McLelland PLA2DI Bedienungsanleitung

PLA2DI

OWNERS MANUAL

POWER AMPLIFIER

240W

* Two Channels Model – 120W RMS/Per

Channel

* Slot card for Dante interface receiver

(DSC02).

* Stereo into 4-8 Ohm loads.

* Bridged mode 240W output for 70V or

100V (Direct Drive)

* Power down after ~15 minutes of no signal

and com ply with Energy Star Power

consumption limits of < 0.5W in standby.

* RED LED (Front Panel) to indicated Standby

mode is active.

* Terminal Block analog audio inputs.

* Selection for Power-Up mode.

* Switch for High Pass Filter.

* Natural cooling without Fan.

* TRIGGER could be external remoting

ON/OFF.

* Short circuit protection.

* Overheating protection.

* Optional accessory card slot for Dante

Receiver.

FEATURE

REAR PANEL FEATURES

1 7 8

25 3 6 9

Power On Selection

1. ON : The unit always Power ON, and will not go to Standby mode.

2. AUTO : The unit goes to Standby mode after 15 minutes of no signal sensing.

3. TRIGGER : The unit only power on by providing 12VDC at Trigger In(Rear Panel).

4. LED : GREEN indicates Power On. RED indicates Standby mode.

FRONT PANEL FEATURES

1 2 3 4

Frequency Response

Signal to Noise

Input Sensitivity

Gain Value

Input Impedance

Maximum Input Level

Trigger In/Out

TECHNICAL SPECIFICATIONS

Stereo Mode (all channels driven)

120W x 2, 8 Ω(31 V) RMS output (steady state), per channel @ < 1 % THD+N

120W x 2, 4 Ω(22 V) RMS output (steady state), per channel @ < 1 % THD+N

20 Hz - 20 kHz, +/- 2 dB @ 4ΩLoad

>90dB @ 1W(20 Hz - 20 kHz)

1.0V (+2.2dBu) @ Max Output 4Ω

25 dB @ 4Ω

>10k, Balanced.

12.3 V (+24 dBu)

DC 12V

Bridged Outputs For 70V/100V (Switch at “HIZ” position)

240W, 70V @ < 1 % THD+N 240W, 100V @ < 1 % THD+N

High Pass Filter

Input Connector

Trigger Connectors

Output Connectors

Dimensions

Net Weight

Power Requirements

80 Hz(±2dB)

5 pin Euro terminal

3.5 mm Jacks

4 pin Euro terminal (4Ω/8Ω) 2 pin Euro terminal (70V/100V)

214mm(W) x 249.8mm(D) x 44mm(H)

1.94 Kg

100 - 240 VAC, 50 - 60 Hz, 350W

1. INPUT: DSC02 Dante Interface receiver,

connecting with Dante network switch.

The network LED will illuminate yellow when

the unit is connected to the Dante network.

The network LED will illuminate green /

blink when the unit has an IP address and is

communicating to the Dante network.

Note: Dante receiver will need the power

from the switch with PoE function..

Note: In AUTO mode, when receiving the

signal from Dante network, the amplifier will

be triggered ON.

2. LEVEL : Adjust the level of output.

3. HPF: High Pass Filter (80Hz)

4. TRIGGER IN : Apply 12VDC to this

connector to active the unit.

5. TRIGGER OUT : Provide 12VDC to

trigger another device.

6. OUTPUT SELECT SWITCH :

4Ohm/8Ohm and HIZ for 70V/100V.

7. SPEAKER : Connect with 4 Ohm or

8 Ohm speakers.

8. 70V/100V: Connect with

Constant-Voltage speakers directly.

9. AC INPUT

DANTE AUDIO INTERFACE

2x2 audio channels

I2S digital audio format

16, 24 or 32-bit audio samples (per device or

per channel)

44.1 KHz, 48KHz, 88.2KHz and 96KHz sample

rates

Power supply: PoE, 52V 36 mA

DANTE CONTROLLER

PLA2Di is built in Dante interface and

compatible with the software “Dante

Controller”.

The software “Dante Controller” is free to

download from the company of Audinate

(the owner of Dante technology). To install

the software on the computer, please visit the

link:

https://www.audinate.com/products/software

/dante-controller

And the “User Guide” of “Dante Controller” is

available on the Audinate websit:

https://www.audinate.com/resources/technic

al-documentation

The tables below list the minimum system

specifications for the computer to use Dante

Controller :

Component Minimum Requirement

Processor GHz or better

Memory 512 Mbytes RAM

Network Standard Ethernet network

interface (100Mbps or Gigabit) or wireless

LAN (Wi-Fi) interface

Operating System

Windows 7 (SP1 and above), 8.1 and 10

NOTE: Both UTF-8 and Unicode are

supported EXCEPT for host or device names;

the DNS standard does not support Unicode

for these

Mac OS X 10.11.6, 10.12.6 and 10.13

NOTE: Intel architecture only; PPC

architecture is not supported

NETWORK INTERFACE

Standard 100Mbps Ethernet

RMII Ethernet interface with MDIO

Hardware time-stamping, supporting

sample-accurate playback

Transmit flows: 2 (unicast or multicast)

Receive flows: 2 (unicast or multicast)

Latency from 2ms

CONNECTION DIAGRAMCONNECTION DIAGRAM

Stereo mode (4 Ω / 8 Ω)

Bridged mode (HIZ 70V / 100V)

Set to HIZ

Determine 70V or 100V

Set to 4Ω/ 8 Ω

Inhaltsverzeichnis

Andere McLelland Verstärker Handbücher

McLelland

McLelland PLA2 Bedienungsanleitung

McLelland

McLelland Power Pro 300 Bedienungsanleitung

McLelland

McLelland AMP-235 Bedienungsanleitung

McLelland

McLelland BP-1 Bedienungsanleitung

McLelland

McLelland McLelland D20BR Bedienungsanleitung

McLelland

McLelland PLA2FX Bedienungsanleitung

McLelland

McLelland HPD-1500 Bedienungsanleitung

McLelland

McLelland CA1250 Bedienungsanleitung

McLelland

McLelland MAP-1200EW Bedienungsanleitung

McLelland

McLelland AMP-D25MC Bedienungsanleitung

McLelland

McLelland MAP 1200 Bedienungsanleitung

McLelland

McLelland HP1200 Bedienungsanleitung

McLelland

McLelland MAP 1200HD Bedienungsanleitung

McLelland

McLelland MAP1200WD Bedienungsanleitung

McLelland

McLelland AVD-800P Bedienungsanleitung

McLelland

McLelland AVD-800P Bedienungsanleitung

McLelland

McLelland PR-150 Bedienungsanleitung

Beliebte Verstärker Handbücher anderer Marken

ASTRO

ASTRO HVO V40 P Bedienungsanleitung

Marantz

Marantz SUPERSCOPE BLA-545 Montageanleitung

NAD

NAD CI980 Bedienungsanleitung

Technics

Technics SE-CH770 Bedienungsanleitung

Harman Kardon

Harman Kardon HK6300 Bedienungsanleitung

NAD

NAD T975 Bedienungsanleitung

McIntosh

McIntosh MA6850 Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix ENGLISH MUFF’N Bedienungsanleitung

Viatron

Viatron Autrix Bedienungsanleitung

GME

GME GA9800 Bedienungsanleitung

Atlas

Atlas CP700 Bedienungsanleitung

Roland

Roland KC-1000 Bedienungsanleitung

Pyle

Pyle PFMRA350BW Bedienungsanleitung

Advantage

Advantage S-250 Bedienungsanleitung

IRT Electronics

IRT Electronics DVA-3007 Bedienungsanleitung

Dimavery

Dimavery BA-100 Series Bedienungsanleitung

Sony

Sony XM-S400D Bedienungsanleitung

Schertler

Schertler ROY X Bedienungsanleitung