Page 4 of 4
IDP104/IDW104 DMX OPTICAL ISOLATOR
Version 0.2 OWNERS MANUAL 04/21/2022
www.lightronics.com
Lightronics Inc. 509 Central Drive, Virginia Beach, VA 23454 757 486 3588
INSTALLATION
Diagrams in this manual show all signal and power
connections for both the portable and wall mount units.
POWER SUPPLY
The IDP104/IDW104 will operate using any external
power supply which can provide 12 - 24 Volts AC or
DC at 600 mA minimum. The size of the power input
connector on the unit is 2.1mm X 5.5mm. If an
external DC power supply is used, the center pin of the
connector MUST be the POSITIVE side of the supply.
The power supply normally provided with unit is
12VDC, 1 Amp.
OPERATION
Operation is automatic when the power supply and a
DMX input signal are connected. The front panel
contains a power indicator LED which is lighted when
power is applied. A "DMX VALID" LED indicator is
lighted when a DMX input signal is present.
MAINTENANCE
There are no user serviceable parts in the unit.
Internal service on the unit by other than Lightronics
authorized agents will void the warranty.
Dealer and Lightronics factory personnel can help you
with operation or maintenance problems. Please read
the applicable parts of this manual before calling for
assistance.
If service is required - contact the dealer from whom
you purchased the unit or contact Lightronics, Service
Dept., 509 Central Drive, Virginia Beach, VA 23454
TEL: (757) 486-3588.
WARRANTY INFORMATION AND
REGISTRATION – CLICK LINK BELOW
www.lightronics.com/warranty.html
