Luraco IFill 4 L0903A Bedienungsanleitung

iFill 4 Spa Control System

MODEL L0903A

MasterBox Control Keypad

When using electrical equipment, basic safety precautions should always be followed to reduce the risk

of fire, electric shock and injury. Safety precautions are as follows:

1. Read and follow all instructions before using the equipment

2. Keep the cord out of heavy traffic area. To avoid fire hazard NEVER put the cord under rugs or near heat

generating devices

3. Always turn off the equipment before servicing

4. Do not drop or insert any object into any openings

5. Do not operate any equipment with damaged parts

6. This system is for indoor use only

7. Do not attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will void the

warranty

8. As a condition of acceptability UL requires that this product be installed over a non-combustible surface; if

this product is installed over a combustible surface, a non-combustible layer must be installed between the

device and the surface

9. Any other use not recommended by the manufacturer may result in electrical shock or injury

After reading this owner’s guide, if you have any questions or comments, please call +1-817-633-1080 or contact our technical

support department at [email protected] or visit our website at www.luraco.com for more information

USER’S MANUAL

PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS

FEATURES and OPERATIONS

iFill 4 Features

•Automatic spa fill with intelligent and reliable level sensor

•Can also be used even with a disposable liner

•Time delay setting

•Dual switched outlets

•Dual continuous outlets

•Single drain pump controlled outlet with 3 minute timer

•Heavy duty water valve

•Can be operated in both automatic or manual modes

•Automatic shutdown for Jet and color light if water level in the basin is below the sensor

•Built-in 1 hour timer

•Audible overflow warning in manual fill mode

Installation Guide

I) Overall System Integration

Fig.1: Connection Diagram

ATTENTION:BACKFLOW PREVENTERS ARE REQUIRED FOR EVERY SPA CHAIR. THEY MUST BE INSTALLED ON BOTH HOT

AND COLD WATER LINES TO AVOID LOSING HOT WATER FROM ONE CHAIR TO THE OTHER.

II) System Installation

A capacitive sensor with advanced electronics and firmware are used to detect the water level. This

technology can also work with a disposable liner.

Fig. 2: Capacitive sensor installed on JET Housing Fig. 3: Input and Output Control Ports

Follow the steps below for the water level sensor installation

a) Connect the sensor cable to MasterBox port named “LEVEL SENSOR”, (Fig. 3)

b) Connect the Water Valve to MasterBox port named “WATER VALVE”, (Fig. 3). Note: The water valve

is unidirectional.

c) Connect the Control Keypad to MasterBox port named “KEYPAD”, (Fig. 3)

d) Connect power to the MasterBox (Note: The blue light on the back of MasterBox should turn on)

ATTENTION:BACKFLOW PREVENTERS ARE REQUIRED FOR EVERY SPA CHAIR. THEY MUST BE INSTALLED ON BOTH HOT

AND COLD WATER LINES TO AVOID LOSING HOT WATER FROM ONE CHAIR TO THE OTHER.

Sensor Delay Time Setting:

The sensor delay time can be adjusted by a knob located next to the blue light.

Depending on the knob position (Fig. 4), a valve shutoff delay time will be added after water reaches the

sensor. This delay allows the user to set the preferred water level in automatic fill mode.

Fig. 4: Time delay setting

III) How to operate the iFill 4 (Be sure that the faucet is open)

ATTENTION: IFILL 4 WILL RUN A SELF-CALIBRATION EVERY TIME THE SYSTEM IS POWERED UP. THIS

CALIBRATION REQUIRES THE TUB TO BE EMPTY (WITHOUT ANY WATER IN IT). BE SURE THAT THE TUB IS

EMPTY BEFORE SYSTEM IS PLUGGED TO POWER OUTLET.

- Pressing the iFill ( ) button will turn On/Off the Automatic-Fill

- Pressing the JET ( ) button will turn On/Off the JET and color light manually (1 Hr timer)

- Pressing the Valve ( ) button will turn On/Off the water manually (4 minute safety timer)

IV) How to reboot the iFill 4

Please follow the steps below

- Drain all water from the tub completely

- Unplug the power cord of the Masterbox

- Wait about 15 seconds and plug power cord back to power outlet

WARRANTY INFORMATION

One (1) YEAR LIMITED WARRANTY

1. This Warranty applies only to the original purchaser of this product.

2. This Warranty applies ONLY to repair or replacement of any supplied or manufactured parts of this product. The

warranty does not cover normal wear, coating, dropped or abused units.

3. Unless otherwise proscribed by law, LURACO shall not be liable for any personal injury, property or any incidental

or consequential damages of any kind resulting from malfunctions, defects, misuse, improper installation or

alteration of this product.

Attention: Any modification to the product will void the warranty

Important Instructions

If you need to send a unit to us for repair, please follow the steps below.

1. Carefully pack the item in its original carton or other suitable box to avoid damage in shipping.

2. Before packing your unit; be sure to enclose:

•Your name with full shipping address and telephone number

•A dated receipt to PROOF OF PURCHASE

•Include a detailed description of the problem you are having

THANK YOU FOR BUYING LURACO PRODUCTS

LURACO HEALTH & BEAUTY, LLC

1140 107TH STREET, ARLINGTON, TX 76011

TEL: +1-817-633-1080, FAX: +1-817-633-1085

WWW.LURACO.COM

Inhaltsverzeichnis

Andere Luraco Steuerungssystem Handbücher

Luraco

Luraco iFill L0903A Bedienungsanleitung

Beliebte Steuerungssystem Handbücher anderer Marken

Pentair Pool Products

Pentair Pool Products Compool Bedienungsanleitung

ComfortNET

ComfortNET CTK04 Bedienungsanleitung

Fireye

Fireye InSight II 95DSS3 Bedienungsanleitung

CAME

CAME G3000 Bedienungsanleitung

Idemia

Idemia MorphoAccess VP MD Bedienungsanleitung

Axis

Axis P1445-LE-3 Bedienungsanleitung

HEIDENHAIN

HEIDENHAIN TNC 150 B Bedienungsanleitung

CNC-Step

CNC-Step High-Z T-Series Bedienungsanleitung

Doosan

Doosan DVF Series Bedienungsanleitung

Honeywell

Honeywell KAP 140 Bedienungsanleitung

Honeywell

Honeywell vk41 series Bedienungsanleitung

AirBench

AirBench FPW Installationsanleitung

Cypress

Cypress HHR-3160 Bedienungsanleitung

CAME

CAME GLT40AOS Bedienungsanleitung

Zonex

Zonex GEN II -VVT Benutzerhandbuch

Altronics

Altronics K 9650 Bedienungsanleitung

micro-trak

micro-trak RoadMaster Bedienungsanleitung

micro-trak

micro-trak Calc-An-Acre II Bedienungsanleitung

Luraco iFill 4 L0903A Bedienungsanleitung

Beliebte Steuerungssystem Handbücher anderer Marken