LEGRAND DAKER DK Plus Series Bedienungsanleitung

DAKER DK Plus

1 kVA - 3 kVA

Manuel d’installation • Installation manual

Table of Contents

1. Introduction 34

1.1 Use of the manual 35

1.2 Guarantee terms 35

1.3 Copyright 35

2. Safety Instructions 36

3. Installation 38

3.1 Package content 38

3.2 Tower configuration setup 39

3.2.1 UPS 39

3.2.2 UPS + battery cabinet (optional) 40

3.3 Rack configuration setup 41

3.4 Rear panel 43

3.5 Installation procedure 44

4. Operation 45

4.1 Control Panel 45

4.1.1 LCD Panel 45

4.1.2 Display description 46

4.2 Operating modes 47

4.3 Start-up procedure 48

4.3.1 Normal mode 48

4.3.2 Cold start 48

4.4 Shutdown 49

4.5 UPS Measurements 49

4.6 UPS settings 50

4.7 Settings shortcuts 55

4.8 Emergency Power Off (EPO) 55

4.9 Communication devices 56

5. Troubleshooting 57

6. Warehousing and dismantling 59

6.1 Warehousing 59

6.2 Dismantling 59

DAKER DK Plus

1 kVA - 3 kVA

1 Introduction

Congratulations on your recent LEGRAND purchase!

ATTENTION

It is necessary to read the whole manual carefully before doing any operation.

DAKER DK Plus must be used only in residential, commercial industrial environments.

The following diagram illustrates the architecture of the UPS system:

The major modules consist of:

• An AC-to-DC power converter (rectifier) with PFC control circuit.

• A DC-to-AC high frequency inverter.

• A battery charger.

• A battery bank.

• A DC-to-DC push/pull converter control circuit.

• A static bypass loop.

• Input and output EMI filters.

1.1 Use of the manual

This manual must be kept in a safe, dry place and must always be available for consultation.

The manual reflects the state of the art when the equipment was put onto the market. This pub-

lication conforms to the standards current on that date; the manual cannot be considered inade-

quate when new standards come into force or modifications are made to the equipment.

INDICATION

The installation manual is an integral part of the equipment supplied and must therefore be kept

for its entire lifetime. In case of need (for example in the case of damage that even partially com-

promise its consultation) a new copy must be requested from the Manufacturer, quoting the pub-

lication code on the cover.

1.2 Guarantee terms

The terms of the guarantee may vary depending on the country where the UPS is sold. Check the

validity and duration with LEGRAND’s local sale representative.

The Manufacturer declines all indirect or direct responsibility arising from:

- failure to observe the installation instructions and use of the equipment which differs from the

specifications in the installation manual;

- use by personnel who have not read and thoroughly understood the content of the installation

manual;

- use that does not comply with the specific standards used in the country where the equipment

is installed;

- modifications made to the equipment, software, functioning logic unless they have been author-

ized by the Manufacturer in writing;

- repairs that have not been authorized by the LEGRAND Technical Support Service;

- damage caused intentionally, through negligence, by acts of God, natural phenomena, fire or

liquid infiltration.

1.3 Copyright

The information contained in this manual cannot be disclosed to third parties. Any partial or total

duplication of the manual which is not authorized in writing by the Manufacturer, by photocopy-

ing or other systems, including by electronic scanning, violates copyright conditions and may lead

to prosecution.

LEGRAND reserves the copyright of this publication and prohibits its reproduction wholly or in

part without previous written authorisation.

DAKER DK Plus

1 kVA - 3 kVA

2 Safety Instructions

This section contains important safety instructions that should always be followed during the in-

stallation, use and maintenance of the UPS.

• This product should be installed in compliance with installation rules, preferably by a qualified

electrician. Incorrect installation and use can lead to risk of electric shock or fire. Before carry-

ing out the installation, read the instructions and take account of the product’s specific mount-

ing location. Do not open up, dismantle, alter or modify the device except where specifically

required to do so by the instructions. All Legrand products must be opened and repaired ex-

clusively by personnel trained and approved by Legrand. Any unauthorised opening or repair

completely cancels all liabilities and the rights to replacement and guarantees. Use only Legrand

brand accessories.

• If any visible damage is found on the product during the unpacking operation, do not install the

UPS but repack the unit and return it to your reseller or distributor.

• Before operating the UPS or connecting any load equipment, ensure the UPS is connected to a

properly grounded electrical supply.

• The load applied must not exceed the one indicated on the type label of the UPS.

• The ON/OFF button of the UPS does not electrically isolate the internal parts. To isolate the UPS,

unplug it from the mains power socket.

• Do not attempt to open or disassemble the UPS; there are no user replaceable parts. Opening

the case will void the warranty and introduces the risk of electric shock even when the mains

plug is disconnected.

• The mains socket outlet that supplies the UPS shall be installed near the UPS and shall be easily

accessible.

• Do not plug non-computer-related items such as medical, life-support and house electric equip-

ments to the UPS output.

• Do not plug laser printers to the UPS output because they have a high start-up current.

• The UPS has its own internal energy source (batteries). If the UPS is switched on when no AC

power is available, there is hazardous voltage at the output sockets.

The batteries inside the UPS are not user-replaceable. Servicing of batteries must be

performed only by electrical hazard authorized personnel.

CAUTION: A battery can present a risk of electrical shock and high short circuit current.

The following precautions should be observed when working on batteries:

a) Remove watches, rings or other metal objects.

b) Use tools with insulated handles.

c) Wear rubber gloves and boots.

d) Do not lay tools or metal parts on top of batteries.

e) Disconnect the charging source prior to connecting or disconnecting battery terminals.

f) Determine if battery is inadvertently grounded. If inadvertently grounded, remove source

from ground. Contact with any part of a grounded battery can result in electrical shock.

The likelihood of such shock can be reduced if such grounds are removed during installa-

tion and maintenance (applicable to equipment and remote battery supplies not having a

grounded supply circuit).

CAUTION: Do not dispose of batteries in a fire. The batteries may explode.

CAUTION: Do not open or mutilate batteries. Released electrolyte is harmful to the skin and

eyes. It may be toxic.

• This UPS has dangerous high voltages on its input and output connections. Contact with these

voltages may be life threatening.

• In case of emergency, immediately turn off the equipment and disconnect the power cord from

the AC power supply to disable the UPS.

• Do not allow any liquid or any foreign object to enter the UPS.

• The UPS is intended for indoor installation in a ventilated, controlled indoor environment with

a range of temperature between 0°C (+32°F) and +40°C (+104°F) and non-condensing humidity

between 20% and 80%.

• Do not install the UPS in locations with sparks, smoke and hazardous gas or where there is water

and excessive humidity. Dusty, corrosive, and salty environments can damage the UPS.

• Do not plug the UPS input into its own output.

• Do not attach a power strip or surge suppressor to the UPS.

• Do not cover the cooling vents and keep a clearance of 20 cm beyond the UPS rear panel. Avoid

exposing it to direct sunlight or installing it near heat emitting appliances.

• Unplug the UPS prior to cleaning and do not use liquid or spray detergent.

• Do not place the UPS near equipments that generate strong electromagnetic fields and/or near

equipments that are sensible to electromagnetic fields.

WARNING

All the UPSs are category C2 products according to the EN 62040-2. In a residential en-

vironment, these equipments may cause radio interference, in which case the user may be re-

quired to take additional measures.

DAKER DK Plus

1 kVA - 3 kVA

3 Installation

3.1 Package content

Check for the following package content:

3.2 Tower configuration setup

3.2.1 UPS

DAKER DK Plus

1 kVA - 3 kVA

3.2.2 UPS + battery cabinet (optional)

3 Installation

3.3 Rack configuration setup

INDICATION

For the rack configuration setup it is also possible to use the rack support bracket kit 3 109 52. In

this case, follow the instruction sheet contained in the kit.

DAKER DK Plus

1 kVA - 3 kVA

Andere Handbücher für DAKER DK Plus Series

Inhaltsverzeichnis

Andere LEGRAND UPS Handbücher

LEGRAND

LEGRAND Ekinoxe 327 13 Bedienungsanleitung

LEGRAND

LEGRAND KEOR SPE TOWER Series Bedienungsanleitung

LEGRAND

LEGRAND WHAD HE 3 101 67 Handbuch

LEGRAND

LEGRAND MIDDLE ATLANTIC NEXSYS UPX-EXPANRUN-10-15 Bedienungsanleitung

LEGRAND

LEGRAND KEOR T Bedienungsanleitung

LEGRAND

LEGRAND Archimod Betriebsanleitung

LEGRAND

LEGRAND KEOR S 3KVA 1 Handbuch

LEGRAND

LEGRAND Keor MOD Top Entry Bedienungsanleitung

LEGRAND

LEGRAND KEOR T 208V 40 KVA Bedienungsanleitung

LEGRAND

LEGRAND DAKER DK Plus Series Bedienungsanleitung

LEGRAND

LEGRAND NUMERIC HP i 33 40 kVA Series Bedienungsanleitung

LEGRAND

LEGRAND KEOR HPE 100 kVA Bedienungsanleitung

LEGRAND

LEGRAND Seismic Kit Trimod HE Bedienungsanleitung

LEGRAND

LEGRAND KEOR COMPACT Bedienungsanleitung

LEGRAND

LEGRAND KEOR MOD Bedienungsanleitung

LEGRAND

LEGRAND KEOR COMPACT Bedienungsanleitung

LEGRAND

LEGRAND KEOR LP Bedienungsanleitung

LEGRAND

LEGRAND Daker DK 4.5 kVA Bedienungsanleitung

LEGRAND

LEGRAND Trimod 10 kVA Betriebsanleitung

LEGRAND

LEGRAND Whad HE 800 VA Bedienungsanleitung

LEGRAND

LEGRAND KEOR MULTIPLUG Bedienungsanleitung

LEGRAND

LEGRAND 332 75 Bedienungsanleitung

LEGRAND

LEGRAND KEOR MULTIPLUG 600 Bedienungsanleitung

LEGRAND

LEGRAND Trimod HE Referenzhandbuch

Beliebte UPS Handbücher anderer Marken

Pylontech

Pylontech Victron & Pylontech US5000 Bedienungsanleitung

Tecnoware

Tecnoware EVO DSP PLUS MM 6.8 Bedienungsanleitung

Mecer

Mecer ME-1000-WTU Bedienungsanleitung

Mustek

Mustek PowerMust 530(B) Plus Installations- und Betriebshandbuch

Emerson

Emerson Liebert NXL series Bedienungsanleitung

MAKELSAN

MAKELSAN BOXER SERIES Bedienungsanleitung

Block

Block PC-0524-400-0 Bedienungsanleitung

CyberPower

CyberPower CP585LCD Bedienungsanleitung

Eaton

Eaton 3S Montageanleitung

CyberPower

CyberPower Office Tower Series UPS 1000 Bedienungsanleitung

CyberPower

CyberPower BM100 Bedienungsanleitung

Best Power

Best Power 610 Bedienungsanleitung

Best Power

Best Power Unity/I UT3K Bedienungsanleitung

Mustek

Mustek PowerMust 400 Offline Bedienungsanleitung

Xantrex

Xantrex Trace 512 UR-UPS Bedienungsanleitung

Forza

Forza SL-1501UL Bedienungsanleitung

ABB

ABB Conceptpower DPA 500 Bedienungsanleitung

ZincFive

ZincFive BC Series Bedienungsanleitung