MFJ MFJ-9201 Bedienungsanleitung

INSTRUCTION MANUAL

CAUTION: Read All Instructions Before Operating Equipment

MFJ ENTERPRISES, INC.

300 Industrial Park Road

Starkville, MS 39759 USA

Tel: 662-323-5869 Fax: 662-323-6551

Model MFJ-9201

VERSION 1A

MFJ-9201 QRPocket Antenna Tuner Instruction Manual

INTRODUCTION

The MFJ-9201 QRPocket Antenna Tuner was specially compact-built for MFJ-

9200 series QRPocket CW Transcievers and other rigs with a built-in SWR

Meter.

You can operate 80 through 10 Meters -- anywhere with any transceiver -- use

any coax fed or random wire antenna. It’s great for mobile, base, backpack, etc.

The MFJ-9201 handles 100 watts RF output and has a tuner bypass switch. The

MFJ-9201 has BNC connectors for input and output.

INSTALLATION

The MFJ-9201 should be installed between the transmitter and antenna.

1. Locate the tuner in a convenient location at the operating position.

2. Use a 50 ohm coaxial cable to connect the transmitter or transceiver to the

BNC connector labeled XMTR on the tuner.

3.Connect an antenna feedline to the antenna BNC connector labeled ANT.

OPERATION

This tuner has a BYPASS/TUNE switch located on the unit. Simply place the

switch toward the BYPASS position to completely bypass the tuning circuit.

Change the switch toward the TUNE position to place the tuning circuit

between the transmitter/transceiver and the antenna.

In this tuner the TRANSMITTER and ANTENNA matching controls have

maximum capacitance at position 0 (fully meshed), and minimum capacitance at

position 10 (fully open). Be sure to use the highest possible capacitance for

each band. This will provide the smoothest tuning, highest efficiency, and

greatest power handling capability.

The INDUCTANCE switch has maximum inductance in positions "A" and “B”,

with minimum inductance in position "L". The use of two maximum inductance

settings improves the voltage rating and helps prevent carbon arcing. Less

inductance is needed as the frequency is increased. If too little inductance is

used, the tuner may not match the load properly. If too much inductance is used,

the tuner will be "touchy", power handling will be compromised (capacitors

could arc, etc.) and the bandwidth will not be as wide.

MFJ-9201 QRPocket Antenna Tuner Instruction Manual

Special Note: Always use the minimum amount of inductance as possible.

Minimum inductance gives the best efficiency, maximum power

handling, and widest bandwidth.

The MFJ-9201 covers 80 through 10 meters. Do not operate on 160 meters.

Tuning Procedure:

1. Position the TRANSMITTER control to 5 on the corresponding scale.

2. Position the ANTENNA control to 0 on the corresponding scale.

3. Place the BYPASS/TUNE switch in the TUNE position.

4. Apply just enough power to obtain noticeable deflection on your reflected

power meter or SWR meter.

5. Adjust the INDUCTOR control for lowest deflection on the reflected power.

6. Carefully adjust the TRANSMITTER control for the lowest reflected

power, then increase the ANTENNA control slightly and adjust the

TRANSMITTER control for the lowest reflected power. Again, increase

the ANTENNA control slightly and adjust the TRANSMITTER control for

lowest reflected power. Repeat this process for lowest reflected power.

Note: These controls interact. Go back and forth between these adjustments

as many times as required until the lowest reflected power (best SWR)

is obtained.

7. After the lowest reflected power (or SWR) is obtained in step 6, use the

INDUCTOR switch to reduce the inductance one switch position (L is the

lowest inductance setting). Adjust the TRANSMITTER and ANTENNA

controls for the lowest SWR. Continue this process until the lowest SWR

cannot be repeated, then use the INDUCTOR switch to increase the

inductance by one switch position (A is the highest inductance setting).

Tune for lowest SWR.

WARNING: Never transmit while changing the INDUCTOR switch.

Note: Always use as little inductance as possible. Step 7 minimizes the

inductance and maximizes the capacitance.

8. After a low SWR is obtained, the transmitter power may be increased to any

value up to 100 watts.

WARNING: Do not exceed 100 watts output. You will damage

the tuner!

Inhaltsverzeichnis

Andere MFJ Tuner Handbücher

MFJ

MFJ VersaTuner III Bedienungsanleitung

MFJ

MFJ MFJ-926 Bedienungsanleitung

MFJ

MFJ MFJ-926B Bedienungsanleitung

MFJ

MFJ MFJ-993BRT Bedienungsanleitung

MFJ

MFJ MFJ-949C Bedienungsanleitung

MFJ

MFJ VersaTuner V -989D Bedienungsanleitung

MFJ

MFJ MFJ-9234 Bedienungsanleitung

MFJ

MFJ Differential-T Tuner -986 Bedienungsanleitung

MFJ

MFJ MFJ-1642 Bedienungsanleitung

MFJ

MFJ MatchMaker 212 Bedienungsanleitung

MFJ

MFJ MFJ-924 Bedienungsanleitung

MFJ

MFJ MFJ-923 Bedienungsanleitung

MFJ

MFJ MFJ-991B Bedienungsanleitung

MFJ

MFJ MFJ-976 Bedienungsanleitung

MFJ

MFJ IntelliTuner MFJ-993 Bedienungsanleitung

MFJ

MFJ MFJ-993 Bedienungsanleitung

MFJ

MFJ 904 Bedienungsanleitung

MFJ

MFJ VERSA TUNER II MFJ-941D Bedienungsanleitung

MFJ

MFJ MFJ-949C Bedienungsanleitung

MFJ

MFJ 945D Bedienungsanleitung

MFJ

MFJ IntelliTuner -991 Bedienungsanleitung

MFJ

MFJ MFJ-974H Bedienungsanleitung

MFJ

MFJ Versa Tuner II 941D Bedienungsanleitung

MFJ

MFJ -969 DELUXE Versa Tuner II Bedienungsanleitung

Beliebte Tuner Handbücher anderer Marken

Tunersys

Tunersys WS16 1 Bedienungsanleitung

Arcam

Arcam DT91 Bedienungsanleitung

Magnum

Magnum MD 102T Bedienungsanleitung

HDHomeRun

HDHomeRun 20121008 Bedienungsanleitung

Crestron

Crestron C2N-TXM Bedienungsanleitung

Eico

Eico HFT-92 Bedienungsanleitung

NAD

NAD C 445 Bedienungsanleitung

Sony

Sony ST-SA5ES Bedienungsanleitung

Sirius Satellite Radio

Sirius Satellite Radio SC-FM1 Bedienungsanleitung

Antique Automobile Radio

Antique Automobile Radio 283501B Bedienungsanleitung

Monacor

Monacor PA-1200R Bedienungsanleitung

Technics

Technics ST-X301L Bedienungsanleitung

Manhattan

Manhattan 176156 Bedienungsanleitung

Marantz

Marantz ST-15S1 Bedienungsanleitung

Korg

Korg HA-40 Bedienungsanleitung

Harman Kardon

Harman Kardon TU915 Bedienungsanleitung

Teac

Teac T-1D Bedienungsanleitung

Pioneer

Pioneer GEX-P700DAB Bedienungsanleitung