4
Getting Started
Follow the steps below to prepare your digital wireless
converter for installation:
2Attach antennas to the antenna jacks on the
receiver and transmitter.
1Identify the transmitter and receiver.
Termination cables are labelled Connect to
Camera on the transmitter and Connect to
DVR on the receiver.
Once you have completed the steps above, determine
which of the following installation options is best suited
to your needs.
Standard Setup:
Extension Cable Setup:
Television Viewing Setup:
Your camera is connected directly to the
transmitter, and the receiver is connected directly
to the DVR.
See “Standard Setup” on page 6 for the
standard setup procedure.
An extension cable (not included) is used to
connect your camera to the transmitter, and the
receiver is connected directly to the DVR.
Use this setup if you want to install the transmitter
far away from the camera for better reception. For
example, if your camera is installed at the back of
a barn and the signal strength is better at the front
of the barn.
You can purchase extension cables from
www.lorextechnology.com.
See “Extension Cable Setup” on page 8 for
the extension cable setup procedure.
The camera is connected directly to the transmitter,
and the receiver is connected directly to a
television (not included).
See “Television Viewing Setup” on page 10 for
the television viewing setup procedure.
NOTE: Video and audio recording are not
available through television viewing setup.
