© 2019 LEA Professional. All Rights Reserved.
SAFETY INSTRUCTIONS | SafeOperation
1. Read these instructions before installing or
operating this unit.
2. Keep these instructions somewhere for your
reference.
3. Heed all warnings provided in these instructions.
4. Follow all instructions found in this document.
5. Keep this unit away from water at all times.
6. Use only a dry cloth to clean the unit.
7. Do not block any ventilation openings. Follow the
installation instructions from this manual for proper
ventilation.
8. Never install this unit near a heat source such as
furnace, radiator, heat registers, ovens, or other
anything else that produces heat.
9. Do not alter the safety purpose of the polarized or
grounding-type plug. If the provided plug does not fit
into your outlet, consult an electrician.
10. Keep the power cord away from areas at risk of
being walked on, tripped over, or pinched.
11. Only use attachments/accessories specified within
this document.
12. Unplug this device during lightning storms or
when unused for long periods of time.
13. Do not attempt to service this unit. All servicing
must be performed by a qualified LEA service
technician. To find a qualified LEA technician, contact
your local LEA dealer/distributor.
14. To disconnect the device from the mains, use the
mains plug.
15. WARNING: DO NOT EXPOSE THIS
APPARATUS TO RAIN OR MOISTURE. DOING SO
CAN RESULT IN AN ELECTRAL SHOCK.
16. ENSURE THAT NO LIQUID-FILLED OBJECTS,
SUCH AS DRINKING WATER, ARE PLACED ON
THE EQUIPMENT. KEEP EQUIPMENT AWAY
FROM DRIPPING OR SPASHING.
17. THE MAINS PLUG OF THE POWER SUPPLY
CORD SHALL REMAIN READILY OPERABLE.
MAGNETIC FIELD
CAUTION! All high-gain devices such as preamplifiers
should be installed away from the device. Due to the
high-power density of this amplifier, it has a strong
magnetic field which can induce hum into unshielded
devices that are located nearby. The field is strongest
just above and below the unit. If an equipment rack is
used, we recommend installing the amplifier(s) in the
bottom of the rack and the preamplifier or other
sensitive equipment at the top.
BE AWARE OF THESE SYMBOLS:
The lightning bolt alert is used to inform
the user to the risk of potential electric
shock.
The exclamation point alert is used to
inform the user of
important operating or maintenance
instructions
DO NOT REMOVE TOP OR
BOTTOM COVERS ON THIS DEVICE. NO USER
SERVICEABLE PARTS INSIDE.
CONTACT QUALIFIED SERVICE PERSONNEL FOR
ALL SERVICING MATTERS.
FCC COMPLIANCE NOTICE
This device complies with part 15 of the FCC rules.
Operation is subject to the following
two conditions: (1) This device may not cause harmful
interference, and (2) this device
must accept any interference received, including
interference that may cause undesired
operation.
CAUTION: Changes or modifications not expressly
approved by the party responsible for compliance
could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help
