MASSEY FERGUSON GC1715 Bedienungsanleitung

Massey Ferguson GC1705 ROPS Cab

* Shown with optional equipment *

Please note: Cab is shown in photo with optional accessories.

www.tektite.ca

Massey Ferguson GC1705 ROPS Cab

This ROPS cab is designed and built to fit the Massey Ferguson GC1705 and GC1715 tractor.

Designed and Built by:

Tektite Manufacturing Inc:

427 Buffalo Street

P.O. Box 639

Winkler, MB

R6W 4A8

Canada

PH: 204-331-3463

Fax: 204-331-4159

[email protected]

www.tektite.ca

One year standard product warranty provided by Tektite.

June 2021© Massey GC1705 ROPS Cab Installation Manual

DO NOT PROCEED FURTHER UNTIL YOU HAVE READ THE INFORMATION BELOW

1) Always wear personal protective equipment

2) A minimum of two people is necessary to safely install the cab

3) This ROPS cab is heavy. A lift assist device such as an overhead

hoist or high lift forklift is required.

4) Ensure your work area is well ventilated. The installation

requires the starting of the tractor which will produce

dangerous carbon monoxide fumes.

5) Read through the entire installation manual first.

6) Follow the installation instructions in order.

7) Reading the operators manual prior to using the ROPS cab.

Tektite Manufacturing Incorporated thanks you for purchasing a Massey Ferguson GC1705

ROPS cab! Tektite has worked very hard to design and build this ROPS product and we hope

that it provides you with many years of ROPS protection.

Tektite’s ROPS products are designed to provide safe and dependable service during operation

when they are properly maintained according to the instructions. Please read this installation

manual carefully before installing and using this ROPS product.

The photos/illustrations provided in this manual may not provide all the detail needed, and are

for reference only.

All directions provided are from the reference point of the tractor seat facing the steering

wheel. All left and right references are from this view point.

For reference, please fill in the information below. This will assist your dealer in providing

service for this ROPS. It is advisable that this information be provided to your insurance

company as well in the event that the tractor is lost or damaged.

Vehicle Model: _________________________________________________________

ROPS Serial Number: ___________________________________________________

Date of Purchase: _______________________________________________________

Dealer Name: ___________________________________________________________

June 2021© Massey GC1705 ROPS Cab Installation Manual

Parts List Standard Cab:

Description

Qty

Step Bolt, 1/4" x 1", MB

Flange Bolt, 1/4" x 3/4", YD

Flange Nut, ¼”, YD

Floormat, Main Platform

Fir Tree Fasteners

Under-seat upholstery

Front Mounting Brackets

L&R

Rear Mounting Brackets (Installed onto cab)

Bolt, Hex, 5/8” x 3”, Gr. 8, YD

Washer, Flat, ¼” thick

Nut, Flange, 5/8”, Gr. 8, YD

Bolt, Hex, ½” x 4 1/2”, Gr. 8

Bolt, Hex, ½” x 1 ½”, YD, Gr. 8

Nut, Flange, ½”, YD, Gr. 8

Fuel Hose, 90 degree (3" cut off tractor side) installed on cab w/fuel fill weldment

Wire Loop, 1/4”

Bolt, Flange, M12 x 35, Gr. 10.9, Yellow (NO LOADER ONLY)

No Loader Bracket

L&R

Parts List Water Heater Kit:

Description

Qty

Hose Clamps, HS-6

Zip Ties

June 2021© Massey GC1705 ROPS Cab Installation Manual

Standard Cab Installation Instructions:

1. Disconnect rear flasher light harness and remove two-post ROPS from machine. Save

fasteners to re-use later.

2.Remove the seat and seat tracks from the tractor.

3.Take the provided under-seat upholstery and position it in the area under the seat. Glue

down the outer edges of the upholstery onto the tractor sheet-metal.

4. Take the left front bracket and position it on the two holes in the loader sub-frame. Bolt into

place with the provided ½” x 1 ½” bolts and flange nuts. The gusset support on the bracket will

be at the front of the bracket when installed (arrow location).

June 2021© Massey GC1705 ROPS Cab Installation Manual

5. Take the right front bracket and position it on the two holes in the loader sub-frame. Bolt

into place with the provided ½” x 1 ½” bolts and flange nuts. The gusset support on the bracket

will be at the front of the bracket when installed (arrow location).

** If tractor is equipped without front end loader, use the provided no loader bracket and M12

x 35 flange bolts. Position left front bracket against tractor bell housing where 7 fastener

pattern is, around mid-mower mount. Loosely fasten into place with provided M12 hardware.

Repeat for the RIGHT side.

June 2021© Massey GC1705 ROPS Cab Installation Manual

6. Take the left rear bracket and put into the pocket where the 2-post ROPS was mounted. The

cab mount plate should be facing forward when installed. Re-use the factory fasteners.

7. Take the right rear bracket and put into the pocket where the 2-post ROPS was mounted.

The cab mount plate should be facing forward when installed. Re-use the factory fasteners.

June 2021© Massey GC1705 ROPS Cab Installation Manual

The quick-attach pin for the D95 loader needs to be modified and reversed. Starting on the

left side, remove the cotter pin and pull pin out. Flatten the one side of the pin down so that

a minimal space is used. Insert pin from the inside and push out. Re-install cotter pin.

Repeat for the right side as well.

June 2021© Massey GC1705 ROPS Cab Installation Manual

8.Return to the cab to install lift brackets next. To remove the gas shock on the left cab door,

slide a flat screwdriver underneath the small clip on the end cap that must be pulled UP order

to pop the shock off the ball stud. The shock will release very easily when this is accomplished.

Lift the door assembly straight up and off the cab and put aside for now. Remove right door as

well. Un-bolt and remove both under-hood shields from cabs.

9. Take one of the provided cab lift bolts, a ½” x 4 ½”hex bolt, and bolt to the tab in the top

upper corner of the door opening; weld nut is located behind the tab. Repeat for the other

side.

June 2021© Massey GC1705 ROPS Cab Installation Manual

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere MASSEY FERGUSON Traktor Handbücher

MASSEY FERGUSON

MASSEY FERGUSON MF35 Bedienungsanleitung

MASSEY FERGUSON

MASSEY FERGUSON MF 5600 Series Bedienungsanleitung

MASSEY FERGUSON

MASSEY FERGUSON 4400 BROCHURE 74-101 Bedienungsanleitung

MASSEY FERGUSON

MASSEY FERGUSON 8650 Bedienungsanleitung

MASSEY FERGUSON

MASSEY FERGUSON MF 565 Handbuch

MASSEY FERGUSON

MASSEY FERGUSON MF4200 Bedienungsanleitung

MASSEY FERGUSON

MASSEY FERGUSON 1531 Bedienungsanleitung

MASSEY FERGUSON

MASSEY FERGUSON MF2400 Series Bedienungsanleitung

MASSEY FERGUSON

MASSEY FERGUSON 410 Handbuch

MASSEY FERGUSON

MASSEY FERGUSON MF240 Installationsanleitung

MASSEY FERGUSON

MASSEY FERGUSON MF 3700 Series Bedienungsanleitung

MASSEY FERGUSON

MASSEY FERGUSON 5400 BROCHURE 125-145 Bedienungsanleitung

MASSEY FERGUSON

MASSEY FERGUSON MF230 Installationsanleitung

MASSEY FERGUSON

MASSEY FERGUSON 6100 Series Bedienungsanleitung

MASSEY FERGUSON

MASSEY FERGUSON MF 3600 Series Bedienungsanleitung

MASSEY FERGUSON

MASSEY FERGUSON 1500 - BROCHURE 19-25 Bedienungsanleitung

MASSEY FERGUSON

MASSEY FERGUSON 2800 Series Bedienungsanleitung

MASSEY FERGUSON

MASSEY FERGUSON 5400 Series Bedienungsanleitung

MASSEY FERGUSON

MASSEY FERGUSON MF 5700 Bedienungsanleitung

MASSEY FERGUSON

MASSEY FERGUSON MF2210 Bedienungsanleitung

MASSEY FERGUSON

MASSEY FERGUSON 6400 BROCHURE 100-170 Bedienungsanleitung

MASSEY FERGUSON

MASSEY FERGUSON 1500 BROCHURE 19.5-46 Bedienungsanleitung

MASSEY FERGUSON

MASSEY FERGUSON 2418 Series Bedienungsanleitung

MASSEY FERGUSON

MASSEY FERGUSON 6400 BROCHURE 175-240 Bedienungsanleitung

Beliebte Traktor Handbücher anderer Marken

Ariens

Ariens 936051 Bedienungsanleitung

MacDon

MacDon M150 Bedienungsanleitung

Belarus

Belarus 3522.5 Bedienungsanleitung

CARRARO

CARRARO Vigneto Bedienungsanleitung

Cub Cadet

Cub Cadet 3208 Bedienungsanleitung

GREMO

GREMO 1250F Gebrauchsanweisung

HATTAT

HATTAT A90 Bedienungsanleitung

Kubota

Kubota WSM STV32 Gebrauchsanweisung

Kubota

Kubota M108DC Bedienungsanleitung

AL-KO

AL-KO Heritage RS 14/82 Bedienungsanleitung

Webb

Webb WE1742SD Bedienungsanleitung

MacDon

MacDon 9250 Bedienungsanleitung

Toro

Toro 03200 Reelmaster 3100-D Bedienungsanleitung

Kubota

Kubota T1880 Bedienungsanleitung

Iseki

Iseki TXG23 Bedienungsanleitung

Toro

Toro 25429 Bedienungsanleitung

New Holland

New Holland T4.80V Bedienungsanleitung

Gravely

Gravely D Bedienungsanleitung