LevelOne MDU-2400FXC Bedienungsanleitung

-1-

MDU-2400FXC

4 Port 100Mbps SC Fiber Switch Module

MDU-2800TX

8 Port 10/100Mbps Fast Ethernet SwitchModule

MDU-2100SX

1000SX Gigabit Switch Module

Installation Guide

-2-

Introduction

MDU-2400FXC 4 Port 100Mbps SC Fiber Switch Module

There are two open slots (‘MODULE 1’ and ‘MODULE 2’) on the front panel of the Scalable

Ethernet Switch. The user canchoose to slide in up to two of the FX modules to increase the link

distance. This users guide describes the installation steps for the 4-Port 100Base-FX fiber

module. Also note that the module only works when incorporated with the base unit. For detailed

system level operation, please refer to the Users Manual.

MDU-2800TX 8Port 10/100Mbps Fast Ethernet Switch Module

There are two open slots (‘MODULE 1’ and ‘MODULE 2’) on the front panel of the Scalable

Ethernet Switch. The user can choose to slide in up to two of the modules to increase

10/100Mbps-port density. This users guide describes the installation steps for the 8-Port

100Base-TX module. Also note that the module only works when incorporated with the base

unit. For detailed system level operation, please refer to the Users Manual.

MDU-2100SX1000SX Gigabit Switch Module

There are two open slots (‘MODULE 1’ and ‘MODULE 2’) on the front panel of the Scalable

Ethernet Switch. The user can choose to slide in up to two of the modules to equip the system

with 1000Mbps-port capability. This users guide describes the installation steps of the 1-Port

1000Base-SX fiber module. Also note that the module only works when incorporated with the

base unit. For detailed system level operation, please refer to the Users Manual.

-3-

Installation

Please be sure the power of the system is down during the installation.Insertone ortwomodules

into the slots on the front panel of the switch (be sure the module is aligned within the guide-rails

and that the two fasteners on the front side of the module are tightened), as shown in the

following figure.

GSW-1600TXM with MDU-2400FXC

GSW-1600TXM with MDU-2800TX

GSW-1600TXM with MDU-2100SX

Note: For MDU-2100SX1000SX Gigabit Switch Module.The transmitter of the Fiber Optic

Transceiver is on the left-hand side (the one close to the Power LED) while the receiver is on the

right-hand side (the one close to the Link LED).

17 18 192021 22 23 24 100/10M

Full/Col

Link/Act

100/10M

Full/Col

Link/ActSystem

1Module1 1Module2

GSW-1600TXM 16 Port 10/100Mbps SNMP Switch

17 18 192021 22 23 24 100/10M

Full/Col

Link/Act

100/10M

Full/Col

Link/ActSystem

1Module1 1Module2

GSW-1600TXM 16 Port 10/100Mbps SNMP Switch

17 18 192021 22 23 24 100/10M

Full/Col

Link/Act

100/10M

Full/Col

Link/ActSystem

1Module1 1Module2

GSW-1600TXM 16 Port 10/100Mbps SNMP Switch

-4-

Status LEDs

MDU-2400FXC 4 Port 100Mbps SC Fiber Switch Module

Once the module(s) slides into the open slot(s) on the front panel of the switch, the LED

indicators for the module(s) will be shown in the LED Monitor area of the. The display includes

all the possible configurations. For instance, when the ‘MODULE 1’ slot is occupied, LED

columns 17 to 20 are used as indicators for the module. When the ‘MODULE 2’ slot is used,

LED columns 25 to 28 are the indicators. There are three LEDs for each port. Their definitions

are described as follows:

10/100Mbps LED

Off NotApplicable

Solid Green 100Mbps

Full/Col LED

Off Half Duplex operation (Default)

Solid Green Full Duplex operation

Blinking Amber Collisions detected for half Duplex operation.

Link/Act. LED

Off Port is link down.

Solid Green Port is link up and no traffic.

Blinking Green Port is link up and with traffic.

-5-

MDU-2800TX 8 Port 10/100Mbps Fast Ethernet Switch Module

Once the module(s) slides into the open slot(s) on the front panel of the switch, the LED

indicators for the module(s) will be shown in the LED Monitor area . The display includes all the

possible configurations. For instance, when the ‘MODULE 1’ slot is occupied, LED columns 17

to 24 are used as indicators for this module. When the ‘MODULE 2’ slot is used, LED

columns 25 to 32 are the indicators. There are three LEDs for each port. Their definitions that

described as follows:

10/100Mbps LED

Off 10Mbps (Default)

Solid Green 100Mbps

Full/Col LED

Off Half Duplex operation (Default)

Solid Green Full Duplex operation

Blinking Amber Collisions detected for half Duplex operation.

Link/Act. LED

Off Port is link down.

Solid Green Port is link up and no traffic.

Blinking Green Port is link up and with traffic.

-6-

MDU-2100SX 1000SX Gigabit Switch Module

Once the module(s) slides into the open slot(s) on the front panel of the switch, the LED

indicator for the module(s) will be shown on the module itself. Note also that, when the

‘MODULE 1’ slot is occupied, the port becomes Port 17 of the switch. When the ‘MODULE 2’

slot is used, the port becomes Port 25 of the switch. There are three LEDs for the 1000Mbps

port. Their definitions are described as follows:

Power LED

Off No power

Solid Green System is in operation.

Full/Col LED

Solid Green Full Duplex operation

Solid Yellow Half Duplex operation

Blinking Yellow Collisions detected for half Duplex operation.

Link/Act LED

Off Port is link down.

Solid Green Port is link up and no traffic.

Blinking Green Port is link up and with traffic.

-7-

Technical Specification

MDU-2400FXC 4 Port 100Mbps SC Fiber Switch Module

Standard

Interface

Environment

Dimension

EMI

IEEE802.3u, 100Base-FX

Fiber SC connector

Temperature:

Operating: 0°C to 40°C

Storage: -20°C to 70°C

Humidity:

Operating: 10%RH to 90%RH

Storage: 5%RH to 90%RH

145 x 116.8 x 25 mm (W x D x H)

5.7 x 4.6x 0.98 in

FCC, CE, VCCI Class A

MDU-2800TX 8 Port 10/100Mbps Fast Ethernet Switch Module

Standard

Interface

Environment

Dimension

EMI

IEEE802.3u, 100Base-TX

RJ-45 connector

Temperature:

Operating: 0°C to 40°C

Storage: -20°C to 70°C

Humidity:

Operating: 10%RH to 90%RH

Storage: 5%RH to 90%RH

145 x 116.8 x 25 mm (W x D x H)

5.7 x 4.6 x 0.98 in

FCC, CE, VCCI Class A

MDU-2100SX 1000SX Gigabit Switch Module

Standard

Interface

Environment

Dimension

EMI

IEEE802.3z, 1000Base-SX

Fiber SC connector

Temperature:

Operating: 0°C to 40°C

Storage: -20°C to 70°C

Humidity:

Operating: 10%RH to 90%RH

Storage: 5%RH to 90%RH

145 x 116.8 x 25 mm (W x D x H)

5.7 x 4.6 x 0.98 in

FCC, CE, VCCI Class A

Inhaltsverzeichnis

Andere LevelOne Netzwerk-Router Handbücher

LevelOne

LevelOne WBR-6022 Bedienungsanleitung

LevelOne

LevelOne FBR-1461 Bedienungsanleitung

LevelOne

LevelOne IFE-0501 Bedienungsanleitung

LevelOne

LevelOne FBR-1416 Bedienungsanleitung

LevelOne

LevelOne WBR-6600 Bedienungsanleitung

LevelOne

LevelOne GSW-0507 Bedienungsanleitung

LevelOne

LevelOne FBR-1700TX Bedienungsanleitung

LevelOne

LevelOne WAB-2000 Bedienungsanleitung

LevelOne

LevelOne DC-202 Bedienungsanleitung

LevelOne

LevelOne NetCon WBR-3408 Bedienungsanleitung

LevelOne

LevelOne WBR-6802 Bedienungsanleitung

LevelOne

LevelOne FRT-2101TX Bedienungsanleitung

LevelOne

LevelOne WBR-3405TX Bedienungsanleitung

LevelOne

LevelOne FSW-0508TX Bedienungsanleitung

LevelOne

LevelOne FSW-0511 Bedienungsanleitung

LevelOne

LevelOne PLI-2020 Bedienungsanleitung

LevelOne

LevelOne WAC-2000 Bedienungsanleitung

LevelOne

LevelOne WBR-3406TX Bedienungsanleitung

LevelOne

LevelOne FSW-2441TX Bedienungsanleitung

LevelOne

LevelOne GBR-4001 Bedienungsanleitung

LevelOne

LevelOne GSW-0807 Bedienungsanleitung

LevelOne

LevelOne FBR-1413TX Bedienungsanleitung

LevelOne

LevelOne WBR-6003 Bedienungsanleitung

LevelOne

LevelOne GSW-0507 Bedienungsanleitung

Beliebte Netzwerk-Router Handbücher anderer Marken

Allnet

Allnet ALL0333AU Bedienungsanleitung

HomeSeer

HomeSeer HT-SEL Bedienungsanleitung

Sercomm

Sercomm Genesis OC3505D Bedienungsanleitung

Billion

Billion BIPAC 5102 Series Bedienungsanleitung

TP-Link

TP-Link TD-8817 Bedienungsanleitung

Motorola

Motorola MR1900 Bedienungsanleitung

Digi

Digi IX14 Bedienungsanleitung

Cisco

Cisco NCS 540 Handbuch

XAVi

XAVi X8821e Bedienungsanleitung

BEC

BEC 6200WZL Bedienungsanleitung

MikroTik

MikroTik hAP ac3 Series Bedienungsanleitung

Korenix

Korenix JetNet 5428G Series Bedienungsanleitung

NETGEAR

NETGEAR FS526T - Switch Bedienungsanleitung

Korenix

Korenix JetNet 5710G Series Bedienungsanleitung

Automated Logic

Automated Logic ZN551 Betriebsanleitung

Cisco

Cisco ASR 1000 Series Bedienerhandbuch

EnGenius

EnGenius ESR-9710 Bedienungsanleitung

Cisco

Cisco 805 Series Bedienungs- und Sicherheitshinweise