2
User manual
LEDForce 18 RGBW
1.Safety instructions
- Every person involved with the installation, operation and maintenance of this device has to :
bequalied
follow the instructions of this manual
- CAUTION! Be careful with your operations. With a dangerous voltage you can suffer a dangerous electric
shock when touching the wires!
- This device has left our premises in absolutely perfect condition. In order to maintain this condition and
to ensure a safe operation, it is absolutely necessary for the user to follow the safety instructions and
warning notes written in this user manual.
- Important: Damages caused by the disregard of this user manual are not subject to warranty.
The distributor will not accept liability for any resulting defects or problems.
- Keep away from heaters and other heating sources!
-Ifthedevicehasbeenexposedtodrastictemperatureuctuation(e.g.aftertransportation),donotswitchit
on immediately. The arising condensation water might damage your device. Leave the device switched off
until it has reached room temperature.
- Make sure that the power-cord is never crimped or damaged by sharp edges. Check the device and
the power-cord from time to time.
-Iftheexternalexiblecableorcordofthisluminaireisdamaged,itshallbeexclusivelyreplacedby
themanufacturerorhisserviceagentorasimilarqualiedpersoninordertoavoidahazard.
- shields, lenses or ultraviolet screens shall be changed if they have become visibly damaged to such
an extent that their effectiveness is impaired, for example by cracks or deep scratches.
- Never let the power-cord come into contact with other cables! Handle the power-cord and all connections
with the mains with particular caution!
- Make sure that the available voltage is not higher than stated in this manual.
- Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle
the power-cord by the plug. Never pull out the plug by tugging the power-cord.
- During the initial start-up some smoke or smell may arise. This is a normal process and does not
necessarily mean that the device is defective.
- DANGER OF BURNING! Never touch the device during the operation! The housing heats up to the housing
temperature.
- Don't switch the device on and off in short intervals as this would reduce the lamp's life.
- HEALTH HAZARD! Never look directly into the light source, as sensitive persons may suffer an epileptic
shock(especiallymeantforepileptics)!
- Always disconnect from the mains, when the device is not in user or before cleaning it.
-Pleasenotethatdamagescausedbymanualmodicationsonthedeviceorunauthorizedoperation
byunqualiedpersonsarenotsubjecttowarranty.
- Keep away children and amateurs from the device!
- There are no serviceable parts inside the device. Maintenance and service operations are only to be
carriedoutbyauthorizeddealers.
2.Operation Instruction
1)ThesystemhasDMXonlinemodeandstand-alonemode.DMXonlinemodecanlinkupeachother
andiscontrolledbyDMXcontroller.Stand-alonehassomefunctions,suchasdimmer,changeprogram,
music active and so on.
2)WhenunderDMXmodeorMaster/slavemode,thesignalispresent.TheslaveLEDwillblinkfast.
The address will blink without signal.
3)IftheslavelinksupthemasterandalsoconnectswithDMXcontroller,themastercanidentify
automatically the data and also turn off the function of sending data from master. Under this mode,
theledislightless.TheslavereceivesthesignalfromDMXcontroller.
