LuxaFlex Roller blinds series Bedienungsanleitung
General information
The basic assembly instructions given in this booklet apply toall skylight products: roller blinds, Venetian
blinds, Plissé blinds,Duette® Shades and combined products (roller blinds withPlissé or Duette® and
Plissé with Duette®). Details of theassembly procedure can vary from one product to another asdescribed
below, however, it is important to read theinformation carefully before installing and using your skylight
Contents of Package
The package you have received should contain the following items :
• The Skylight product.
• 2 Cassette mounting brackets with 2 screws per bracket.
• 2 Packing profiles with 3 screws per profile (only for use with100 or 105° angle framed windows).
• 2 Side channels with 2 - 4 screws per channel depending onthe drop of your blind.
• 1 Side guiding sill bracket and cable locking ring (only suppliedfor wide Venetian blinds where a
centre support cable isrequired).
Please check that all the relevant components above have beensupplied.
Standard Fitting Procedure
1. Preparation for fitting
Remove the skylight from its packaging.
Warning:
- Keep the product stacked at this stage.
- Do not remove transport cord cleat(s) or retaining tapes yet.
2. Fitting the cassette mounting bracket
• Place the mounting brackets with the positioning
lip against thetop of the frame, at least 100 mm
from the edges [1].
• Screw the brackets into place [2].
• Now break off the positioning lips [3].
Skylight products
Assembly and operating instructions for
GB
www.Luxaflex.com
1 - 4
product and to follow the assembly instructions carefully.
Skylight Products
3. Mounting the packing profiles for 100 or 105° frames
(only if packing profiles supplied)
• Place the packing profile with the stop against
the frame [1].
• Screw the packing profiles into place [2].
4. Fitting the cassette
• Taking the cassette in both hands and push
it up into the mountingbrackets.
• The front lip at the top of the cassette should
now be sitting flushwith the frame.
(Gebruik bij rolgordijnen de meegeleverde
handschoenen om het risico van vlekken op
de stof te voorkomen).
5. Mounting the side channels
• Slide the channel under the cassette on each side [1].
Warning:
- Make sure that you locate the end guide of the
bottom bar intothe groove of the channels.
- Check that you have not trapped the cords
between the frame andthe channels.
• Position the channels against the frame [2].
6. Screwing the side channels onto the frame
Use enough screws to fill all the holes
predrilled in the side channels.
2 - 4Skylight Products
Assembly and Operating instructions
7. Removing transport cord cleat
• Remove the cords from the transport cleat.
• Remove the transport cleat and keep it in a
safe place, as it will beuseful if you need to
8. Mounting cord tension clips
Clip both cord tension clips into the holders at the
bottom of each sidechannel.
Warning: For Duette® and Plissé shades,
ensure that the cords are not twisted.
Assembly Options
9. Centre tension cable for venetian blinds
(Only supplied with wide Luxaflex® Venetian blinds)
dismantle the product.
• Place the side guiding sill bracket [1] so that
its opening is directlybelow the groove in the
bottom bar [2].
• Mark the position of the sill bracket, and screw into place.
and screw into place.
• Slide the locking ring onto the cable with its wider rim at the bottom,and pull the cable tight to
• Slide the locking ring up by approximately 20 mm from the bottomof the frame and tighten
• Pull the cable down and locate the locking ring under the sill bracket.
3 - 4
• Pull down the blind completely.
the grub screw to secure.
remove any slackness.
Skylight Products
Assembly and Operating instructions
Operation
1. Opening and closing.
Push the bottom bar up to open the product or down to close it.If the product is mounted in an
inaccessible position, it can be operatedwith the aid of a control rod (available as an optional extra).
Thecontrol rod can be located into the bottom bar, and allows the productto be opened and closed
with very little effort.
2. Adjusting the angle of the slat (venetians)
The angle of the slats can be adjusted by turning the knob on the cassette.If the blinds are mounted
at high level, this operation can alsobe carried out with the aid of the control rod.
3. Battery driven Tilt only (venetians)
If your venetian blind has been supplied with this option, the slatscan be tilted using the remote
control transmitter supplied.
Demounting
To demount the product completely, carry out the fitting instructionsin reverse order.
To summarise briefly, this means:
• Slide the bottom bar up as far as it will go.
• If you have retained the transport cleat, reattach this to the bottombar.
• Pull the cord tension clips out from the side channels and wind thecords round the transport cleat.
• Unscrew the side channels.
• Ease the cassette from its brackets with the aid of a flat bladedscrewdriver.
Cleaning
Roller blinds, Duette® and Plisse shades
The blinds should be cleaned regularly with a feather duster toprevent excessive build up of dust.
All fabrics with the exception of metalised fabrics can also be wipedwith a clean damp cloth.
A non-synthetic mild detergent may also be added if necessary toremove more stubborn dirt.
You should only rub or dab gently, to avoid damage to the fabric.
Venetian blinds
Luxaflex® Skylight Venetian blinds can be kept clean by regular use ofa feather duster. If necessary,
a damp cloth may used. Stubborn dirtcan be removed with the aid of water to which a gentle all purpose
cleaner has been added.
The above cleaning advice has been formulated with care.However we cannot accept responsibility for the results of your cleaning
activities.For further queries, please contact your Luxaflex® dealer.
4 - 4
• Unscrew the cassette mounting brackets.
Skylight Products
Assembly and Operating instructions
Dieses Handbuch passt für folgende Modelle
3
Inhaltsverzeichnis
Andere LuxaFlex Jalousie Handbücher
LuxaFlex
LuxaFlex Roman Series Bedienungsanleitung
LuxaFlex
LuxaFlex SimpleFit Plisse Bedienungsanleitung
LuxaFlex
LuxaFlex Timber Venetians Bedienungsanleitung
LuxaFlex
LuxaFlex Duette UltraGlide Leitfaden
LuxaFlex
LuxaFlex Twist Series Bedienungsanleitung
LuxaFlex
LuxaFlex LiteRise Bedienungsanleitung
LuxaFlex
LuxaFlex 2106/56 Bedienungsanleitung
LuxaFlex
LuxaFlex EasyRise Duette Stücklistenhandbuch
LuxaFlex
LuxaFlex Lumishade Bedienungsanleitung
LuxaFlex
LuxaFlex Country Woods Venetians Bedienungsanleitung
LuxaFlex
LuxaFlex Duette Honeycomb Shades Stücklistenhandbuch
LuxaFlex
LuxaFlex Twist Bedienungsanleitung
LuxaFlex
LuxaFlex RecessFix Bedienungsanleitung
LuxaFlex
LuxaFlex EVO MagnaTrack Bedienungsanleitung
LuxaFlex
LuxaFlex Silhouette Shades Bedienungsanleitung
LuxaFlex
LuxaFlex Venetian Series Benutzerhandbuch
LuxaFlex
LuxaFlex Super Nova Benutzerhandbuch
LuxaFlex
LuxaFlex Vertical Blinds Bedienungsanleitung
LuxaFlex
LuxaFlex M25T Bedienungsanleitung
LuxaFlex
LuxaFlex Silhouette Shadings Bedienungsanleitung
