LENCO Auto Glide Bedienungsanleitung

3-11-11

Auto Glide

Boat Control System

Auto Glide

Boat Control System

Owner’s Manual B

Please visit our website to view up-to-date information and various

videos which may be beneficial to you. www.lencoautoglide.com

Operational Instructions

AUTO GLIDE OPERATION INSTRUCTIONS

Once the Home Roll Default Position and Home Pitch Default Position have been saved, the Auto Glide can provide

you with full automatic boat control. This section describes how to operate the Auto Glide in both AUTOMATIC and

MANUAL MODES.

Here is the list of topics we will cover in this section:

I. KEY PAD OVERVIEW………………………………………………………………………………………………………………….

3 - 5

A. KEY PAD BUTTONS………………………………………………………………………………………………………………….

B. KEY PAD BUTTON LED INDICATORS………………………………………………………………………………….

C. CROSSHAIR LED INDICATORS……………………………………………………………………………………………..

4 - 5

II. AUTOMATIC OPERATIONAL MODES…………………………………………………………………………………..

6 - 22

A. IDLE MODE…………………………………………………………………………………………………………………………………

6 - 8

1. ENTERING IDLE MODE …………………………………………………………………………………………………………

6 - 7

2. EXITING IDLE MODE INTO HOLE SHOT MODE……………………………………………………………………

B. HOLE SHOT MODE……………………………………………………………………………………………………………………

9 - 14

1. TRIM TABS AUTO-RETRACT IN REVERSE BOAT EQUIPPED WITH DIGITAL SHIFT….…...

2. SMOOTH WATER CONDITIONS: TRANSITION - HOLE SHOT TO PLANING MODE…………..

3. ROUGH WATER HOLE SHOT……………………………………………………………………………………………….

4. ROUGH WATER CONDITIONS: TRANSITION - HOLE SHOT TO PLANING MODE…………….

5. OVERRIDING ROUGH WATER HOLE SHOT MODE…………………………………………………………….

C. PLANING MODE……………………………………………………………………………………………………………………..…

15 - 22

1. ROLL CORRECTION……………………………………………………………………………………………………………..

16 - 17

2. PITCH CORRECTION…………………………………………………………………………………………………………….

18 - 19

3. YAW LOCK OUT…………………………………………………………………………………………………..……………….

4. RAPID DECELERATION……………………………………………………………………………………………….……….

5. EXITING PLANING MODE…………………………………………………………………………………………….……….

III. AUTOMATIC SETTINGS………………………………………………………………………………………..……………………….

23 - 26

A. AUTO SETTING………………………………………………………………………………………………………………..……….

23 - 24

B. FAV 1, FAV 2, and HOLD SETTINGS…………………………………………………………………………………….

24 - 26

1. SAVING “FAV 1” and “FAV 2” HOME ROLL AND PITCH POSITIONS………………………………..

24 - 25

2. RESETTING “FAV 1” AND “FAV 2” HOME ROLL AND PITCH POSITIONS………………………..

3. SAVING “HOLD” HOME ROLL AND PITCH POSITIONS………………………………………………………

IV. MANUAL OPERATION MODES……………………………………………………………………………………………….

27 - 32

A. MANUAL MODE………………………………………………………………………………………………………………………..

27 - 29

1. EXITING MANUAL MODE………………………………………………………………………………………………………

B. LIMP HOME MODE…………………………………………………………………………………………………………………..

29 - 32

V. SYSTEM FAILURE WARNING MESSAGES…………………………………………………………………………

33 - 38

A. DATA LOSS FAILURE …………………………………………………………………………………………………………….

B. GPS DATA LOSS …………………………………………………………………………………………………………………….

C. ENGINE DATA LOSS………………………………………………………………………………………………………………

D. KEY PAD COMMUNICATION LOSS ……………………………………………………………………………………

E. REACQUIRED DATA LOSS ………………………………………………………………………………………………….

F. ACTUATOR OVER-AMPERAGE…………………………………………………………………………………………..

37 - 38

G. CONTROL BOX OUT OF OPERATIONAL TOLERANCE …………………………………………………

I. KEY PAD OVERVIEW

A. KEY PAD BUTTONS

The Auto Glide Key Pad has two (2) Bow Down and two (2) Bow Up buttons that provide manual control of the

trim tabs at any time. There are also four (4) Automatic Setting Buttons on the outer corners of the key pad that

enable you to select up to four different automatic Home Roll and Pitch positions that the Auto Glide will use to

level the boat.

DN DN

AUT

UP UP

“AUTO” AUTOMATIC

SETTING BUTTON

“FAV 1”

BUTTON

AUTOMATIC

SETTING “FAV 2”

BUTTON

AUTOMATIC

SETTING

PORT

BOW DOWN

BUTTON

PORT

BOW UP

BUTTON

STARBOARD

BOW DOWN

BUTTON

STARBOARD

BOW UP

BUTTON

“HOLD”

BUTTON

AUTOMATIC

SETTING

KEY PAD - BUTTON OVERVIEW

B. KEY PAD BUTTON LED INDICATORS

Each of the Key Pad Buttons also has a corresponding LED Indicator that illuminates to indicate that the button is

being activated (either manually or automatically).

DN DN

AUTO

UP UP

HORIZONTAL

CROSSHAIR

LED INDICATORS

VERTICAL

CROSSHAIR

LED INDICATORS

BOW DOWN BUTTON

LED INDICATORS

BOW UP BUTTON

LED INDICATORS

“AUTO” AUTOMATIC

SETTING LED

INDICATOR

“FAV 1”AUTOMATIC

SETTING LED

INDICATOR

“FAV 2”AUTOMATIC

SETTING LED

INDICATOR

“HOLD”AUTOMATIC

SETTING LED

INDICATOR

KEY PAD - LED INDICATOR OVERVIEW

C. CROSSHAIR LED INDICATORS

The Crosshair LED Indicators are constantly showing the boat’s CURRENT ROLL AND PITCH POSITIONS

compared to the HOME ROLL AND PITCH POSITION. As the boat rocks back and forth on the water, the Auto

Glide is constantly tracking the boat’s position and displaying it on the crosshairs. Roll and Pitch Positions are

illuminated independently of each other on the Horizontal and Vertical Crosshairs.

The Auto Glide is constantly measuring the boat’s CURRENT ROLL AND PITCH POSITIONS at the rate of 25

times per second. However, that information is dampened so that the Auto Glide does not overreact to every

small movement of the boat. You will most likely notice the dampening because the CURRENT ROLL AND

PITCH POSITIONS are displayed on the Key Pad slower than the boat is actually moving.

The following examples illustrate how the boat’s CURRENT ROLL AND PITCH POSITIONS are shown to you on

the Key Pad’s Crosshair LED Indicators:

EXAMPLE #1: THE BOAT CURRENT ROLL AND PITCH POSITIONS MATCH THE AUTO GLIDE’S

HOME ROLL AND PITCH DEFAULT POSITIONS:

EXAMPLE #2: THE CURRENT ROLL POSITION IS ROLLED TO PORT, BUT THE CURRENT PITCH

POSITION MATCHES THE AUTO GLIDE’S HOME PITCH DEFAULT POSITION.

EXAMPLE #3: THE CURRENT ROLL POSITION IS ROLLED TO STARBOARD AND THE CURRENT

PITCH POSITION IS ABOVE THE HOME PITCH DEFAULT POSITION.

II. AUTOMATIC OPERATIONAL MODES

There are three (3) AUTOMATIC OPERATIONAL MODES that the Auto Glide uses to make all of the automatic boat

control decisions. These AUTOMATIC OPERATIONAL MODES are:

A. IDLE MODE

B. HOLE SHOT MODE

C. PLANING MODE

These three AUTOMATIC OPERATIONAL MODES use the Engine and GPS CANBUS DATA plus the HOME ROLL

AND PITCH POSITIONS to decide how and when to move the trim tabs to correct the position of the boat.

A. IDLE MODE:

The primary objective of IDLE MODE is to limit the movement of the trim tabs during idle conditions which would

include situations such as maneuvering the boat within a marina or boat launch area.

1. ENTERING IDLE MODE: The Auto Glide will transition into IDLE MODE when the boat’s motor(s) is started

and the Auto Glide sees 400 RPMs or greater from the CANBUS data. The AUTO SETTING button will

illuminate on the Key Pad to indicate the Auto Glide is in an automatic mode.

The following illustrations outline the sequence of LED indicator flashes as the Auto Glide transitions into

IDLE MODE when you start the motor(s).

NOTE:

If it is the first time you have started your motor(s) since turning “ON” your battery switch, the Auto Glide

will auto-retract the trim tabs to ensure they are fully retracted. The Auto Glide will also auto-retract the

trim tabs if you were in MANUAL MODE the last time you turned OFF your motor(s).

Once the Auto Glide “wakes up”, it takes a few moments to verify that it is receiving all of the required ENGINE

and GPS DATA and that both HOME ROLL AND PITCH DEFAULT POSITIONS have been stored. It then

defaults to the “AUTO” AUTOMATIC SETTING and IDLE MODE.

2. EXITING IDLE MODE INTO HOLE SHOT MODE: The Auto Glide will not extend or retract the trim tabs while

you are in IDLE MODE. If you are maneuvering around the dock or boat launch area, the trim tabs remain

retracted until you EXIT IDLE MODE by:

§Going faster than 4 MPH:

4 MPH

HOLE SHOT MODE

OR GREATER

INITIATES

§Override IDLE MODE by pressing the currently selected AUTOMATIC SETTING BUTTON (i.e.

AUTO, FAV 1, FAV 2, HOLD):

B. HOLE SHOT MODE:

The objective of HOLE SHOT MODE is to provide the fastest and most efficient transition from HOLE SHOT to

ON PLANE by automatically deploying the trim tabs before acceleration and automatically retracting the trim tabs

as the boat reaches cruising speed and the CURRENT PITCH POSITION approaches the saved HOME PITCH

DEFAULT POSITION.

ENTERING HOLE SHOT MODE: Once the boat enters into HOLE SHOT MODE, the Auto Glide automatically

fully deploys the trim tabs in preparation for Hole Shot.

1. TRIM TABS AUTO-RETRACT IN REVERSE IF BOAT IS EQUIPPED WITH DIGITAL SHIFT

SYSTEM: If the boat has Mercury DTS Engine Shift or NMEA 2000 Engine Shift Systems, the Auto Glide will

retract the trim tabs when you shift your motor(s) into reverse. This only occurs while the Auto Glide is in

HOLE SHOT MODE. This feature is not available on boats that do not have Mercury DTS or NMEA 2000

Engine Shift data available on the CANBUS.

Andere Handbücher für Auto Glide

Inhaltsverzeichnis

Andere LENCO Bootsausrüstung Handbücher

LENCO

LENCO Auto Glide Bedienungsanleitung

Beliebte Bootsausrüstung Handbücher anderer Marken

Ideal Windlass

Ideal Windlass CWM Leitfaden

Access

Access BIMINI Bedienungsanleitung

Floe

Floe VSD 6000 Bedienungsanleitung

Faun

Faun C40 Trackway Bedienungsanleitung

Exalto

Exalto 240BS Bedienungsanleitung

Hobie

Hobie Mirage 360 Bedienungsanleitung

Dowco

Dowco V322 CC - 2019 Bedienungsanleitung

Humphree

Humphree HCS-5 Bedienungsanleitung

Vetus

Vetus BOW4512D Technisches Datenblatt

Dock Doctors

Dock Doctors SLIDING BOARDING STEP Bedienungsanleitung

Mastervolt

Mastervolt Mass Combi 12/2000-100 Original Betriebsanleitung

Zattini Group

Zattini Group bamar BOXTRON E14S Benutzerhandbuch

SeaView

SeaView PM5-FMD-8 Bedienungsanleitung

Vetus

Vetus HTANK Bedienungsanleitung

Grammer

Grammer AVENTO MSG 65/511 Betriebsanleitung

Furuno

Furuno TZTL12F Bedienungsanleitung

Harken

Harken 944 Bedienungsanleitung

ShoreLand'r

ShoreLand'r DUB 2314 Bedienungsanleitung