Lathem 1221 Bedienungsanleitung

888 534-5994

1221

USER MANUAL

Contents

Here’s all the information you need for setting and operating your

new Lathem time recorder. Service information is also included

in this manual, in case any problems ever arise.

Thank you for choosing a Lathem time recorder. Should you

ever need assistance, please let us know.

Ordering Accessories ................................................ 2

Setting the Time ........................................................ 3

Changing the Ribbon................................................. 6

Replacing the Type Section....................................... 7

Changing the Motor ................................................... 8

Warranty .................................................................... 9

1200 Series User’s Manual

Ordering Accessories

For maximum results, only use Lathem

accessories specifically designed to fit your time recorder.

Description Part Number

Extra Pair of Keys JB976

Replacement Ribbon, 2-Colors 7-2CN

Replacement Timing Motor, 110V/60Hz K342

1200 Series User’s Manual

Setting the Time

Figure 1

Raise the Type Section

1. Unlock the case cover and pull it forward to remove it.

2. Wait until you hear the clock “click”.

3. Press either side of the Type Section Headlock – 1.2

and pull upward on the lower part of the Clock Face until

the Type Section locks in the up position as shown in

Figure 1. Note position of the Overthrow Lever and the

Setting Wheel.

4. Press the red Overthrow Lever – 1.3 away from you

until it clicks. This releases the wheels allowing them to

turn.

1200 Series User’s Manual

Set the Time on the Type Wheels

Figure 2

1. Locate the Center Line where all the wheels line up as

shown in Figure 2.

2. Rotate the wheels using a pointed object. Rotate each

wheel until the correct date and time are aligned at the

Center Position, as shown in Figure 2.Hint: Start at

the top wheel and work down when setting.

Note: if your machine records in 1-12 hours, the PM hours are

underlined. AM hours are not underlined. Set time to the proper

hour of the day to avoid errors such as setting the day wheel to

the next day at noon rather than midnight.

3. Rotate the Minute Wheels to show the current minute.

4. Set the Hour Wheel to the current hour

5. Rotate the Clock Face Setting Wheel– 3.1 to set the

hands to match the time set on the wheels.

6. Rotate the Main Setting Wheel – 2.1 to advance both

the Clock Face and Print Wheels together. Rotate until

you pass the actual time by one minute (each “click”

indicates one minute.)

7. Hold the corner of the Clock Face and release the

Release Latch – 2.2 by pushing it to the left. Slowly let

1200 Series User’s Manual

the Type Section down and press it firmly into the Type

Section Headlock.

8. Make a sample registration and verify the time and date

or day is correct.

9. Replace and lock the case cover.

Set the Time on the Clock Face

Figure 3

1. Make a sample registration on paper.

2. Rotate Clock Face Setting Wheel 3.1 until the clock

face displays the same time as shown on the sample

registration.

DO NOT TURN CLOCK HANDS EXCEPT BY USING

SETTING WHEEL.

1200 Series User’s Manual

Changing the Ribbon

Lathem time recorders have self-reversing ribbons. With normal

use, a ribbon should last for many months or even years….and

when the time comes, it is easy to change.

Figure 4

1. Remove the top cover and raise type section (see “Raise

the type section” on page 3.)

2. Remove the cotter pins 4.1 that retain the ribbon spools

and slide off old spools.

3. Lift ribbon hold-down guide 4.2 – use pencil to support

in up position.

4. Remove ribbon and replace with new Lathem ribbon.

Make sure the ribbon feeds from bottom of spools and

runs BETWEEN reversing fingers 4.3, the red side

aligned with date wheel(s).

5. Install cotter pins, remove pencil, and lower type section

into place.

1200 Series User’s Manual

Replacing the Type Section

If your type section needs servicing, you can easily remove and

replace it with a spare, without sending the entire machine for

service.

Figure 5

1. Remove the top cover.

2. Remove Type Section Retaining Ring – 5.1.

3. Lift type section slightly and move it to the right to

release Hinge Pins – 5.2 from their sockets. Unit will lift

out.

1200 Series User’s Manual

Changing the Motor

Figure 6

1. Unplug cord from wall outlet.

2. Remove type section from main frame (see “Replacing

the Type Section”).

3. Figure 6 shows a close-up of cam block terminal.

4. Disconnect Motor Wire Leads – 6.1 by turning each

Screw – 6.2 one-quarter of a turn counterclockwise.

5. Remove the Motor Clutch – 6.3 from its shaft. The

shaft has LEFT HAND threads – remove clutch by

turning clockwise.

6. Hold Motor Bracket – 6.4 and loosen Motor Mounting

Screws – 6.5. Remove and retain screws and bracket

from old motor.

7. Install motor clutch on new motor. Turn

counterclockwise to tighten. DO NOT OVERTIGHTEN

OR BEND – YOU MAY DAMAGE INTERNAL MOTOR

GEARS.

8. Install new motor.

9. Plug cord back in wall outlet, and reset the time.

1200 Series User’s Manual

Warranty

One-Year Limited Warranty

Lathem warrants the hardware products described in this guide against

defects in material and workmanship for a period of one year from date

of original purchase. The conditions of this warranty and the extent of

the responsibility of Lathem Time Corporation (“Lathem”) under this

warranty are listed below.

1. This warranty will become void when service performed by

anyone other than an approved Lathem warranty service

dealer results in damage to the product.

2. This warranty does not apply to any product which has been

subject to abuse, neglect, or accident, or which has had the

serial number altered or removed, or which has been

connected, installed, adjusted, or repaired other than in

accordance with instructions furnished by Lathem.

3. This warranty does not cover dealer labor cost for removing

and reinstalling the machine for repair, or any expendable

parts that are readily replaced due to normal use.

4. The sole responsibility of Lathem under this warranty shall be

limited to repair of this product, or replacement thereof, at the

sole discretion of Lathem.

5. If it becomes necessary to send the product or any defective

part to Lathem or any authorized service dealer, the product

must be shipped in its original carton or equivalent, fully

insured with shipping charges prepaid. Lathem will not assume

any responsibility for any loss or damage incurred in shipping.

6. WARRANTY DISCLAIMER: Limitation of Liability. Except in

only the limited express warranty set forth above, there are no

expressed or implied warranties of merchantability and fitness

for a particular purpose. In no event will Lathem be liable for

any direct, special, or consequential damages arising out of or

in connection with the delivery, use or inability to use, or

performance of this product.

7. Proof of date of purchase is required for warranty service on

this product.

8. This Warranty grants specific legal rights. Additional legal

rights, which may vary by locale, may also apply.

9. Should any difficulties arise with the performance of this

product during warranty, or with any Lathem authorized service

centers, contact Lathem Time.

Inhaltsverzeichnis

Andere Lathem Uhr Handbücher

Lathem

Lathem 7500E Bedienungsanleitung

Lathem

Lathem DDC2-RS Bedienungsanleitung

Lathem

Lathem Airtime AT-DDC4 Bedienungsanleitung

Lathem

Lathem 100E Bedienungsanleitung

Lathem

Lathem 1600E Bedienungsanleitung

Lathem

Lathem 2121 Bedienungsanleitung

Lathem

Lathem 900E Bedienungsanleitung

Lathem

Lathem 2121 Bedienungsanleitung

Lathem

Lathem 2000 Bedienungsanleitung

Lathem

Lathem LTR4-512 Bedienungsanleitung

Lathem

Lathem TruAlign 800P Bedienungsanleitung

Lathem

Lathem PC100-R Bedienungsanleitung

Lathem

Lathem 7000E Bedienungsanleitung

Lathem

Lathem 700E Bedienungsanleitung

Lathem

Lathem 900E Bedienungsanleitung

Lathem

Lathem PAYCLOCK PC50 Bedienungsanleitung

Lathem

Lathem 8800 Series Bedienungsanleitung

Lathem

Lathem 900E Bedienungsanleitung

Lathem

Lathem 6000E Bedienungsanleitung

Lathem

Lathem 1000E Bedienungsanleitung

Lathem

Lathem DWA-4000 Bedienungsanleitung

Lathem

Lathem DWA-4000 Bedienungsanleitung

Lathem

Lathem 4000 Series Bedienungsanleitung

Lathem

Lathem Mechanical Time Recorder Bedienungsanleitung

Beliebte Uhr Handbücher anderer Marken

Silicon Laboratories

Silicon Laboratories SI5324 Bedienungsanleitung

Heathkit

Heathkit GC-1005 Bedienungsanleitung

Oregon Scientific

Oregon Scientific PRYSMA RMR221P Bedienungsanleitung

Andrew O'Malley

Andrew O'Malley DOTKLOK Bedienungsanleitung

ALGE-Timing

ALGE-Timing ASC3 Bedienungsanleitung

Bodet

Bodet Profil 960 Bedienungsanleitung

Nixie Clock

Nixie Clock Divergence Meter Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS-8256-AL Bedienungsanleitung

Mini Gadgets

Mini Gadgets MCPro Bedienungsanleitung

Casio

Casio TMR-200 Bedienungsanleitung

Progetti

Progetti ILTEMPOSTRINGE Handbuch

BVItech

BVItech BV-101 Bedienungsanleitung

Progetti

Progetti KALIMERO Handbuch

La Crosse Technology

La Crosse Technology WT-3141b Handbuch

La Crosse Technology

La Crosse Technology W86531 Bedienungsanleitung

Sharp

Sharp SPC900 Bedienungsanleitung

La Crosse Technology

La Crosse Technology 404-50447 Bedienungsanleitung

Datexx

Datexx DF0063 Bedienungsanleitung