Magnat Audio MONITOR SUPREME 1000 Planungshandbuch

MONITOR 1000, 990, 880, 220, 110,

CENTER 210

OWNER’S MANUAL/WARRANTY DOCUMENT

Abbildungen/Illustrations

Dear MAGNAT Customer,

Congratulations on your fine new loudspeakers and thank you very much for choosing

MAGNAT! You have made an excellent choice. The high-quality speakers produced by

MAGNAT are renowned all over the world.

Please study the instructions and information below carefully before using your new

loudspeakers.

GENERAL INFORMATION ABOUT CONNECTING YOUR MAGNAT MONITOR

LOUDSPEAKERS

Please always use a good quality loudspeaker connection cable from an audio dealer.

To prevent impairment of sound quality, we recommend cables with cross-sections of at

least 2.5 mm² for lengths up to 3 m and at least 4 mm² for lengths above 3 m.

Always turn off the amplifier or receiver before connecting or disconnecting loudspeaker

cables. Place the loudspeakers in their planned positions and cut the cables to the right

length. The cables for both channels should always be exactly the same length.

Strip 10 – 15 mm of insulation from the ends of the cables. Twist the ends – this is much

better than tinning them with solder – insert them in the terminals and tighten the terminal

screws firmly.

For good sound it is imperative that the cables must be connected in such a way that the

speakers are “in phase”. This means that the black negative terminals on the speakers

(-) must be connected to the negative (-) terminals on the amplifier, the red positive (+)

speaker terminals to the positive (+) amplifier terminals. To make this easier one wire of

most speaker cables is marked with a coloured strip or a ridge in the insulation.

Before switching on the system double-check all your connections and make sure that

the terminal screws are tight and that there are no short circuits caused by stray wire

filaments – this could cause serious damage to your amplifier!

THE MAGNAT MONITOR LOUDSPEAKERS IN STEREO MODE

In the ideal configuration the speakers and the listening position should form an

equilateral triangle. When the left and right speakers are the same distance from the

listening position their sound arrives at the same time, resulting in a harmonious, natural

music reproduction. (Fig. 1)

There should be a clear line of sight between the loudspeakers and the listening position.

Any sound-absorbing or reflecting obstacles in the path will distort the sound. When you

install the loudspeakers the following distances should be maintained:

Monitor tower loudspeakers:at least 20 cm away from the rear wall and at least 30 cm

from the side walls. This will prevent excessive emphasis of the bass range.

Monitor 220:shelf loudspeakers should also be as free-standing as possible, the

distance to the sides and rear to walls and items should be at least 10 cm, the tweeters

should be located at ear height.

Monitor 1000, 880 Spikes:you should use the supplied spikes when setting the

speakers up. This isolates them from the supporting surface, preventing unpleasant

resonance effects. The spikes are screwed into the threaded bushes on the bottom of

the speaker.

MAGNAT MONITOR LOUDSPEAKERS AS A FRONT OR REAR LOUD-SPEAKER

The front loudspeakers are positioned at ear height on the left and right as equidistant

from the television as possible. The rear loudspeakers are placed at ear height or a little

above on the left and right besides or better behind the listening position. (Fig. 2)

Monitor 110, 220:if possible, the cross-over frequency for the front and rear channels

should be adjusted to approximately 80 Hz in the AV receiver's set-up. Otherwise all the

recommendations made in the previous chapter also apply.

MAGNAT MONITOR CENTER 210

The Monitor Center 210 loudspeaker visually and acoustically ideally matches the other

Monitor models. The loudspeaker is placed immediately on or under the television set.

Otherwise please adhere to the general recommendations outlined in the previous

chapters.

MAGNAT MONITOR SUBWOOFERS

The active subwoofers of the Monitor line visually and acoustically ideally match the

loudspeakers in the Monitor series. Please refer to the separate operating instructions

supplied with this product.

CONNECTING TO AN AV RECEIVER

Figs. 3 and 4 show two different methods of connecting to AV receivers.

Fig. 3: AV receiver without subwoofer output.

Fig. 4: AV receiver with subwoofer output.

HOW TO AVOID DAMAGE TO YOUR VALUABLE SPEAKERS

All MAGNAT loudspeakers are designed and built for optimum sound reproduction with

the tone controls in the central position – i.e. with “linear” amplifier output. Turning up the

bass and treble controls too far delivers more power to the woofers and/or tweeters, and

at high volumes this can actually destroy the speaker units!

If the output of your amplifier is significantly higher than the rated power handling capacity

of your speakers extremely high volumes can physically destroy your speakers. This

doesn’t actually happen often but you should be aware that it is possible.

Weak amplifiers with low output ratings can actually be more dangerous for your

speakers at medium volumes because weak amplifiers may overload much faster than

powerful ones and this causes measurable and audible distortion, which is extremely

dangerous to your loudspeakers.

Always turn the volume down immediately as soon as you hear distortion! If you like

listening to loud music make sure that your amplifier can deliver at least as much power

as the speakers’ power-handling rating.

THE SOUND YOU CAN’T HEAR...

Amplifiers, tuners and CD players can all produce inaudible high-frequency signals – and

this doesn’t only apply to cheap products. If your tweeters fail at low or medium volumes

you should have a qualified technician check your system components for dangerous

inaudible signals.

SPECIFICATIONS

Monitor 1000 Monitor 990

Configuration: 3-way bass reflex 3-way

Power-handling capacity: 170 / 360 W 140 / 280 W

Impedance: 4 – 8 ohms 4 – 8 ohms

Frequency response: 19 – 35 000 Hz 20 – 35 000 Hz

Recommended amplifier output: 30 – 360 W 30 – 280 W

Efficiency (1W/1m): 92 dB 91 dB

Dimensions (WxHxD): 210 x 950 x 320 mm 145 x 850 x 300 mm

Accessory: Hard rubber spikes

Metal spikes

Monitor 880 Monitor 220

Configuration: 2-way bass reflex 2-way bass reflex

Power-handling capacity: 150 / 300 W 90 / 180 W

Impedance: 4 – 8 ohms 4 – 8 ohms

Frequency response: 22 – 35 000 Hz 34 – 35 000 Hz

Recommended amplifier output: 30 – 300 W 30 – 180 W

Efficiency (1W/1m): 92 dB 91 dB

Dimensions (WxHxD): 210 x 850 x 280 mm 210 x 355 x 280 mm

Accessory: Hard rubber spikes

Metal spikes

Monitor 110 Monitor Center 210

Configuration: 2-way 2-way double bass

Power-handling capacity: 50 / 100 W 75 / 150 W

Impedance: 4 – 8 ohms 4 – 8 ohms

Frequency response: 45 – 32 000 Hz 40 – 32 000 Hz

Recommended amplifier output: 20 – 100 W 20 – 150 W

Efficiency (1W/1m): 89 dB 90 dB

Dimensions (WxHxD): 145 x 235 x 200 mm 420 x 145 x 200 mm

Fig. 1

Fig. 2

FRONT L CENTER FRONT R

SPEAKER OUT

REAR L REAR R

-+-+

Center

Front L Front R

Rear RRear L

RECEIVER

to Subwoofer

High Level Input ->

SUBWOOFER (optional)

CROSSOVER LEVEL

POWER

AUTO

OFF MIN MAX

LINE IN

FROM RECEIVER TO SPEAKERS

L R L R

50 Hz 150

Fig. 3

Andere Handbücher für MONITOR SUPREME 1000

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Magnat Audio Sprecher Handbücher

Magnat Audio

Magnat Audio Sounddeck 700 Kurzanleitung

Magnat Audio

Magnat Audio MTT 990 Bedienungsanleitung

Magnat Audio

Magnat Audio PRIME ONE Kurzanleitung

Magnat Audio

Magnat Audio Cinema Ultra RD 200-THX Kurzanleitung

Magnat Audio

Magnat Audio VECTOR 208 TOWER Planungshandbuch

Magnat Audio

Magnat Audio ACTIVE REFLEX 300A II Series Planungshandbuch

Magnat Audio

Magnat Audio QUANTUM 657 Planungshandbuch

Magnat Audio

Magnat Audio NEEDLE 9000 ALU Bedienungsanleitung

Magnat Audio

Magnat Audio MONITOR ACTIVE 2000 Kurzanleitung

Magnat Audio

Magnat Audio INTERIOR ICP 262 Planungshandbuch

Magnat Audio

Magnat Audio 171 110 Kurzanleitung

Magnat Audio

Magnat Audio MULTIMEDIA 2100 DIGITAL Planungshandbuch

Magnat Audio

Magnat Audio STYLUS 5000 A Bedienungsanleitung

Magnat Audio

Magnat Audio WSB 25 Kurzanleitung

Magnat Audio

Magnat Audio SIGNATURE SUB 930A Planungshandbuch

Magnat Audio

Magnat Audio INTERIOR IC 51 Bedienungsanleitung

Magnat Audio

Magnat Audio QUANTUM 657 Bedienungsanleitung

Magnat Audio

Magnat Audio SOUNDDECK 100 Kurzanleitung

Magnat Audio

Magnat Audio CS 40 Kurzanleitung

Magnat Audio

Magnat Audio Sounddeck 400 BTX Bedienungsanleitung

Magnat Audio

Magnat Audio SIGNATURE 707 Planungshandbuch

Magnat Audio

Magnat Audio Vector 207 Planungshandbuch

Magnat Audio

Magnat Audio INTERIOR ICQ 82 Planungshandbuch

Magnat Audio

Magnat Audio Interior 5.1x Planungshandbuch

Beliebte Sprecher Handbücher anderer Marken

argon audio

argon audio IE20 Bedienungsanleitung

Denon

Denon SC-N7 Bedienungsanleitung

Gemline

Gemline Ace 3952 Bedienungsanleitung

Focal

Focal ON WALL 300 Bedienungsanleitung

HEADRUSH

HEADRUSH Maximus HRSP 5024 Bedienungsanleitung

SoundLogic

SoundLogic BCCS-6/6395 Bedienungsanleitung

Peavey

Peavey DTH 218 Bedienungsanleitung

Avantree

Avantree Pluto Air Bedienungsanleitung

Morel

Morel Integra Series INTEGRA OVATION 4 Bedienungsanleitung

Oppo

Oppo SONICA Bedienungsanleitung

Bose

Bose SoundLink Wireless Music System Bedienungsanleitung

Rocksteady

Rocksteady Stadium Bedienungsanleitung

Bowers & Wilkins

Bowers & Wilkins 4 Bedienungsanleitung

Sonance

Sonance SONOS OUTDOOR Series Bedienungsanleitung

Electro-Voice

Electro-Voice EVID FM4.2 Bedienungsanleitung

Pioneer

Pioneer XW-HTD630 Bedienungsanleitung

Onn

Onn BWA16AA002 Bedienungsanleitung

HP GL313AA - USB Speakers PC Multimedia Bedienungsanleitung