Luma 300 Series Bedienungsanleitung
300 Series Turret
HD Analog Surveillance Camera
Installation &
Operation
Manual
2
Luma 300 Series Turret Camera
Installation
Before you start, ensure that the device is in good
condition and all the assembly parts are included.
}Make sure that all equipment is powered off
during installation.
}Ensure the wall is strong enough to hold three
times the weight of the camera and the mount.
}If the mounting surface is cement, use the
included expansion screws to install the
camera. If mounting to a wood surface, use
self-tapping wood screws (not included) to
secure the camera.
}If the product does not function properly,
please contact technical support. Do
not disassemble the camera for repair or
maintenance.
3
Luma 300 Series Turret Camera
Wiring Advisory
We recommend installing with RG-59 or RG-6
cabling with two-wire power (either regular or
siamese). This provides better performance over
distance than using traditional category cable
with baluns.
For more details on the cameras or cables, see the
product page at SnapAV.com.
4
Luma 300 Series Turret Camera
Box Contents
}Camera
}Mounting bracket
}Self-adhesive mounting template
}3 x wall anchors with screws
}3mm hex wrench
Other Required Equipment
Aside from the contents of this box, you will need
}Phillips screwdriver
}Power source: 12V DC
5
Luma 300 Series Turret Camera
Overview
Before installing, familiarize yourself with the
parts of your camera.
Camera
Body
6
Luma 300 Series Turret Camera
Camera
Base
Cables
}The black BNC cable: 960H video connection.
}The gray BNC cable: HD-TVI connection.
}Standard gray cable: power.
}The thin, twin wires (black and white) are
used to select CVBS or HD-TVI signal.
7
Luma 300 Series Turret Camera
Prepare for Installation
1. Drill a cable hole and pilot holes for your
screws in the ceiling, using the supplied
template shown.
2. Select which BNC cable you are going to use.
Wrap the unused BNC head in electrical tape to
avoid cross-connection.
8
Luma 300 Series Turret Camera
3. If using CVBS, cross-connect the two thin wires
to activate the CVBS signal. Otherwise, wrap
the wires separately to avoid cross-connection.
4. Loosen the locking hex screw on the base and
remove it from the camera housing.
Locking
Hex Screw
9
Luma 300 Series Turret Camera
Install the Camera
5. Attach the base of the camera to the ceiling and
secure it with screws.
6. Route the cables through the cable hole. Note
that the base provides extra space between the
camera and the ceiling for wire management.
10
Luma 300 Series Turret Camera
7. Insert the camera
into the base,
making sure the
open area of the
housing is pointed
in the direction you
want the camera
to aim. Tighten
the locking hex
screw to secure the
camera in place.
8. Connect the power and video cables.
Andere Handbücher für 300 Series
1
Inhaltsverzeichnis
Andere Luma Sicherheitskamera Handbücher
Luma
Luma 300 Series Bedienungsanleitung
Luma
Luma 100 series Bedienungsanleitung
Luma
Luma 110 Series Bedienungsanleitung
Luma
Luma 700 Series Bedienungsanleitung
Luma
Luma 110 Series Bedienungsanleitung
Luma
Luma 300 Series Cube Bedienungsanleitung
Luma
Luma LUM-600-DOM-A Series Bedienungsanleitung
Luma
Luma Special Cube Service-Handbuch
