Martin Audio CS265P Bedienungsanleitung

Martin Audio – CS265P

CONTENTS (ENGLISH) Page No

1 INTRODUCTION 2

2 UNPACKING 2

3 FEATURES 2

4 MAINS CONNECTION 3

5 INSTALLATION 3

6 SIGNAL CONNECTIONS 4

7 WARRANTY 4

8 TECHNICAL SPECIFICATIONS 5

MARTIN AUDIO

LONDON

The Martin Experience

CONTENTS

GUIDES

1 INTRODUCTION

Thank you for purchasing a Martin Audio CS265P, a powered sub-bass

system designed to be used with the C115 and C516 Contractor Series

loudspeakers. It incorporates two powerful 6.5" (165mm) drive units in an

ultra-compact enclosure powered by an internal 150 watt amplifier.

2 UNPACKING

Each Martin Audio loudspeaker is built to the highest standard and

thoroughly inspected before it leaves the factory. After unpacking the

system, examine it carefully for any signs of transit damage and inform

your dealer if any such damage is found. It is suggested that you retain

the original packaging so that the system can be repacked at a future date

if necessary.

Please note that Martin Audio and its distributors cannot accept any

responsibility for damage to any returned product through the use of

non-approved packaging.

3 FEATURES

The CS265P has the following features:

150 watt bi-polar complementary output stage.

Differential balanced, summed, dual XLR inputs.

In-built limiters, to ensure the power module cannot clip.

Auto signal ramp-up on switch on. This ensures that the sub-bass

output is brought up to its pre-set level over a two second period.

Full protection against thermal overload.

Martin Audio – CS265P

ENGLISH

This equipment conforms to the requirements of the

EMC Directive 89/336/EEC, amended by 92/31/EEC

and 93/68/EEC and the requirements of the Low

Voltage Directive 73/23/EEC, amended by 93/68/EEC.

Standards Applied EMC Emission EN55103-1:1996

Immunity EN55103-2:1996

Electrical Safety EN60065:1998

CONTENTS

GUIDES

4 MAINS CONNECTION

The CS265P is supplied in either 220-240 volt or 100-120 volt versions.

Before connecting to the mains, ensure that the version you have is the

correct voltage.

The CS265P is fitted with an IEC 320 mains receptacle with integral fuse

holder. The 2 metre mains lead supplied is fitted with a 3-pin mains plug to

UK BS1363.

Should this mains plug be removed and another plug substituted, the cable

must be rewired as follows:

GREEN/YELLOW - EARTH

BROWN - LIVE

BLUE - NEUTRAL

WARNING:

The CS265P must always be operated with the mains safety earth

connected

Fuse rating for 220-240V version - 2 amp type T(L)

Fuse rating for 100-120V version - 4 amp type T(L)

Voltage tolerance on each version -5% +10%

5 INSTALLATION

The CS265P may be mounted in any orientation provided that there is

adequate airflow around the power module to assist cooling. It should not

be mounted in an environment where the ambient temperature can exceed

40 degrees C. This will result in thermal shutdown of the power amplifier

module. Operation will be automatically resumed once the temperature has

returned to a safe level.

Martin Audio – CS265P

ENGLISH

This equipment must be earthed.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

DO NOT EXPOSE TO RAIN

OR MOISTURE

It should not be necessary to remove any protective earth or signal cable

shield connections.

CONTENTS

GUIDES

6 SIGNAL CONNECTIONS

The CS265P is provided with two differential balanced inputs wired as

follows:

Pin 1 Selectable Ground Lift/Ground/Open Circuit (See note below)

Pin 2 Hot (+)

Pin 3 Cold (-)

Important Note: The CS265P is supplied from the factory with pin 1 in the

Ground Lift position, with a 47R resistor between Signal 0V and Ground.

Links on the printed circuit board can be changed to link Signal 0V direct to

ground or removed completely (open circuit).

WARNING:The unit must be disconnected from the mains supply before

attempting these changes.

The two connectors are fed to a summing circuit which combines the left and

right signals to a mono signal. For full-power output, both balanced inputs

must be fed with a signal of 0dB (0.775V rms) with the input sensitivity

control set fully clockwise. If only one mono signal is available, it can either

be Y-split and fed to both inputs or, if only one input connector is used, the

level of the input should be increased by +6dB (1.546V rms) to achieve the

same output.

7 WARRANTY

Martin Audio CS265P is warranted against manufacturing defects in materials

or craftsmanship over a period of 1 year from the date of original purchase.

During the warranty period Martin Audio will, at it's discretion, either repair or

replace products which prove to be defective provided that the product is

returned in its original packaging, shipping prepaid, to an authorised Martin

Audio service agent or distributor.

Martin Audio Ltd. cannot be held responsible for defects caused by

unauthorised modifications, improper use, negligence, exposure to inclement

weather conditions, act of God or accident, or any use of this product that is

not in accordance with the instructions provided by Martin Audio.

Martin Audio is not liable for consequential damages.

This warranty is exclusive and no other warranty is expressed or implied.

This warranty does not affect your statutory rights.

Martin Audio – CS265P

ENGLISH

CONTENTS

GUIDES

8 TECHNICAL SPECIFICATIONS

CS265P

TYPE Powered ultra-compact sub-bass system

FREQUENCY RESPONSE 60Hz-120Hz ±3dB

LOW FREQUENCY LIMIT -10dB @ 55Hz

DRIVERS 2 x 6.5" (165mm) long excursion drivers

with 1.5" (38mm) voice coils

POWER MODULE 150 watts RMS into 4 ohms

MAXIMUM SPL 113dB continuous, 119dB peak

ACTIVE FILTERS 30Hz high-pass, 150Hz low-pass

ENCLOSURE 44 litre (1.6 cu foot) particle board

construction

CONNECTORS IEC mains receptacle

2 x XLR inputs

DIMENSIONS (W) 215mm x (H) 456mm x (D) 605mm

(W) 8.5ins x (H) 18.0ins x (D) 23.8ins

WEIGHT 19kg (41.8lbs)

SHIPPING DIMENSIONS (W) 280mm x (H) 510mm x (D) 680mm

(W) 11ins x (H) 20.1ins x (D) 26.8ins

SHIPPING WEIGHT 19.5kg (43lbs)

Due to our policy of continuous improvement all specifications are subject

to change without notice.

Martin Audio – CS265P

ENGLISH

CONTENTS

GUIDES

Contractor Series CS265P

Century Point, Halifax Road, Cressex Business Park, High Wycombe, Buckinghamshire HP12 3SL, England.

Telephone: +44 (0)1494 535312 Facsimile: +44 (0)1494 438669

Web: www.martin-audio.com E-mail: [email protected]

The Martin Experience

MARTIN AUDIO

LONDON

Please Click here to

return to main menu

Please Click here to

visit our website

CONTENTS

GUIDES

MARTIN AUDIO

LONDON

The Martin Experience

ENGLISH

Contractor Series CS265P

User’s Guide

CONTENTS

GUIDES

Inhaltsverzeichnis

Andere Martin Audio Verstärker Handbücher

Martin Audio

Martin Audio MA2.0 - V1.1 Bedienungsanleitung

Martin Audio

Martin Audio MA2.0 - Bedienungsanleitung

Martin Audio

Martin Audio E1300 Bedienungsanleitung

Martin Audio

Martin Audio MA1400 Bedienungsanleitung

Martin Audio

Martin Audio MA18K Bedienungsanleitung

Martin Audio

Martin Audio MA1400 Bedienungsanleitung

Martin Audio

Martin Audio MA3.0 Bedienungsanleitung

Martin Audio

Martin Audio EM120 Bedienungsanleitung

Martin Audio

Martin Audio MA9.6K Bedienungsanleitung

Martin Audio

Martin Audio MA3.0 - V1.1 Bedienungsanleitung

Martin Audio

Martin Audio MA2.0 - Bedienungsanleitung

Martin Audio

Martin Audio E1300 Bedienungsanleitung

Martin Audio

Martin Audio M Bedienungsanleitung

Martin Audio

Martin Audio MA12K - 2007 Bedienungsanleitung

Martin Audio

Martin Audio MA4.2 Bedienungsanleitung

Martin Audio

Martin Audio VIA 5002 Bedienungsanleitung

Martin Audio

Martin Audio MA4.2s Bedienungsanleitung

Martin Audio

Martin Audio MA4.8Q Bedienungsanleitung

Martin Audio

Martin Audio MA5.2K Bedienungsanleitung

Martin Audio

Martin Audio MA2.0 - Bedienungsanleitung

Martin Audio

Martin Audio MA2.8Q - SCHEMA Bedienungsanleitung

Martin Audio

Martin Audio MA6.8Q Bedienungsanleitung

Martin Audio

Martin Audio ICT500 Bedienungsanleitung

Martin Audio

Martin Audio Ikon IK81 Bedienungsanleitung

Beliebte Verstärker Handbücher anderer Marken

ASTRO

ASTRO HVO V40 P Bedienungsanleitung

Marantz

Marantz SUPERSCOPE BLA-545 Montageanleitung

NAD

NAD CI980 Bedienungsanleitung

Technics

Technics SE-CH770 Bedienungsanleitung

Harman Kardon

Harman Kardon HK6300 Bedienungsanleitung

NAD

NAD T975 Bedienungsanleitung

McIntosh

McIntosh MA6850 Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix ENGLISH MUFF’N Bedienungsanleitung

Viatron

Viatron Autrix Bedienungsanleitung

GME

GME GA9800 Bedienungsanleitung

Atlas

Atlas CP700 Bedienungsanleitung

Roland

Roland KC-1000 Bedienungsanleitung

Pyle

Pyle PFMRA350BW Bedienungsanleitung

Advantage

Advantage S-250 Bedienungsanleitung

IRT Electronics

IRT Electronics DVA-3007 Bedienungsanleitung

Dimavery

Dimavery BA-100 Series Bedienungsanleitung

Sony

Sony XM-S400D Bedienungsanleitung

Schertler

Schertler ROY X Bedienungsanleitung