a. Enter http://mwlogin.net in the address bar of the web browser. Create a login
password when prompted, then click OK.
b. Click Next to start Quick Setup. Choose your connection type. If you are unsure of your
connection type, choose Auto-Detect. Then click Next.
Note: If the login window does not appear, please refer to FAQ>Q1.
d. Customize your wireless network name and password, then click Next.c. Enter the parameters provided by your ISP and then click Next. Here we take PPPoE as
an example.
e. Click Finish to complete the setup.
2
Q1. What can I do if the login window does not appear?
A1. If the computer is set to a static IP address, change it to obtain an IP address automatically.
A2. Verify that http://mwlogin.net is correctly entered in the web browser.
A3. Use another web browser and try again.
A4. Reboot your router and try again.
A5. Disable the network adapter used currently and then enable it again.
FAQ (Frequently Asked Questions)
Q2. What can I do if I cannot access the Internet?
A1. Check if the Internet is working properly by connecting a computer directly to the modem via
Ethernet cable.
If not, contact your Internet Service Provider.
A2. Open a web browser, enter http://mwlogin.net and try to set up again.
A3. Reboot your router and try again.
Note: For cable modem users, reboot the modem rst. If the problem still exists, log in to the web
management page, go to Network>MAC Clone, click Clone MAC Address and Save.
A1. With the router powered on, press and hold the WPS/RESET button on the rear panel for at
least 5 seconds until all the LEDs turn on temporarily.
Q3. How do I restore the router to its factory default settings?
A2. Log in to the web management page of the router, and go to System Tools>Factory Defaults,
click Restore, then wait until the process completes.
Q4. What can I do if I forget my web management page password?
Q5. What can I do if I forget my wireless network password?
A. Restore the router to its factory default settings and then create a new password when
prompted.
A2. If you have set password for the network, log in to the router’s web management page, go to
Wireless>Wireless Security to obtain or reset your password.
A1. By default, the wireless network has no password.
LED Indicators
Congure the router using a web browser.
Password
Conrm Password
OK
Quick Setup - WAN Connection Type
Auto-Detect (Recommended)
PPPoE
Dynamic IP
Static IP
Back Next
Username:
Password:
Conrm Password:
Back Next
Quick Setup - PPPoE Quick Setup - Wireless Settings
Wireless Security:
WPA-PSK/WPA2-PSK
Disable Security
Wireless Password:
Back Next
SSID: MERCUSYS_XXXX
XXXXXXXX
**********
******
******
**********
**********
Click Finish to nish the Quick Setup
Back Finish
Quick Setup
LED Name Status Indication
LAN
WAN
O
On
Flashing
The corresponding port is not connected.
The corresponding port is connected.
The corresponding port is transmitting/receiving data.
POWER
O Power is o.
Power is on.On
Flashing Slowly Connection via WPS is in process.
Connection via WPS is failed.
Flashing Quickly
©2016 MERCUSYS
Enjoy!
Now your wired and wireless devices can connect to the Internet!
