Lec+ PE 907 Bedienungsanleitung

PE 357

PE 907

PG 907

Operating Instructions

refrigerators

GB/IE

The refrigerator was developed taking the different storage requirements of Pharmacy

products into consideration. Some must be stored cold - others require a little higher

temperature. A few must be stored separately. To ensure that you get the best out

of your new refrigerator, it is important that you become familiar with the refrigerator

functions and know how to use the accessories. Please read the instructions for use

carefully before setting up and using your refrigerator.

As these instructions apply to several refrigerator models, the equipment may vary

from model to model.

Before using the refrigerator

On receipt, check to ensure that the refrigerator has not become damaged during

transportation. Any transport damage should be reported to our Customer Services

department immediately.

Before lling the refrigerator with contents / products, the refrigerator interior should

be cleaned with lukewarm water containing a mild detergent. Use a soft cloth. If the

refrigerator has been stored in cold surroundings (colder than +5°C), it must be allowed

to stabilise for at least 2 hours before being switched on.

Read more about setting up, building in, and installation on pages 10 and 11.

GB/IE

Contents

Important information

Transporting and moving the refrigerator 4

If the refrigerator is to remain unused for a time 4

Old refrigerators 4

Disposal 4

Product description 5

Using the refrigerator

User interface 6

First start up 6

Deleting recorded exceedance (MIN / MAX) 7

ALARM CONDITION / REMOTE ALARM 7

Alarms 7

Using the refrigerator and accessories

Shelves 8

Defrosting and cleaning

Automatic defrosting 8

Manual defrosting 8

Cleaning 8

Setting up and installation

Where to place the refrigerator 10

Electrical connection 11

Maintenance and Service 12

Changing the door hinging 14

Spare parts 15

GB/IE

Important information

The refrigerator contains the environment-friendly, non-ozone-depleting refrigerant

R600a. As R600 is a ammable gas, it is important to avoid damage to the refrigera-

tion circuit during transport and installation. If the refrigeration circuit is damaged,

avoid using naked ame in the vicinity of the refrigerator and connecting power to the

refrigerator. Also make sure that there is good ventilation in the room. If you are in

doubt, please contact your supplier.

Transporting and moving the refrigerator

The refrigerator must always be moved in the vertical position. The cabinet must not

be tilted more than approx. 40°. If the refrigerator has been tilted more than 40°, the

power supply must not be connected until the appliance has stood upright for at least

two hours.

If the refrigerator is not to be used for some time

If the refrigerator is to remain unused for a period of time, switch it off by pressing

button ‘ I’ (1). Then disconnect the power supply to the refrigerator and preferably pull

the plug out of the wall socket.

Empty, defrost and clean the refrigerator. Leave the refrigerator door slightly ajar. This

will prevent bad smells in the refrigerator.

Warning

This appliance is not intended for use by persons (including children) with reduced

physical, sensory or mental capabilities, or lack of experience and knowledge, unless

they have been given supervision or instruction concerning use of the appliance by a

person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

Old refrigerators and freezers are often tted with complicated latches that can only be

opened from the outside. If you have an old unit like this stored away somewhere, or if

you scrap it, remember to destroy the latch to prevent children from being exposed to

danger by getting locked inside the unit.Note! Please also observe the environmental

rules on disposal.

Disposal

If a refrigerator is to be disposed of, this must be done in an environmentally correct

way, in accordance with current rules on disposal.

Please observe the environmental rules on disposal. There might be special require-

ments/conditions to be observed.

Information on disposal can be obtained from:

- Your supplier

- Authorities (the local council, Ministry of the Environment, etc.)

GB/IE

Product description

The refrigerator is intended for use in a Pharmacy. It is designed to safely store prod-

ucts and contents between 2 and 8 degrees C.

Please nd on the product nameplate the interval of ambient temperature for which

this product is designed to have the best performances

Class Symbol Ambient Temperature

Range °C

Extended

Temperate SN + 100C to + 320C

Temperate N + 160C to + 320C

Subtropical ST +180C to + 380C

Using the refrigerator

1. User interface

Button (1) ‘ I ’ (ON /OFF) – pressed for about 2-3sec – switches on and switches off

whole product's controlling,

Button (2) ‘light’ – turns on and off the lighting, if it is not turned off, it turns off auto-

matically after 3 minutes.

Green LED diode (3) – indicates lighting turned on,

Button (4) ‘lock’ – pressed for about 2-3sec – blocks the keypad – does not refer to

button (1) driver switch off,

Green LED diode (5) – indicates active blockade function,

‘-‘ minus diode (6) – indication of temperatures below zero,

LED display (7) –temperatures, service parameters and alarm symbols display,

Button (8) ‘▼’ - minimum temperature preview or parameter value decrease,

Button (9) ‘▲’ – maximum temperature preview or parameter value increase,

Button (10) AUX – functional button,

Green LED diode (11) – indication of temperature programming mode – manual

switch of AUX output,

2. First start up

After switching on, the driver activates the auto-test procedure. During the rst se-

cond, it displays dots, program version during next second, dots during the third

second and then switches to normal work mode.

During normal work mode, the display shows cooler temperature. In case of an alarm,

it displays E with alarm number.

If the driver is switched off, LED diodes are turned off and the display shows two

horizontal lines.

The display indicates temperature of the cooler-freezer within the range of –30oC to +30oC

GB/IE

3. Deleting recorded exceedance (MIN / MAX):

- pressing buttons (8)‘▼’ and (9)‘▲’ for about 2-3sec results in deleting saved min/

max temperatures and saving current temperature in the driver’s memory

4. ALARM CONDITION / REMOTE ALARM

On PE 357, PE 907, PG 907 models the jack plugs are in a box at the rear of the

cabinet in the compressor cavity.

Note! The power source for this circuit must be external to the cabinet and MUST

NOT EXCEED 50 V AC/DC. This must be installed by a competent electrician.

In normal conditions (no alarm) the AUX relay OPENS the contact for the remote

alarm facility.

When there is alarm condition (Hi/Lo temperature, E1, E2, probe failure), the AUX

relay CLOSES the contact.

In alarm condition (excluding power failure), pressing any button for 1 second causes

the alarm display to be cancelled, the buzzer to be muted and the AUX relay to open

the contact.

After the alarm has been silenced, if the alarm ends , all indications are erased.

5. Alarms

A displayed alarm should be saved even if the reason of the alarm does not exist

anymore

Alarms are not saved after switch off (lack) of energy.

E1 – cooler sensor malfunction – if the error persist for a long time please call the

Customer service

E2 – evaporator sensor malfunction – if the error persist for a long time please call

the Customer service

Hi – maximum set temperature of the product exceeded – please be sure that the

door is properly closed, the compartment is not over loaded, air circulation to the sen-

sor is blocked - if the error persist for a long time please call the Customer service

Lo – minimum set temperature of the product exceeded – - if the error persist for a

long time please call the Customer service

By pressing any button the sound alarm will be off as well Hi and Lo indications.

E1 and E2 can be erased if the malfunction is xed and the electronic control board

is reset (unplug the appliance).

GB/IE

Automatic defrosting

The refrigerator features automatic defrosting. In some periods, however, frost may

form on the rear wall of the refrigerator. This normally happens when the compartment

is very full or when many new items of are stored in the refrigerator. In situations such

as these the compressor must run for long periods of time. As automatic defrosting

takes place while the compressor is at a standstill, the refrigerator may not defrost

completely before the compressor restarts. In these instances, manual defrosting is

required.

Manual defrosting

Stop the compressor by pressing button ‘ I’ (1) and disconnect the power supply to

the refrigerator.

Any loose frost on the evaporator can be removed using a plastic or wooden scraper.

Never use a knife or a sharp object as these can damage the evaporator.

Warning

It is dangerous to use electrical apparatus, knives or sharp objects to speed up the

defrosting process.

Cleaning

Stop the compressor by pressing button ‘ I’ (1) and disconnect the power supply to

the refrigerator

Defrosting and cleaning

Using the refrigerator and accessories

Shelves

Extract the shelf by lifting up the left shelf

side (12). Start by removing the top shelf

when you want to clean the refrigerator

or rearrange the shelves.

The refrigerator is best cleaned using a weak soap solution and a soft cloth. Do not

use cleaning agents that scour. Clean the sealing strip around the door regularly to

prolong its life. Use only clean water for cleaning the sealing strip. The plastic parts

of the cabinet cannot withstand boiling water (max. 85°C). It is important to prevent

water from getting into the control panel

Clean the melt water drain in the refrigerator compartment using the cleaning pin

supplied (13).

GB/IE

Cleaning of doors in stainless

steel or aluminium

Cleaning of doors in stainless steel or

aluminium

Stainless steel or aluminium doors on Lec

products can, with advantage, be cleaned

with a spray and a soft cloth. There are

a number of different spraying agents for

this purpose on the market.

Remove dust and threads from the

compressor compartment at the back of

the refrigerator with a vacuum cleaner.

GB/IE

Setting up and installation

Where to place the refrigerator

For safety reasons the refrigerator must not be installed outdoors; it must be placed

in a dry room. Never place the appliance close to sources of heat such as radiators,

and avoid placing it in direct sunlight. The surface on which the appliance is placed

must be at. Do not use a frame or similar. The small wheels mounted at the rear of

the refrigerator make it easy to place it in the required position.

The refrigerator can be set up free-standing against a wall.

It is important that the appliance stands completely level and that there is good air

circulation over, under and around it. The refrigerator can be adjusted by turning the

four adjusting screws on the plinth. After adjustment, the feet and the two rear wheels

must be in contact with the surface on which the appliance stands.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Lec+ Kühlschrank Handbücher

Lec+

Lec+ INT800LA Bedienungsanleitung

Lec+

Lec+ TL5510W Bedienungsanleitung

Lec+

Lec+ TU55142W Bedienungsanleitung

Lec+

Lec+ R50052W Bedienungsanleitung

Lec+

Lec+ TS50152W Bedienungsanleitung

Lec+

Lec+ TF55185W Bedienungsanleitung

Lec+

Lec+ T5039W Bedienungsanleitung

Lec+

Lec+ R5010W Bedienungsanleitung

Lec+

Lec+ RST6057I Bedienungsanleitung

Lec+

Lec+ L6014W/S Bedienungsanleitung

Lec+

Lec+ CL 157 Bedienungsanleitung

Lec+

Lec+ TS55142W Bedienungsanleitung

Lec+

Lec+ R50263W Bedienungsanleitung

Lec+

Lec+ R6014W/S Bedienungsanleitung

Lec+

Lec+ TS55184W Bedienungsanleitung

Lec+

Lec+ T50084W Bedienungsanleitung

Lec+

Lec+ TF60185WTD W Bedienungsanleitung

Lec+

Lec+ TF55152S Bedienungsanleitung

Lec+

Lec+ TR55122W Bedienungsanleitung

Lec+

Lec+ U6014W/S Bedienungsanleitung

Lec+

Lec+ T50082W Bedienungsanleitung

Lec+

Lec+ L5010W Bedienungsanleitung

Lec+

Lec+ L5017W Bedienungsanleitung

Lec+

Lec+ T5576W Bedienungsanleitung

Beliebte Kühlschrank Handbücher anderer Marken

Bonnet Neve

Bonnet Neve SKYVIEW PLUS Bedienungsanleitung

Zanussi Electrolux

Zanussi Electrolux ZERB 8441 Bedienungsanleitung

Sharp

Sharp SJ-BA31IEXW2-EU Bedienungsanleitung

CORBERO

CORBERO CC2300MCW Bedienungsanleitung

KitchenAid

KitchenAid 2205264 Bedienungsanleitung

Stengel

Stengel KU 1101 A++ Bedienungsanleitung

NEFF

NEFF KI181 Series Bedienungsanleitung

Hoshizaki

Hoshizaki Reach-In Bedienungsanleitung

Amana

Amana ASD2524VES00 Bedienungsanleitung

BOMANN

BOMANN KGC 213 Bedienungsanleitung

Danby

Danby DAR044A1SLDD Montageanleitung

Samsung

Samsung RF323TE Bedienungsanleitung

Beko

Beko CSA31022 Bedienungsanleitung

IKEA

IKEA FROSTIG C 185 E Bedienungsanleitung

Electrolux

Electrolux ER 6821 D Bedienungsanleitung

True

True TS-28 Bedienungsanleitung

Frigidaire

Frigidaire FSC23R5DW9 Bedienungsanleitung

Beko

Beko LSP4579W Bedienungsanleitung