Messoa SPD970 Bedienungsanleitung

PTZ Dome Network Camera

User Manual

A.2

NOTICE

Please read this manual thoroughly and save it for future use before attempting to connect or operate this unit.

Table of Content

1Product Overview 6

1.1 Physical Characteristics 6

2Installation and Connection 9

2.1 Unpack Everything 9

2.2 Installation 9

2.2.1 Checking Appearance 9

2.2.2 Installing the Camera 10

2.2.3 Connecting the wires 11

2.2.4 Network Topology 12

2.2.5 System Requirements 13

2.3 Connection 14

2.3.1 Default IP address 14

2.3.2 Connecting from a computer & Viewing Preparation 14

2.4 IP Finder 18

3Administration and Configuration 19

3.1 Live View 19

3.2 PTZ Panel 20

3.3 Configuration 21

3.3.1 Information 21

3.3.2 Image Parameter 21

3.3.3 Network Settings 31

3.3.4 System Settings 39

3.3.5 Event Settings 44

3.3.6 Pan/Tilt Control 51

3.3.7 SD Card Information 54

WARNING

This unit operates at AC 24V/ PoE+.

Installation and service should be performed only by qualified and experienced technicians and comply

with all local codes and rules to maintain your warranty.

To reduce the risk of fire or electric shock, do not expose the product to rain or moisture.

Wipe the camera with a dry soft cloth. For tough stains, slightly apply with diluted neutral detergent and

wipe with a dry soft cloth.

Do not apply benzene or thinner to the camera, which may cause the surface of the unit to be melted or

lens to be fogged.

Avoid aligning the lens to very bright objects (example, light fixtures) for long periods of time.

Although this unit is waterproof and suitable for both indoor and outdoor usages, please do not sink the

unit into water. Contact your dealer in case of sunk.

Avoid operating or storing the unit in the following locations:

Extremely humid, dusty, or hot/cold environments (recommended operating temperature: -40°C to

+50°C )

Close to sources of powerful radio or TV transmitters

Close to fluorescent lamps or objects with reflections

Under unstable or flickering light sources

WEEE (Waste Electrical and Electronic Equipment). Correct disposal of this product

(applicable in the European Union and other European countries with separate collection

systems). This product should be disposed of, at the end of its useful life, as per applicable

local laws, regulations, and procedures.

FCC Compliance Statement

Information to the user: This unit has been tested and found to comply with the limits for a ClassA digital

device pursuant to Part 15B of the FCC Rules. Operation is subject to the following two conditions: (1) this

device may not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This unit generates, uses, and can radiate

radio frequency energy and, if not installed and used in accordance with the manual, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in a

particular installation.

f this unit does cause harmful interference to radio or television reception, which can be determined by turning

the unit off and on, the user is encouraged to try to correct the interference. For example, try reorienting or

relocating the receiving antenna, increasing the separation between the unit and receiver, or connecting the

unit to an outlet on a different circuit.

Caution Changes or modifications not expressly approved by the party responsible for compliance

could void the user‟s authority to operate the unit.

CE Statement

Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may cause undesired operation.

The manufacturer declares that the unit supplied with this guide is compliant with the essential protection

requirements of EMC directive and General Product Safety Directive GPSD conforming to requirements of

standards EN55022 for emission, EN 50130-4 for immunity.

Preface

This user manual is designed as a reference for the installation and manipulations of the unit including the

camera‟s features, functions, and detailed explanation of the menu tree. The reader is supposed to be able to

get following information in the manual.

Product Overview: the main functions and system requirements of the unit.

Installation and Connection: instructions on unit installation and wire connections.

Administration and Configuration: the main menu navigation and controls explanations.

1Product Overview

1.1 Physical Characteristics

TABLE 1-1: PICTORIAL INDEX DEFINITION

Index #

Connector

Descriptions

RJ-45

Ethernet/PoE+ connection. Cabling this port to the RJ-45

jack of standard network devices for connection or PoE+

compatible devices for power supply to the unit as well.

Power Input Terminal

(Black/White)

Connecting the power terminal with a power supply. Make

sure to wire the terminals to correct jacks (Red+/White–).

Void this connector if PoE+ applicable.

Reset (Orange/White)

Connecting to power box PCBA for resetting the unit by

pressing and holding the reset button for 5 seconds or

short-circuiting the 2-PIN connector.

Audio In (Black/White)

Connecting to an auxiliary microphone to record audio

from the unit.

Alarm out open (Light Green)

Connecting to the device that responds to alarm signals.

Alarm out com (Black)

Alarm out close (Purple)

Alarm in 5 (Blue)

Connecting to the device that triggers alarm signals.

Alarm in 6 (Green)

Alarm in GND (White)

Alarm In 1 (Red)

Connecting to the device that triggers alarm signals.

Alarm in 2 (Brown)

Alarm In 3 (Yellow)

Connecting to the device that triggers alarm signals.

Alarm in 4 (Orange)

Default (Pink/Gray)

Connecting to the device that responds to setting factory

default.

Main signal connector

Sending/receiving signals information.

Safety Wire

Keeping the camera from falling off.

Caution

Never connect more than one type of power supply (PoE+ IEEE802.3at Ethernet Class 4 or

AC 24V power plug) at the same time to avoid damage to the unit.

Note

Connectors and field wiring terminal for external Class 2 circuits provided with marking

indicating minimum Class of wiring to be used. Class 2 shall be marked adjacent to the field

wiring terminals.

2Installation and Connection

2.1 Unpack Everything

Check everything in the packing box matches to the order form and the packing slip. In addition to this manual,

items below are included in the packing box.

One PTZ Dome Network Camera

One printed quick installation guide

One RJ-45 coupler

One Allen wrench (4mm)

One Screw (1/4-20UNC,12mm)

One Torx wrench (33x90L)

Please contact your dealer if any item missing.

2.2 Installation

Following tools might help you complete the installation:

A drill

Screwdrivers

Wire cutters

2.2.1 Checking Appearance

When first unboxing, please check whether if there is any visible damage to the appearance of the unit and its

accessories. The protective materials used for the packaging should be able to protect the unit from most of

accidents during transportation.

Please remove the protective film of the unit when every item is checked in accordance with the list in 2.1

Unpacking Everything.

Inhaltsverzeichnis

Andere Messoa Sicherheitskamera Handbücher

Messoa

Messoa A101RZ Bedienungsanleitung

Messoa

Messoa SDF418 Bedienungsanleitung

Messoa

Messoa NCB752 Bedienungsanleitung

Messoa

Messoa UFD301 Bedienungsanleitung

Messoa

Messoa NCR375 Bedienungsanleitung

Messoa

Messoa NDF831-HN5 Bedienungsanleitung

Messoa

Messoa SCR515PRO Bedienungsanleitung

Messoa

Messoa NOD316 Bedienungsanleitung

Messoa

Messoa NIC990 Bedienungsanleitung

Messoa

Messoa NDR891(H) Bedienungsanleitung

Messoa

Messoa PTZ900 Bedienungsanleitung

Messoa

Messoa NDF821PRO Bedienungsanleitung

Messoa

Messoa HCR176 Bedienungsanleitung

Messoa

Messoa SCB290-HN5 Bedienungsanleitung

Messoa

Messoa NCC800 Bedienungsanleitung

Messoa

Messoa SCB267-HN5 Bedienungsanleitung

Messoa

Messoa NCB750 Bedienungsanleitung

Messoa

Messoa SPD982 Bedienungsanleitung

Messoa

Messoa NCC700 Bedienungsanleitung

Messoa

Messoa NDR891 Bedienungsanleitung

Messoa

Messoa LPR606 Bedienungsanleitung

Messoa

Messoa NIC990 Bedienungsanleitung

Messoa

Messoa PTZ900 Bedienungsanleitung

Messoa

Messoa SCB280 Bedienungsanleitung

Beliebte Sicherheitskamera Handbücher anderer Marken

Okina USA

Okina USA SIR36-870VF650LP Bedienungsanleitung

Divio

Divio NDR155PA Bedienungsanleitung

Canon

Canon VB-C500D Bedienungsanleitung

Easy Access

Easy Access EasyGuard Bedienungsanleitung

Vivotek

Vivotek FD9389-EHV-v2 Bedienungsanleitung

TUYA

TUYA COSMO W2 Bedienungsanleitung

Eusso

Eusso UNC7500-IR Einrichtungshandbuch

urmet domus

urmet domus 1096/204 Bedienungsanleitung

VC VC20 series Bedienungsanleitung

Axis

Axis Q1614 Bedienungsanleitung

ieGeek

ieGeek DD201 Bedienungsanleitung

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Bedienungsanleitung

Vicon

Vicon V662-D-1 Betriebsanleitung

Grundig

Grundig GCH-K0274P Bedienungsanleitung

Lorex

Lorex VANTAGE LBC7032 Bedienungsanleitung

4xem

4xem WPT Bedienungsanleitung

Samsung

Samsung SCV-3082 Bedienungsanleitung

Vitek

Vitek VTC-C544 Bedienungsanleitung