light-for-me
4XPG Hand Torch
manual
light-for-me 4XPG Hand Torch:
- up to 1600 lumens
- 4 x XPG LEDs
-protection against LEDs’ overheating - when the microprocessor detects too high
temperature, it lowers the current flowing through LEDs
-protection against deep discharge of batteries - when the microprocess detects a critical
voltage, the torch flashes 5 times and then after a few minutes it switches off. Since this
moment, the fifth red diode will be flashing for one minute in series: 5 flashes every 10
seconds. This means the battery level is too low to switch the torch on.
-protection against reversed polarity - if by chance the batteries are placed the other way
round, it will not caused any damage to or reaction by the torch
4XPG Hand Torch can be powered by:
- 2 x 18650 Li-Ion batteries
or
- 2 x 26650 Li-Ion batteries
It is recommended to use high quality batteries of capacity at least 2600mAh. Burntime
depends on the quality, overall condition and charge level of the batteries used and
ambient temperature.
The batteries should be put into the backup’s body with the sign – (minus) to the head and
with the sign + (plus) to the inner part of the body - see photo below.
4XPG Hand Torch is equipped with protection against deep discharge of batteries so to get
the best possible burntime the batteries used should be unprotected. Recommended
batteries are given below.
4XPG Hand Torch is equipped with battery adaptors enabling the user to use either 18650
or 26650 batteries. Adaptors are already placed in the 4XPG body. To power the torch by
26650 Li-Ion battery type, simply remove the adaptors. If later the torch is to be powered
www.light-for-me.com
