Larson Electronics LM-20-3S-EW-LV Bedienungsanleitung

ver.0217-1

LM-20-3S-EW-LV Larson Electronics LLC 1

READ BEFORE USING OR INSTALLING!

Read instructions carefully before attempting to install the mast or operate

the mast winches. Failure to comply with instructions and guidelines could

result in serious or fatal injury, as well as void any warranty. Retain these

instructions for future reference.

1. Position the unit in its desired location. Ensure that the unit is

completely level and then anchor the unit using the mounting holes

located at the bottom of the base. When picking a location, ensure

the mast is free and clear from any overhead obstructions.

2. Put the mast head on with customer provided equipment.

3. Once the mast head with customer provided equipment is installed,

you are ready to put power to the unit. This unit runs off of 12VDC.

The 12VDC must be constant. This unit has a provided line in.

Connect the white wire to your positive and the black wire to your

negative. The red and green wires are for customer use and are not

tied to any source in the control box.

4. You are now ready to use the unit. Locate the control box on the

side of the unit. The lower right switch controls the power to the

whole unit. Turn that switch to the up (on) position.

5. To fold the mast up in the vertical position:

•Remove the mast retaining pin located at the bottom of the

mast.

Instruction Manual

ver.0217-1

LM-20-3S-EW-LV Larson Electronics LLC 2

•Make sure the upper left switch is in the “Fold up” position.

•Make sure the lower left switch is in the “Lower Winch”

position.

•Locate the upper right switch labeled “Run” and “Lower Winch

Control”.

•This is a momentary switch that only toggles up. This switch is

designed to stop the winch, when you let off of the switch.

•Toggling the momentary switch up, and holding it, the mast will

begin to rise from the folded over position.

•Once the mast reaches its vertical position, a sensor will make it

stop, and then briefly back off. This is by design, do not be

alarmed.

•Re-insert the mast retaining pin. Once you have reached that

point, you are ready to extend the mast.

Important!The winch is designed for intermittent use only.

Continuous running in excess of 3 minutes can damage the winch

motor. Allow a 20 minute cooling off period before continuing use.

Continuous use without a cooling off period will cause overheating

and damage the motor.

ver.0217-1

LM-20-3S-EW-LV Larson Electronics LLC 3

6. To extend the mast:

•Make sure the lower left switch is in the “Upper Winch”

position.

•Locate the provided hand control/pendant switch.

•The hand control plugs into a whip coming out of the bottom of

the control box.

•Once the hand control is plugged in, you are now ready to

extend the mast.

•Put the hand control in the “out” position

•Press the button that says “run” in order to

extend the mast to the desired height. Letting

off of the “run” button will stop the mast.

•Once the unit reaches its maximum height it

will hit a sensor and retract for 3 seconds. This

will prevent the mast from over extending.

Once you have reached that point, the unit is

installed.

Important: The winch is designed for intermittent

use only. Continuous running in excess of 3

minutes can damage the winch motor. Allow a 20

minute cooling off period before continuing use.

Continuous use without a cooling off period will

cause overheating and damage the motor.

7. To retract the mast:

•Make sure the lower left switch is in the “Upper Winch”

position.

ver.0217-1

LM-20-3S-EW-LV Larson Electronics LLC 4

•Locate the provided hand control/pendant switch.

•The hand control plugs into a whip coming out of the bottom of

the control box.

•Once the hand control is plugged in, you are now ready to

retract the mast.

•Put the hand control in the “in” position.

•Press the button that says “run” in order to retract the mast.

Letting off of the “run” button will stop the mast. Once the mast

is all the way down, let off of the “run” button.

•Once the cable goes slack, stop immediately. Do not allow the

winch to “free spool”.

Important: The winch is designed for intermittent use only.

Continuous running in excess of 3 minutes can damage the winch

motor. Allow a 20 minute cooling off period before continuing use.

Continuous use without a cooling off period will cause overheating

and damage the motor.

8. To fold the mast down in the horizontal/folded position:

NEVER FOLD THE MAST OVER WITH IT EXTENDED

•Remove the mast retaining pin located at the bottom of the

mast.

•Make sure the upper left switch is in the “Fold Down” position.

•Make sure the lower left switch is in the “Lower Winch”

position.

ver.0217-1

LM-20-3S-EW-LV Larson Electronics LLC 5

•Locate the upper right switch labeled “Run” and “Lower Winch

Control”.

•This is a momentary switch that only toggles up. This switch is

designed to stop the winch, when you let off of the switch.

•Toggling the momentary switch up, and holding it, the mast will

begin to fold over from the vertical position.

•Once the mast reaches the horizontal position, let off of the

momentary switch. Do not allow the mast to lay further than a

90 degree angle.

•Re-insert the mast retaining pin.

Important!The winch is designed for intermittent use only.

Continuous running in excess of 3 minutes can damage the winch

motor. Allow a 20 minute cooling off period before continuing use.

Continuous use without a cooling off period will cause overheating

and damage the motor.

9. Using the lower right switch, turn the power to “off”.

10. You can now disconnect from the power source.

9419 US-HWY 175

Kemp, TX 75143 USA

P: 800-369-6671 | INTL: 903-498-3363 F: 903-498-3364

sales@larsonelectronics.com

www.larsonelectronics.com

Andere Larson Electronics Beleuchtungsausrüstung Handbücher

Larson Electronics

Larson Electronics EPL-AMB-150LED-150-140DB Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-TL-2X10W-C-PA Series Bedienungsanleitung

Larson Electronics

Larson Electronics IND-DHA-FUVC-EX-48-3L-V2 Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-FL1524-LED-100 Bedienungsanleitung

Larson Electronics

Larson Electronics GAU-PT-150LTL-LED-480V Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-TP-2XRUL10 Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-SBDL-150RT-48 Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-HB-150LED-RT-NSF Bedienungsanleitung

Larson Electronics

Larson Electronics HAL-48-33W-LED-1227-70C Bedienungsanleitung

Larson Electronics

Larson Electronics LEDWP-600E-M-E2E-20C Bedienungsanleitung

Larson Electronics

Larson Electronics SPLED-QP-1X10WRE Bedienungsanleitung

Larson Electronics

Larson Electronics SLEDB-110V-MS Bedienungsanleitung

Larson Electronics

Larson Electronics WAL-TJL-250W-LED-CPR Bedienungsanleitung

Larson Electronics

Larson Electronics WCDE-11-6HPS-MR Bedienungsanleitung

Larson Electronics

Larson Electronics VPLHL-7WLED-GR30 Bedienungsanleitung

Larson Electronics

Larson Electronics EXP-LED-1XB-9W Bedienungsanleitung

Larson Electronics

Larson Electronics LEDWP-600E-M-E2E Bedienungsanleitung

Larson Electronics

Larson Electronics PML-15 Bedienungsanleitung

Larson Electronics

Larson Electronics C1D2 Bedienungsanleitung

Larson Electronics

Larson Electronics GL-9051-F-M Bedienungsanleitung

Larson Electronics

Larson Electronics GAU-EMG-2X5W-LED-WP Bedienungsanleitung

Larson Electronics

Larson Electronics HALPRM-PS-1000WMH Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-48-2L-T12VHO Bedienungsanleitung

Larson Electronics

Larson Electronics VPLHL-7WLED-PC-XGFI Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

Alien

Alien RG STAR Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Bedienungsanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung