Lightolier LYTECASTER 2000LVRE1 Bedienungsanleitung

Figure A

Figure B Figure C

Figure D Figure E

Figure F

Figure G Figure H

READ AND UNDERSTAND THESE INSTRUCTIONS

BEFORE INSTALLING LUMINAIRE.

This luminaire is intended for installation in accordance with the National Electrical Code and local regulations.

To assure full compliance with local codes and regulations, check with your local electrical inspector before

installation. To prevent electric shock, turn off electricity at main power supply before proceeding.

Retain these instructions for maintenance reference.

INSTALLATION PROCEDURE FOR: LYTECASTER® 2000LVRE1 LOW VOLTAGE REMODELER KIT

CAUTION: USE ONLY WITH REFLECTOR TRIMS PROVIDED BY LIGHTOLIER. USE OF OTHER MANUFACTURER’S TRIMS MAY VOID THE

UNDERWRITERS LABORATORIES LISTING AND COULD CONSTITUTE A FIRE HAZARD.

INSTRUCTION SHEET NO.

IS:2000LVRE1

A0607 Page 1 of 2

A COMPANY

631 Airport Road, Fall River, MA 02720

CAUTION: BEFORE INSTALLING FRAME-IN KIT AND REFLECTOR TRIM, READ ALL MARKINGS ON FRAME-IN KIT AND REFLECTOR TO

DETERMINE LAMP WATTAGE AND TYPE APPLICABLE FOR YOUR INSTALLATION.

1. CUT OPENING (Fig. A)

Use aperture sticker provided as a template to cut a hole in the ceiling. Cut to

outside edge of sticker.

* Lightolier also offers a hole cutter (HC-356) that can be purchased separately to

assist with quick, clean trim installations. In this case, follow the hole cutting

directions supplied with HC-356.

2. WIRE IN & PUSH THRU

Wire to SUPPLY LEADS. (For Cable, use built in CABLE CLAMP in J-BOX).

WHITE FIXTURE LEAD to NEUTRAL SUPPLY LEAD. BLACK FIXTURE LEAD to

HOT SUPPLY LEAD (120V). GREEN AND BARE FIXTURE LEAD WIRE TO

SUPPLY GROUND. Use wirenuts (local hardware item). Place all electrical

connections in J-Box. Attach J-BOX cover onto J-BOX. For flexible CONDUIT, use

90° connector (not supplied) or 3/8” SPRING CONNECTOR (provided). If 3/8”

SPRING CONNECTOR is used, place J-BOX and TRANSFORMER ASSEMBLY

onto ceiling, attach CONNECTOR to CONDUIT and push into one of the 7/8” dia.

knock out holes in J-BOX. Pull J-BOX and TRANSFORMER ASSEMBLY toward

ceiling opening (as shown in Figure B) and complete wiring.

3. ATTACH MOUNTING RING (Fig. D)

Push MOUNTING RING into opening until FLANGE sits against ceiling.

Slide MOUNTING STRAPS down to trap ceiling thickness and then bend up

to secure (Fig. E). Make sure “J-BOX” SLOT on REMODELER RING is in a

position that will ensure enough space above ceiling for J-BOX to sit flat

against ceiling.

4. ATTACH J-BOX (Fig. E)

Insert J-BOX MOUNTING STRAP between the ceiling material and MOUNTING RING and through the

“J-BOX” SLOT on the MOUNTING RING. Pull the STRAP until the J-BOX PLATE sits flat on the

ceiling with the feet over the edge of the ceiling thickness. Bend J-BOX PLATE MOUNTING STRAP

up to secure. Make sure J-BOX PLATE is securely attached to the ceiling and the J-BOX is in the

shown position.

5. SNAP-ON (Fig.G)

→

6. PUSH-UP (Fig. H)

SEE SEPARATE

REFLECTOR TRIM

INSTRUCTION

SHEETS

WARNING: (RISK OF FIRE) DO NOT INSTALL INSULATION WITHIN 3” OF FIXTURE SIDES OR WIRING COMPARTMENT, NOR ABOVE

FIXTURE IN SUCH A MANNER SO AS TO ENTRAP HEAT.

INSTALLATION PROCEDURE FOR:

Lytecaster® 2000LVRE1 Low Voltage Frame- In Kit

INSTRUCTION SHEET NO.

IS:2000LVRE1

A0607 Page 2 of 2

A COMPANY

631 Airport Road, Fall River, MA 02720

7. LAMPING (Fig. J)

1. Make sure that power is OFF when lamping or relamping. Remove LAMP RING

from SOCKET CUP by pulling straight down.

2. Insert LAMP (MR-16 bulb) between LAMP SPRINGS until face of bulb sits

firmly on GLASS LAMP GUARD (Figure J).

3. Attach SOCKET to bi-pin prongs on LAMP.

4. Insert LAMP RING with LAMP and GLASS LAMP GUARD back into SOCKET

CUP.

NOTE: 1. LOW VOLTAGE FIXTURES should be dimmed only with special

dimmers intended specifically for that purpose. Use Lightolier Lytemode,

Scenist, Crescendo VA, Neptune VA, Precision VA, Easyset VA, Sunrise VA,

Radiant VA or equivalent products by others or variable autotransformers or

electronic dimmers intended for use with low voltage fixtures. 2. Low voltage

fixtures may produce audible sound when used with dimmers, which may be

objectional in acoustically critical areas.

8. ADJUSTMENT (Fig. K)

1. For vertical adjustment, insert blade of screwdriver into the open slot of YOKE.

2. Using Screwdriver as a lever, tilt the entire LAMP HOLDER to the desired

angle.

3. For horizontal adjustment, rotate the LAMP HOLDER.

Inhaltsverzeichnis

Andere Lightolier Beleuchtungsausrüstung Handbücher

Lightolier

Lightolier Lighting Systems Baselyte-BSL18 Bedienungsanleitung

Lightolier

Lightolier PTS6-1 Bedienungsanleitung

Lightolier

Lightolier Calculite A-E Bedienungsanleitung

Lightolier

Lightolier 6" Cloud Bedienungsanleitung

Lightolier

Lightolier Pre-wired, compact fluorescent electronic... Bedienungsanleitung

Lightolier

Lightolier Calculite ProSpec PB3H3039 Bedienungsanleitung

Lightolier

Lightolier MBS2GPW1FT Bedienungsanleitung

Lightolier

Lightolier LYTEDROP FIXTURE Leitfaden

Lightolier

Lightolier ProSpec 37109 Bedienungsanleitung

Lightolier

Lightolier Calculite C12E28VN Bedienungsanleitung

Lightolier

Lightolier LP-21 Bedienungsanleitung

Lightolier

Lightolier 9033 Bedienungsanleitung

Lightolier

Lightolier Lytespan 6275B Bedienungsanleitung

Lightolier

Lightolier QVS2GPTLG232 Bedienungsanleitung

Lightolier

Lightolier Baselyte-BSL28 Bedienungsanleitung

Lightolier

Lightolier Lighting Systems Baselyte-BSL23 Bedienungsanleitung

Lightolier

Lightolier MIC100 Bedienungsanleitung

Lightolier

Lightolier RT6-2 Bedienungsanleitung

Lightolier

Lightolier FP02 Bedienungsanleitung

Lightolier

Lightolier Brisa FC28U Bedienungsanleitung

Lightolier

Lightolier Lytecaster 1102TM1 Bedienungsanleitung

Lightolier

Lightolier FW01 Bedienungsanleitung

Lightolier

Lightolier Calculite ProSpec PA1P3810 Bedienungsanleitung

Lightolier

Lightolier Calculite ProSpec PA4H3070 Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

Alien

Alien RG STAR Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Bedienungsanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung