-free cloth. If not sufficient, use mild soap or a liquid

cleaner.

3. Inspect the cooling fins on the luminaire to ensure that they are free of any obstructions or

contamination (i.e. excessive dust build-up). Clean with a non-abrasive cloth if needed.

4. Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.

USE AND CARE

Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.

Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of

children when not in use.Inspect for good working condition prior to storage and before re-use.

REPLACEMENT PARTS

The LEDLB-4-IR is designed to provide years of reliable performance. Should the need for replacement parts arise,

please contact Larson Electronics.

THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.

SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT

SAL[email protected] OR BY PHONE AT 1-877-348-9680 FOR FURTHER ASSISTANCE.

PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN INFORMATION.

Inhaltsverzeichnis

Andere Larson Electronics Beleuchtungsausrüstung Handbücher

Larson Electronics

Larson Electronics WAL-TL-2X12W-C-SP Bedienungsanleitung

Larson Electronics

Larson Electronics HALD-24-1X150LED-V3 Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-PM-150LED Handbuch

Larson Electronics

Larson Electronics PTB-1-50FT Bedienungsanleitung

Larson Electronics

Larson Electronics EPLC2-PT-2X150LED-RT Bedienungsanleitung

Larson Electronics

Larson Electronics EXP-EMG-2L-LE6 Bedienungsanleitung

Larson Electronics

Larson Electronics HL-85-LED-CPR-30-TRP Bedienungsanleitung

Larson Electronics

Larson Electronics LM Multi Stage Series Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-LED-50W-RT-JB2 Bedienungsanleitung

Larson Electronics

Larson Electronics EPLC2-EMG-HB-150LED-RT Bedienungsanleitung

Larson Electronics

Larson Electronics HALD-48-1X4-2X50LED-DIMM Bedienungsanleitung

Larson Electronics

Larson Electronics EPP-3P4W-30A-N7 Bedienungsanleitung

Larson Electronics

Larson Electronics VPLHL-7WLED-GR30 Bedienungsanleitung

Larson Electronics

Larson Electronics HAL-48-33W-LED-1227-70C Bedienungsanleitung

Larson Electronics

Larson Electronics HALD-48-1X100LED Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-HB-150LED-RT-JB2-25-BCE Bedienungsanleitung

Larson Electronics

Larson Electronics LEDWP-600E-M-E2E Bedienungsanleitung

Larson Electronics

Larson Electronics IND-LP-SS-24-2X2-2L-UVC Bedienungsanleitung

Larson Electronics

Larson Electronics EPLC2-LED-50W-RT-JB5 Bedienungsanleitung

Larson Electronics

Larson Electronics GL-9051-F-M Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-HB-50LED-RT Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-FL26-LED Series Bedienungsanleitung

Larson Electronics

Larson Electronics GAU-EMG-2X5W-LED-WP Bedienungsanleitung

Larson Electronics

Larson Electronics MMLP-1MLED-12P Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

Alien

Alien RG STAR Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Bedienungsanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung