Note:
Please remove the plastic protective films from the camera lens and
PIR motion sensors before use.
Once you've prepared your camera by properly installing batteries
and a Micro SD card, you could simply take it outside, strap it to a
tree (or not-according to your application scenario), switch it ON and
leave. We highly recommend that you first spend some with this
manual so that you know a bit about setting up your camera.
The camera has three basic operational modes:
OFF mode: Power switch in the OFF position.
ON mode: Power switch in the ON position (LCD screen is off.)
SETUP mode: Power switch in the SETUP position (LCD screen
is on).
1. OFF MODE
The OFF mode is the "safe" mode when any actions must be
taken, e.g., replacing the Micro SD card or batteries, or
transporting the device. You will also use OFF mode (ON or
SETUP is available) if you connect the camera to a computer's
USB port later to download your photos/videos. And of course,
when you are storing or not using the camera, you will switch it to
OFF. Please note that in OFF mode the camera consumes little
power. It's a good idea to take the batteries out of the battery
compartment if the camera will not be used for an extended period
time.
2. ON MODE
After installing the batteries and Micro SD card, you can switch on
the camera. When the power switch is moved to the left position,
the camera will enter into ON (Live) mode. Once in the ON mode,
no manual controls are needed or possible (the control keys have
no effect). The camera will take photos or videos automatically as
it is programmed when the PIR sensors detect movement in
range.
Using the Camera
The OFF, ON, and SETUP Modes
- 7 -
