Larson Electronics LE-4100-6-A Bedienungsanleitung

LE-4100-6-A

Remote Control LED Spotlight

12-24V DC, 5000 Lumens - (1) Wireless Remote - 6" Stanchion Mount

Instruction Manual

Thank you for your purchase of the Larson Electronics LE-4100-6-A remote control LED spotlight.

IMPORTANT

READ CAREFULLY BEFORE INSTALLING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTURE

REFERENCE. THE LE-4100-6-A MUST BE WIRED IN ACCORDANCE WITH NATIONAL ELECTRICAL CODE AND

ALL APPLICABLE LOCAL CODES. PROPER GROUNDING IS REQUIRED FOR SAFETY.

WE STRONGLY ENCOURAGE ONLY A LICENSED ELECTRICIAN INSTALL, OPERATE AND MAINTAIN THIS

PRODUCT. IF YOU ARE NOT QUALIFIED OR UNFAMILIAR WITH ANY ASPECT OF THIS INSTRUCTION SHEET,

CONSULT AN ELECTRICIAN. THERE ARE NO SERVICEABLE PARTS INSIDE.

WARNING: MAKE SURE POWER IS TURNED OFF BEFORE STARTING THE

INSTALLATION OR PERFORMING ANY MAINTENANCE.

RISK OF FIRE/ELECTRIC SHOCK –DISCONNECT POWER AT BREAKER BEFORE INSTALLING OR SERVICING.

RISK OF PERSONAL INJURY –FIXTURE MAY BECOME UNSTABLE OR DAMAGED IF NOTINSTALLED PROPERLY.

RISK OF BURN –ALLOW FIXTURE TO COOL BEFORE SERVICING.

Larson Electronics, LLC Phone: (877) 348-9680 Fax: (903) 498-3364 www.larsonelectronics.com 1of 3

MOUNTING

The light is mounted on a 6" stanchion post compatible with 2-pin Perko sockets. A

stanchion mount enables the light to be easily installed and removed for storage.

For installation to existing Perko socket, carefully engage stanchion into base

socket. As it slides into socket, make sure the alignment screw at rear of stanchion

slides into notch at rear of socket. Push stanchion down until it engages with

electrical connector at bottom of socket. Lock unit in place by sliding lock collar

into the top of the socket and rotate clockwise. Check to make sure stanchion is

secure in the socket. For installing Perko socket, follow steps page 2.

The LE-4100-6-A from Larson Electronics is a LED Search Light w/ Stanchion

Mount that provides intense output in outdoor locations and is recommended for

lighting support during nighttime operations, emergencies, patrolling, and more.

This LED light operates on 12 V or 24 V DC and provides 5000 Lumens of output

during use. Equipped with a wireless remotes, the LED light with white housing is

compatible with stanchion mounting installations and features a white anchor light.

WARNING: CHECK PRODUCT LABEL FOR CORRECT VOLTAGE!

Verify supply voltage matches product voltage rating as labeled.

SAFETY NOTICE:

◎If replacing LED module, the LED module connector should be connected correctly for positive and

negative wires.

RED and BLUE: Positive (+)

BLACK and BROWN: Negative (-)

◎FCC RULE Part. 15.21：Changes or modifications not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment.

◎This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device

may not cause harmful interference, and (2) this device must accept any interference received, including interference

that may cause undesired operation.

◎This searchlight is a Radio Frequency (RF) device which operates on Channel 433.92 MHz. It will send out RF energy

when it is in operation.

1. RF energy may affect some electronic equipment.

2. Some electronic equipment on vehicles or boats may be affected by RF energy.

LE-4100-6-A

Larson Electronics, LLC Phone: (877) 348-9680 Fax: (903) 498-3364 www.larsonelectronics.com 2of 3

1. For proper light selection, positioning and configuration, refer to A.B.Y.C. Standard A-16*, the '72 COLREGS*,

and the U.S. Inland Rules*.

2. These bases are designed to be mounted on a horizontal surface.

3. For Bi-Color lights, draw a 6" long reference line through the center of the selected mounting location and parallel

to the centerline of the boat.

4. Cut out the mounting template. Place it on the mounting surface such that the reference line (drawn above) is

directly underneath the reference line marked on the template.

5. Drill indicated holes through the template to accommodate #8 oval head mounting screws and socket as required.

6. Attach supply connections to the light, making sure to wire in accordance with both A.B.Y.C. Standard E-9* and

the U.S. Coast Guard Safety Standards for Boat Electrical Systems (33 CFR 183)*.

For 2-contact bases, the supply leads are coded as follows:

WHITE: Positive supply lead

BLACK: Negative supply lead (Caution: Negative lead connected to case. To avoid energizing case, observe

polarity.)

Electrical connections must be made such that the forward compartment is switched in conjunction with the

other running light(s); aft compartment should be switched with Ignition (or permanently energized), as a

push switch is provided on top of the light. NOTE: All light circuits must be circuit protected. Use a 1/2 Amp

fuse (or breaker) for the courtesy light circuit and a 2 Amp fuse (or breaker) for the combination light circuit.

7. Setup for Operation: As pole engages with base, make sure alignment screw in pole slides into the notch in the

base. Push pole until it engages the electrical connector and lock by rotating the locking collar clockwise.

*The above referenced standards can be obtained from

American Boat & Yacht Council, Inc.

613 Third Street, Suite 10

Annapolis, MD 21403

U.S. Coast Guard

Washington D.C. 20593

(or your local C.G. Office)

<< PRINT ACTUAL SIZE (100% SCALE) FOR CORRECT DIMENSIONS.

PERKO SOCKET INSTALLATION

Larson Electronics, LLC Phone: (877) 348-9680 Fax: (903) 498-3364 www.larsonelectronics.com 3of 3

IMPORTANT NOTICE

If searchlight DC power is disconnected (wires disconnected from battery or power supply switched off), after

reconnecting to power, make sure to turn on the searchlight using the wireless or wired remote, to make a full 360°

rotation, in order to reset the home position memory.

USE AND CARE

Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.

Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of

children when not in use.Inspect for good working condition prior to storage and before re-use.

REPLACEMENT PARTS

This spotlight is designed to provide years of reliable performance. Should the need for replacement parts arise, please

contact Larson Electronics.

THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.

SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT

SAL[email protected] OR BY PHONE AT 1-877-348-9680 FOR FURTHER ASSISTANCE.

PLEASE VISIT LARSONELECTRONICS.COM FORWARRANTY AND RETURN INFORMATION.

OPERATION:

1. Press on/off button to Switch on or off searchlight.

Change direction of the light beam by pressing the direction buttons.

2. Utilize the Function button to switch speed

Button Down

Button Left

Button Right

Button

Dual speed (Fast / Slow)

HANDHELD WIRELESS REMOTE PROGRAMMING:

1. Switch off DC Power or disconnect from battery.

2. Make sure there is NO other transmitter operating at the same time.

3. Switch on DC power, within 5 seconds press remote up ▲ and down ▼button

once simultaneously.

4. Searchlight will flash to acknowledge the remote. Connection has been made.

5. Up to 4 remotes may be used with the searchlight (programming a fifth remote

will replace the first). To program a second remote, within five seconds of

programming the first remote, press the second remote’s up and down button

once simultaneously. Repeat to program additional remotes.

NOTE: The included running lights are

always on when mount is receiving power.

The wireless remote control only controls the

search light and NOT the running lights.

LE-4100-6-A

Inhaltsverzeichnis

Andere Larson Electronics Scheinwerfer Handbücher

Larson Electronics

Larson Electronics Golight GL-3000-24-M Bedienungsanleitung

Larson Electronics

Larson Electronics GL-2000-S-E Handbuch

Larson Electronics

Larson Electronics IL-LED-27R Bedienungsanleitung

Larson Electronics

Larson Electronics HL-85-LED-CPR-NC Bedienungsanleitung

Larson Electronics

Larson Electronics LE Series Bedienungsanleitung

Larson Electronics

Larson Electronics LED10W-6RT-LT Bedienungsanleitung

Larson Electronics

Larson Electronics LE-217 Bedienungsanleitung

Larson Electronics

Larson Electronics GL-2000-24 Handbuch

Larson Electronics

Larson Electronics RL-85-3W1 Bedienungsanleitung

Larson Electronics

Larson Electronics GL-30514-S-E Handbuch

Larson Electronics

Larson Electronics Golight Radioray GL-2051GT Bedienungsanleitung

Larson Electronics

Larson Electronics HL-85-LED-CPR Bedienungsanleitung

Larson Electronics

Larson Electronics PML-90LED-DP-120 Bedienungsanleitung

Larson Electronics

Larson Electronics GVP-48-2L-LED-D-V2 Bedienungsanleitung

Larson Electronics

Larson Electronics HL-85-3W1-IR Bedienungsanleitung

Larson Electronics

Larson Electronics HL-85-CPR-MS Bedienungsanleitung

Larson Electronics

Larson Electronics GAU-LTL-500W-LED-IR Bedienungsanleitung

Larson Electronics

Larson Electronics GL-8130-M Bedienungsanleitung

Larson Electronics

Larson Electronics GL5150-12IR Handbuch

Larson Electronics

Larson Electronics Golight GL-2 GT Series Handbuch

Larson Electronics

Larson Electronics PTB-1-M Bedienungsanleitung

Larson Electronics

Larson Electronics MUL-30-LED Bedienungsanleitung

Larson Electronics

Larson Electronics LEDWL 1227 Series Handbuch

Larson Electronics

Larson Electronics RL-85-10W1 Bedienungsanleitung

Beliebte Scheinwerfer Handbücher anderer Marken

Guangzhou Yinhe Lighting&Sound Equipment Factory

Guangzhou Yinhe Lighting&Sound Equipment Factory NE-204 Bedienungsanleitung

LIVARNO home

LIVARNO home 375304 2101 Originalbetriebsanleitung

Cameo

Cameo CLQS40WW Bedienungsanleitung

Leviton

Leviton Ellipsoid 5/50 Bedienungsanleitung

Monacor

Monacor img Stage Line PARL-56PDX/CR Bedienungsanleitung

Vector

Vector SL3AKV Bedienungsanleitung

Quantum

Quantum Q262 Betriebshandbuch

Philips

Philips Vari-lite VL3015LT Bedienungsanleitung

EUROSPOT

EUROSPOT C51 Bedienungsanleitung

DTS

DTS MINI BRICK ARC Bedienungsanleitung

Federal Signal Corporation

Federal Signal Corporation VISIBEAM II Handbuch

ACME

ACME LED-MS350B Bedienungsanleitung

EuroLite

EuroLite Akku flat light 1 Bedienungsanleitung

Commercial Electric

Commercial Electric SPTM-1401 Bedienungsanleitung

Vision & Control

Vision & Control SLB-500-W5K7-P-SL Bedienungsanleitung

Teknik

Teknik FLEXI Bedienungsanleitung

Craftsman

Craftsman CMXLSB10 Bedienungsanleitung

EuroLite

EuroLite LED SLS-144 UV Floor Spot Bedienungsanleitung