Instructions for use
6
Before using the appliance for the first time, remove the protective wrappings from the various parts of
the appliance and check that no parts are missing or damaged/broken that could affect the proper
functioning of the appliance.
1. Take the handle, open the battery cover, insert 2 AAA batteries (not included) and close the cover
(as shown in picture 1)
2. After assembly, insert the handle into the tube. Push it in until you hear a "click" (as shown in
picture 2)
3. To disassemble the handle if needed, pull the cable storage hook and pull the handle upwards out
of the tube (as shown in picture 3).
4. Press the button on the back of the main body and insert it into the unit. Make sure that the
locking tab clicks into place.
5. To remove the tube if needed, press the release button on the back of the main body and remove
it (as shown in image 4).
To fill the tank, you only need to use tap water. For very hard areas, deionized water is recommended.
1. Press the PU H button on the front of the unit.
2. Turn the tank cap.
3. Do not put more than the MAX level
4. Close the cap and replace the tank.
5. Make sure the tank is properly in place before plugging in the unit
Important: never use the steam cleaner without the microfiber cloth placed on the head or with an
empty tank.
Before use, it is preferable to sweep the floor.
Important: Always insure that the unit is unplugged prior to filling the water tank and before attaching
the micro-fiber cleaning pad.
1. Place the micro-fiber cleaning pad underneath the mop head. Make sure that the velcro are
facing up.
The carpet glider should also be positioned on the pad to allow easy gliding on this
type of floor covering.
2. Press the ON/OFF button. Once turned on a red light will appear. The cleaner takes 30 seconds
to heat up. Your steam cleaner is ready for use once the green light flashes around the ON/OFF
button.
3. To start the steam and begin cleaning, tilt the body of the cleaner towards you. The green button
will stop flashing and steam will begin to appear. You can select the steam level on the handle of
the appliance.
