2.3 Select Wireless Group
Each time you press the button, The group switch. Only the same group transceivers can communi-
cate with each other.
NOTE: If you are sending or receiving radio signals, the rst press to view current group, then press
switch the group.
WIDMX mode supports 6 groups (FHSS, 1100 hops / sec)
1: RED ----------------------- Red
2: GREEN ----------------------- Green
3: BLUE ----------------------- Blue
4: RED + GREED ----------------------- Yellow
5: GREEN + BLUE ----------------------- Cyan
6: RED + BLUE ----------------------- Purple
GZ protocol supports 7 groups (Frequency Agile)
1: RED ----------------------- Red
2: GREEN ----------------------- Green
3: RED + GREED ----------------------- Yellow
4: BLUE ----------------------- Blue
5: RED + BLUE ----------------------- Purple
6: GREEN + BLUE ----------------------- Cyan
7: RED+GREED+BLUE -------------------- White
2.4 Restore factory settings
Long press (> 1S) release button atWIDMX or Guangzhou protocol operation mode, the system will
restore the factory settings and restart, then saw„red - green - blue“, then red, indicating that restore
factory settings success. The default group is red.
2.5 Connection and Delete Connection
In the W-DMX G3 or G4 mode press button can be connected to all powered receiver is not connected
within the coverage area. Long press (> 3S), see red then release will delete all receivers connected
to it within range. In the W-DMX receive mode, long press (> 3S), see white then release will remove
the receiver‘s current connection.
NOTE: in order to connect with the new transmitter only after deleting the old connection.
Manual | Wireless DMX Transceiver
