3
TechnicalDept.-Allrightsreserved-Reproductionprohibited
11-PRECAUTIONS BEFORE START-UP
WARNINGS BEFORE IGNITION
GENERAL WARNINGS
Removeallpartsthatmayburnfromthebrazierandtheglass(manual,variousadhesivelabelsoranypolystyrene).
Check that the brazier is positioned correctly and rests properly on the base.
The rst start-up may not be successful as the feed screw is empty and does not always manage to load the brazier
with the required amount of pellets in time to light the ame.
CLEAR THE FAILED IGNITION ALARM FROM THE STOVE PANEL OR APP.
REMOVE THE PELLETS LEFT IN THE BRAZIER AND REPEAT IGNITION. (SEE “SAFETY DEVICES/ALARMS” PARAGRAPH)
If,afterrepeatedattempts,theamefailstoignite,despitearegularowofpellets,checkthe correctpositioning ofthebrazier,which
mustrestsnuglyagainsttheslots.Ifnoanomalyisfoundduringthisinspection,theremaybeaproblemwiththeproductcomponents
orinstallationmaynotbecorrect.
REMOVE THE PELLETS FROM THE BRAZIER AND CONTACT AN AUTHORISED TECHNICIAN.
Do not touch the stove during the rst start-up, as it is during this phase that the paint sets. If you touch the paint,
you may expose the steel surface.
It is good practice to ensure eective ventilation in the room during the initial start-up, as the stove will emit some
smoke and smell of paint.
Ifnecessary,touchupthepaintwiththespraycanofthespeciccolour.
Donotstandclosetothestoveand,asmentioned,airouttheroom.Thesmokeandsmellofpaintwilldisappearafteraboutanhourof
operation,however,theyarenotharmfulinanycase.
The product will be subject to expansion and contraction during the start-up and cooling stages, therefore slight
creaking noises may be heard. This is absolutely normal and must not be considered a defect as the structure is made
of laminated steel.
Uponrst ignition, forthe rst pellethopper, it isrecommendedto startthe stoveatmaximum powersothat thestructureandthe
smellofthepaintsettlemorequickly.
Itisrecommendedtoinstalltheceramicorserpentinestonecladdingaftertherstsuccessfulignition.
DO NOT EXPECT HEATING EFFICIENCY IMMEDIATELY!!!
