M-Audio CT-14 Bedienungsanleitung

CT-14

™

1x4 Digital Audio

Coaxial S/PDIF

Thru Box

CT-14

MANUAL

CT-14

1x4 Digital Audio Coaxial S/PDIF Thru Box

Thank you for purchasing the CT-14, by M Audio. The CT-

14 accepts one S/PDIF digital audio signal via coaxial RCA

connector and duplicates it to four S/PDIF coaxial RCA

outputs, all on the rear of the CT-14. This allows you to

take the S/PDIF output of any digital audio source, such

as a DAT, CD player, digital mixer, etc., and send it

simultaneously to four digital audio targets that are

capable of receiving S/PDIF format signals. The CT-14

will flawlessly pass any coaxial S/PDIF signal having

100kHz or less sample rate and any data width. Its

active electronics assure that the integrity of your digital

signal is never compromised.

The setup example that follows shows what might be a

typical mixing scenario. The output of a digital mixer is

connected to the CT-14 input, while a DAT, computer-

based digital audio card (such as an M Audio “Delta DiO

2496” or “DiO 2448”), a CD recorder, and a D/A

Converter (to feed your monitors) are connected to the

CT-14 outputs. This setup allows the user to take one

mix output and simultaneously record to several mixdown

decks, saving hours of time and possible frustration.

To set up the CT-14 in your system, first make sure all of

your external devices are turned off. Then, using good-

quality 75-ohm coaxial digital cables with male connectors

(digital video cables meet this requirement) for best

results, follow this simple procedure:

1. With the CT-14 power button in the “out”(off) position, plug the

appropriate end of the supplied 9-Volt DC “wall-wart”power

adapter into your CT-14 and the other end into a wall socket or

power strip. The CT-14 power indicator LED should be off.

2. Take the output of your digital audio source device and plug it into

the CT-14 coaxial RCA input connector located on the rear of the

CT-14 .

3. Connect the CT-14’s coaxial RCA digital output connectors to the

inputs of your receiving or “target”digital audio devices. You may

want to connect the analog audio output of one of these target

devices to a sound system for monitoring purposes.

4. With all volumes turned down, turn on your source device.

5. Turn on the CT-14 by pressing its power button and allowing it to

latch in the “in”position. The power indicator LED will light on the

front of the CT-14 unit.

6. Turn on your target devices. Your CT-14 is now ready for use.

CT-14

Hook-Up

Diagram

NOTE: When any signal is present at the CT-14 input, the

“Signal Present” LED will light on the front of the unit. The

CT-14 is “format neutral” and does not analyze the incoming

signal. Therefore, although signal presence is detected by

the CT-14, it may not necessarily be a valid S/PDIF format

signal.

Other Typical uses of the CT-14

•Sending a single digital out to multiple digital effects units.

•Outputting to several D/A converters simultaneously.

•Using a single digital out to both monitor your system’s

output and master to DAT and/or CD at the same time.

•Multiplying the sends on your digital mixer

If you have any questions about your CT-14, please

contact our tech support in any of the following ways:

voice: (626) 445-8495

email: [email protected]

fax: (626) 445-7564

USA: 45 E. St. Joseph Street • Arcadia, CA 91006-2861 • Tel: (626) 445-2842

Fax: (626) 445-7564 • Web: http://www.midiman.net • Email: [email protected]

UK: Unit 22, Harrogate Business Park • Freemans Way • Harrogate • N Yorks • HG3 1DH • England

Tel: 44 1423 886692 • Fax: 44 1423 886693• Email: [email protected]

Germany: Kuhallmand 34 • D-74613 Ohringen • Germany • Tel: 49 7941 98 7000

Fax: 49 7941 98 70070 • Web: http://www.midiman.de • Email: [email protected]

AUDIO

Inhaltsverzeichnis

Andere M-Audio Medienkonverter Handbücher

M-Audio

M-Audio CO2 Bedienungsanleitung

M-Audio

M-Audio Mac Syncman Bedienungsanleitung

M-Audio

M-Audio Rack-mountable 8 x 8 USB 2.0 Interface with MX Core DSP Technology... Gebrauchsanweisung

M-Audio

M-Audio Firewire Audiophile Bedienungsanleitung

M-Audio

M-Audio MIDISport UNO Bedienungsanleitung

M-Audio

M-Audio MIDISPORT 1x1 Bedienungsanleitung

M-Audio

M-Audio MIDISPORT 2x2 Anniversary Edition Bedienungsanleitung

M-Audio

M-Audio Midisport 8x8 Bedienungsanleitung

M-Audio

M-Audio Flying Calf Bedienungsanleitung

M-Audio

M-Audio RAD-050503 Bedienungsanleitung

M-Audio

M-Audio Portman PC/P Bedienungsanleitung

M-Audio

M-Audio SUPER DAC 2496 Bedienungsanleitung

M-Audio

M-Audio Portman PC/S Bedienungsanleitung

M-Audio

M-Audio midiman Flying Calf D/A Bedienungsanleitung

M-Audio

M-Audio MICRO DAC 24/192 Bedienungsanleitung

M-Audio

M-Audio Flying Cow Bedienungsanleitung

M-Audio

M-Audio AIR 192|8 Bedienungsanleitung

M-Audio

M-Audio Portman 4x4 Bedienungsanleitung

M-Audio

M-Audio Biport 2x4 Bedienungsanleitung

M-Audio

M-Audio MIDISPORT 1x1 Bedienungsanleitung

M-Audio

M-Audio CO2 CO2 Bedienungsanleitung

M-Audio

M-Audio MM-401 Bedienungsanleitung

M-Audio

M-Audio Portman 2x4 Bedienungsanleitung

M-Audio

M-Audio CO3 Bedienungsanleitung

Beliebte Medienkonverter Handbücher anderer Marken

SoundTraxx

SoundTraxx Blunami BLU-2200 Bedienungsanleitung

SPROLINK

SPROLINK VA1 Bedienungsanleitung

Acclaim Lighting

Acclaim Lighting DDC-1-AC Bedienungsanleitung

Nikon

Nikon AF-S TC-20E III Bedienungsanleitung

Axis

Axis AXIS Q7406 Bedienungsanleitung

Omega

Omega TAC80B-J Bedienungsanleitung

Zoom

Zoom Thunderbolt TAC-2R Bedienungsanleitung

OST

OST iConverter 10/100M Bedienungsanleitung

Vertiv

Vertiv Netsure Bedienungsanleitung

birddog

birddog MINI Bedienungsanleitung

Roland

Roland GI-10 Bedienungsanleitung

Wallenstein

Wallenstein WX310 Bedienungsanleitung

Pace

Pace MSS 200-1 Bedienungsanleitung

Solar Converters

Solar Converters EQ 12/24-50 Bedienungsanleitung

CYP

CYP EL-7400V Bedienungsanleitung

TIE

TIE MIDI 1i1o Bedienungsanleitung

DCS

DCS Vivaldi Upsampler Bedienungsanleitung

Westermo

Westermo MCW-211 SERIES Bedienungsanleitung