LiteOn WN6301MH Bedienungsanleitung

Ben J. Chen Page 1 10/19/2010

r’

’s

Ben J. Chen Page 2 10/19/2010

REGULATORY STATEMENTS

FCC Certification

The United States Federal Communication Commission (FCC) and the Canadian

Department of Communications have established certain rules governing the use of

electronic equipment.

Part15, Class B

This device complies with Part 15 of FCC rules. Operation is subject to the

following two conditions:

1) This device may not cause harmful interference, and

2) This device must accept any interference received, including interference

that may cause undesired operation. This equipment has been tested and found to

comply with the limits for a Class B digital device, pursuant to Part15 of the FCC

Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates uses and can radiate

radio frequency energy, and if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning

off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

Ben J. Chen Page 3 10/19/2010

Warning: Changes or modifications to this unit not expressly approved by

the party responsible for compliance could void the user authority to operate

the equipment.

1. This Transmitter must not be co-located or operating in conjunction with

any other antenna or transmitter.

2. For product available in the USA market, only channel 1~11 can be

operated. Selection of other channels is not possible.

IMPORTANT NOTE:

This module is intended for OEM integrator. The OEM integrator is still responsible

for the FCC compliance requirement of the end product, which integrates this module.

20cm minimum distance has to be able to be maintained between the antenna and the

users for the host this module is integrated into. Under such configuration, the FCC

radiation exposure limits set forth for an population/uncontrolled environment can be

satisfied.

Any changes or modifications not expressly approved by the manufacturer

could void the user's authority to operate this equipment.

USERS MANUAL OF THE END PRODUCT:

In the users manual of the end product, the end user has to be informed to keep at least

20cm separation with the antenna while this end product is installed and operated. The

end user has to be informed that the FCC radio-frequency exposure guidelines for an

uncontrolled environment can be satisfied. The end user has to also be informed that any

changes or modifications not expressly approved by the manufacturer could void the

user's authority to operate this equipment. If the size of the end product is smaller than

8x10cm, then additional FCC part 15.19 statement is required to be available in the user

manual: This device complies with Part 15 of FCC rules. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference and (2) this

device must accept any interference received, including interference that may cause

undesired operation.

Ben J. Chen Page 4 10/19/2010

This Class B digital apparatus complies with Canadian

ICES-003.

Cet appareil numérique de la classe B conforme á la norme NMB-003 du

Canada.

Operation is subject to the following two conditions: (1) this device may not

cause interference, and (2) this device must accept any interference, including

interference that may cause undesired operation of the device.

For product available in the USA/Canada market, only channel 1~11 can be

operated. Selection of other channels is not possible.

This device and its antenna(s) must not be co-located or operation in conjunction

with any other antenna or transmitter.

To reduce potential radio interference to other users, the antenna type and its

gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p)

is not more than that permitted for successful communication.

Ben J. Chen Page 5 10/19/2010

INTRODUCTION

The Marvell sd8686 Wirless LAN SDIO Adapter is a device that allows you connect

your computer to a wireless local area network (LAN). A wireless LAN allows your

system to use wireless Radio Frequency (RF) technology to transmit and receive data

without physically attaching to the network. The Wireless protocols that come with this

product ensure data security and isolation from interference generated by other radio

frequencies.

This card also allows you to take full advantage of your computer’s mobility with

access to real-time information and online services anytime and anywhere. In addition,

this device eliminates the bother of pulling cable through walls and under furniture. It

even allows you to place your system in locations where cabling is impossible.

Modifying and augmenting networks has never been so easy.

Wireless Network Options

The Peer-to-Peer Network

This network installation lets you set a small wireless workgroup easily and

quickly. Equipped with wireless PC Cards or wireless PCI, you can share files

and printers between each PC and laptop.

You can also use one computer as an Internet Server to connect to a wired global

network and share files and information with other computers via a wireless LAN.

Ben J. Chen Page 6 10/19/2010

The Access Point Network

The network installation allows you to share files, printers, and Internet access

much more conveniently. With Wireless LAN Cards, you can connect wireless

LAN to a wired global network via an Access Point.

SOFTWARE INSTALLATION

Install the device

1. Make sure the computer is turned off. Remove the expansion slot cover from the

computer.

2. Carefully slide the Marvell sd8686 Wirless LAN SDIO Adapter into the PCI-E

scoket. Push evenly and slowly and ensure it is properly seated.

3. After the device has been connected to your computer, turn on your computer.

Windows will detect the new hardware and then automatically copy all of the files

needed for networking.

Ben J. Chen Page 7 10/19/2010

Install the Driver & Utility

1. Exit all Windows programs. Insert the included CD-ROM into your computer. The

CD-ROM will run automatically.

2. Manually install driver from Device Manager.

HARDWARE INSTALLATION

To verify if the device exists in your computer and is enabled, go to Start 

Control Panel System (Hardware) Device Manager. Expand the

Network Adapters category. If the Marvell sd8686 Wirless LAN SDIO Adapter

is listed here, it means that your device is properly installed and enabled.

Ben J. Chen Page 8 10/19/2010

NETWORK CONNECTION

Once the device driver is well installed, a network setting described in the following

should be also established.

1. Click the Wireless icon to enable Windows Zero Configure.

2. Select theAP then click the Connect

Ben J. Chen Page 9 10/19/2010

3. Surfing the Internet after completing connection.

Inhaltsverzeichnis

Andere LiteOn Netzwerkkarte Handbücher

LiteOn

LiteOn Realtek RTL8191SE Bedienungsanleitung

Beliebte Netzwerkkarte Handbücher anderer Marken

FirstComm

FirstComm OBiWiFi5G Bedienungsanleitung

Sun Microsystems

Sun Microsystems Interface Adapter Bedienungsanleitung

TRENDnet

TRENDnet TU2-ETG Bedienungsanleitung

YASKAWA

YASKAWA SI-EN3 Bedienungsanleitung

Paradyne

Paradyne BitStorm 2600 IP DSLAM Bedienungsanleitung

Belkin

Belkin F5D7050 Bedienungsanleitung

3Com

3Com EtherLink 3C509B Bedienungsanleitung

TRENDnet

TRENDnet TEG-PCITX Bedienungsanleitung

Cisco

Cisco MC16E Bedienungsanleitung

Delta Electronics

Delta Electronics Braking Modules VFDB Series Bedienungsanleitung

TwinMOS

TwinMOS Booming Bedienungsanleitung

Dialogic

Dialogic Media Board DM/V1200BTEPEQ Bedienungsanleitung

Buffalo

Buffalo AirStation WLI-PCM-L11GP Bedienungsanleitung

National Instruments

National Instruments NI 9234 Bedienungsanleitung

Hama

Hama 49276 Bedienungsanleitung

Linksys

Linksys WCF54G - Wireless-G Compact Flash Card Bedienungsanleitung

Compaq

Compaq Wireless LAN 100 Bedienungsanleitung

Bose

Bose PowerMatch Dante Bedienungsanleitung