LOGICDATA LogicS Bedienungsanleitung
Mounting Instructions for the LogicS
Motor Control
Step 1
Installation Material
LogicS motor control Mounting plate 4 Wood screws
12 x 3,5
Position the motor control with attached mounting plate where you want to install it. Mark the
edge of the mounting plate with a pencil.
Mounting Instructions for the LogicS
Motor Control
Step 2
Detach the mounting plate and install it by means of two wood screws at the marked position (drill
the holes beforehand!). Notice the v formation of the mounting plate (see picture).
Step 3
Slide the motor control onto the mounting plate.
Mounting Instructions for the LogicS
Motor Control
Step 4
Mark the drill holes on the frontside with a pencil.
Schritt 5
Remove the motor control and screw in the remaining two screws halfway at the marked position
(drill holes beforehand!).
Mounting Instructions for the LogicS
Motor Control
Step 6
(1) Attach the motor control again, (2) slide it onto the mounting plate (pay attention to the correct
fit of the mounting plate) and (3) fasten the screws on the frontside.
Mounting Instructions for the LogicS
Motor Control
Drill Template
To speed up the
installation you can
also use the drill
template printed on
this page to mark the
drill holes.
Inhaltsverzeichnis
Andere LOGICDATA Steuerungssystem Handbücher
LOGICDATA
LOGICDATA LogicS-2 Bedienungsanleitung
LOGICDATA
LOGICDATA IRR-3MAS-SET Bedienungsanleitung
LOGICDATA
LOGICDATA IRR-DDSET Bedienungsanleitung
LOGICDATA
LOGICDATA DYNAMIC MOTION Benutzerhandbuch
LOGICDATA
LOGICDATA DMIclassic Series Bedienungsanleitung
LOGICDATA
LOGICDATA LogicSP-2-1 Bedienungsanleitung
