Midea C03 Bedienungsanleitung
Service Manual
Washing Machine
Model:C03
Note：
Before service the unit, please read this manual first.
Contact with your service center if meet problem
Contents
2
1 PRECAUTION ………………….………………..…………………………………………………. 3
1.1 Safety Precautions
1.2 Servicing Precaution
1.3 Cautions For Safety
2 PRODUCT SPECIFICATIONS ……………………………………………………………….. 7
3 USER MANUAL …………………………………………………………………………………. 17
4 WIRING DIAGRAM /PCB LAYOUT ………………………………………………………… 18
5 FACTORY PATT DETECTION …………….…………………………………………………… 20
6 MALFUNCTIONS CODES AND EXPLANATIONS ……………………………………… 24
7 TROUBLESHOOTING …………………………………………………………………………… 27
7.1 Maintenance non-heating malfunction
7.2 Door non-locked & its maintenance
7.3 Door non-locked & its maintenance
7.4 Heating beyond the setting temperature its maintenance
7.5 Maintenance of non-drain or drain exceed the setting time
7.6 Water inlet overflow malfunction maintenance
7.7 Drum non-rotating malfunction maintenance
7.8 Maintenance water inlet and water outlet at the same time
8 CHECK POINT OF CIRCUIT …………………………………………………………………… 37
9 UNPACKING WAYS OF MAIN PARTS ……………………………………………………… 40
9.1. Undo the back cover
9.2. Undo top cover
9.3. Undo the control panel and PCB
9.4. Undo the door assembly
9.5. Undo the front plate
9.6. Undo the detergent box
9.7. Undo the inlet valve
9.8. Undo the pressure switch
9.9. Undo the drain pump
9.10. Undo the pulley and motor
9.11. Undo the absorber pin from the cabinet
9.12.Undo the drum tub assembly
9.13. Undo the absorber pin from the drum
9.14.Undo the heater and NTC
10 SERVICE TOOLS ……..…………………………………………………………………………. 47
3
When performing troubleshooting and part replacement during servicing, note the
following safety
precautions:
1.1 Safety Precautions
1.1.1 Use Genuine Parts
The components of the washing machine have safety features such as non-combustibility
and voltage with standing. Therefore, always use the same part as suggested by the maker.
In particular be sure
to use only designated parts in case of major safety parts identified by the marker.
1.1.2 Grounding
Connect the grounding wire to the shell plate ,and bury it under at least 25cm of earth:
alternatively, connect the ground wire to the appropriate pin on a properly grounded
power receptacle. Never connect the wire to a telephone line, lightning rod, or gas pipe.
1.2 Servicing Precautions
1.2.1Observe Warnings
Be sure to follow special warning and precautions that are described on part labels and in
the owner'
manual.
1.2.2 Parts Assembly and Wiring
Be sure to use insulation material(such as tube and tape).And be sure to restore all parts
and wires to their original position. Take special care to avoid contact with sharp edges.
1.2.3 Perform Safety Checks after Servicing
After servicing, check to see that the screws, parts, and wiring are restored to their
original positions, and check the insulation between the external metals and the socket
plug. In addition, place the washing machine in a level position (less than1 degree)to
prevent vibration and noise during operations.
1.2.4 Insulation Checks
Pull out the plug from the power receptacle, pour water into the spin tub, and then set
the timer.
Check to see that the resistance insulation between the terminals of the plug and the
externally
exposed metal is greater than 1M .
Note :When it is impossible to insulation check with a 500V insulation resistance
tester, use other testers for inspection.
1 PRECAUTION
1.3 CAUTIONS FOR SAFETY
•Please observe the following notes for safety.
•The symbols indicate as follows.
4
Symbol Meaning
WARNING
Indicates possibility of death or serious injury of a repair
technician and a person nearby through the misconducted
work , or of a user by a defect of the product after the work
performed by the technician.
CAUTION
Indicates possibility of injury or physical damages* of a
repair technician and a person nearby through the
misconducted work , or of a user by a defect of the product
after the work performed by the technician.
Symbol Meaning
ELECTRIC SHOCK
Indicates a caution (including a warning).
Specific instruction is followed by a graphic or characters in
or near.
Symbol left warns an electric shock.
DO NOT DISASSEMBLE
Indicates prohibition (act must not be conducted).
Specific instruction is followed by a graphic or characters in
or near.
DO NOT Symbol left warns not to disassemble.
UNPLUG
Indicates forcing (act must be conducted).
Specific instruction is followed by a graphic or characters in
or near .
Symbol left warns to unplug the power cord.
* Means secondary damages of property, furniture , domestic animal and pet.
Symbol Meaning
OUT OF CHILD
Advise the customer to keep children out of the work place.
Children may be injured with a tool or a disassembled part.
UNPLUG POWER
Unplug power cord for the work such as disassembling
which is not
unnecessary to power on . Do not hold the plug by a wet hand.
Failing to unplug may cause an electric shock.
USE REPAIR PARTS
Use the specified repair parts when repairing the product.
Otherwise , amalfunction or a defect may occur.
Also , a short circuit , ignition or other danger to the
customer may occur.
1 PRECAUTION
5
WARNING
CHECK INSULATION
RESISTANCE
After repair, measure insulation resistance between the
charging part(power cord plug) and the non-charging
metallic part (ground) with an insulation resistance meter
(500V).The resistance shall be 10M or more.
Failing to check the insulation resistance may cause a short
circuit, electric shock or other diseases to the customer.
DO NOT MODIF
Do not modify the product.
An electric shock or ignition may occur.
DO NOT MODIFY
Only a repair technician can disassemble and repair.
An electric shock, ignition or malfunction may cause injury.
USE EXCLUSIVE
SOCKET
Use an exclusive 110 VAC/15 A socket for the washing
machine.
Use an exclusive 220VAC/17A socket for the washing
machine.
Otherwise , an electric shock or ignition may cause. Sharing
the same socket with other instrument causes heating of a
branch socket and result in a fire.
CONNECT
GROUNDING WIRE
Connect the grounding wire.
Failing to do so may cause an electric shock when a short
circuit occurs.
Consult an electric work shop or a sales shop.
DO NOT USE WET
PLACE
Do not install in a bath room or a place exposed to wind or
rain.
An electric shock or a short circuit may cause a fire.
DO NOT SPLASH
WATER
Do not pour or immerse electrical parts into water or liquid
solution.
An electric shock or ignition may occur.
REMOVE DUST
Wipe off dust adhered to the plug of power cord.
Dust may cause a fire.
AVOID
INFLAMMABLE
Do not put inflammable into the washing tub.
Do not put cloths stained with kerosene, gasoline, benzene,
thinner, alcohol, etc. lt may cause a fire or explosion.
1 PRECAUTION
6
WARNING
DO NOT TOUCH
Do not touch the laundry before the spin basket stops
completely.
The laundry entangles your hand causing an injury even if
the basket rotates slowly. Pay special attention to children.
INSTALL
CAREFULLY
Ask an electric work shop to install the product.
Install the product securely and safely according to the
electrical equipment technical standard and the wiring
standard.
Incorrect work causes an electric shock and a fire.
DO NOT PULL
Do not pull the power cord when unplugging.
Hold the power plug to unplug.
An electric shock or short circuit may cause a fire.
DANGER HAND
Do not insert your hand under the washing machine during
operation.
There is a rotary part under the machine which may cause
an injury.
WATER LEAKAGE
Before starting washing, open the faucet and check water
supply hose joint which shall not be loosened for no water
leaks.
The loose screw or hose joint may cause water leakage
resulting in an unexpected damage.
1 PRECAUTION
7
Product Specifications
Model Series C03
Model Name EU(A3)-FC80-S12/C1903E
EU(A3)-FC80-S14/C1903E
IR(A3)-FC80-S14S/C1903E
Color White
Features
Washing Capacity 8kg
Rated Spinning Capacity 8kg
Power Supply 220-240 V
Rated Frequency 50Hz
Rated Power 2000W
Rated Current 10A
Max. Spin Speed 1200RPM/1400RPM/1400RPM
Display Type LED
Motor Universal Motor
Energy Rating
Energy Efficiency Class A+++
Washing Performance Class A
Spin-drying Efficiency Class B
Annual energy consumption
(AEC) 196Kwh/annum
Weighted annual water
consumption (AWC) 11000L/annum
Specifications
Net Dimensions (W×D×H) 595 × 565 × 850mm
Net Weight 70Kg
Gross Weight 75Kg
2 PRODUCT SPECIFICATIONS
8
Product Specifications
Model Series C03
Model Name MFC80-S1403/C14E-AE(5)
Color White
Features
Washing Capacity 8kg
Rated Spinning Capacity 8kg
Power Supply 220-240 V
Rated Frequency 50Hz
Rated Power 2000W
Rated Current 10A
Max. Spin Speed 1400RPM
Display Type LED
Motor Universal Motor
Energy Rating
Energy Efficiency Class UAE ★★★★★
Washing Performance Class -
Spin-drying Efficiency Class -
Annual energy consumption
(UAE) 187Kwh/year
Weighted annual water
consumption (UAE) 14300L/year
Specifications
Net Dimensions (W×D×H) 595 × 565 × 850mm
Net Weight 70Kg
Gross Weight 75Kg
2 PRODUCT SPECIFICATIONS
9
Product Specifications
Model Series C03
Model Name SA(4)-FC75-S12/C1903E
MFC75-S1403/C14E-SA(4)
Color White
Features
Washing Capacity 7.5kg
Rated Spinning Capacity 7.5kg
Power Supply 220-230 V
Rated Frequency 60Hz
Rated Power 2000W
Rated Current 10A
Max. Spin Speed 1200RPM/1400RPM
Display Type LED
Motor Universal Motor
Energy Rating
Energy Efficiency Class SA ★★★★
Washing Performance Class -
Spin-drying Efficiency Class -
Annual energy consumption
(SA) 665Kwh/year
Weighted annual water
consumption (SA) 55L/cycle 54L/cycle
Specifications
Net Dimensions (W×D×H) 595 × 565 × 850mm
Net Weight 70Kg
Gross Weight 75Kg
2 PRODUCT SPECIFICATIONS
10
Product Specifications
Model Series C03
Model Name EU(A3)-FC70-S12/C1903E
EU(A3)-FC70-S14/C1903E
IR(A3)-FC70-S14S/C1903E
Color White
Features
Washing Capacity 7kg
Rated Spinning Capacity 7kg
Power Supply 220-240 V
Rated Frequency 50Hz
Rated Power 2050W
Rated Current 10A
Max. Spin Speed 1200RPM/1400RPM/1400RPM
Display Type LED
Motor Universal Motor
Energy Rating
Energy Efficiency Class A+++
Washing Performance Class A
Spin-drying Efficiency Class B
Annual energy consumption
(AEC) 175Kwh/annum
Weighted annual water
consumption (AWC) 10000L/annum
Specifications
Net Dimensions (W×D×H) 595 × 495 × 850mm
Net Weight 61Kg
Gross Weight 65Kg
2 PRODUCT SPECIFICATIONS
Inhaltsverzeichnis
Andere Midea Waschmaschine Handbücher
Midea
Midea MFW-701S Bedienungsanleitung
Midea
Midea MLH52N5AWW Handbuch
Midea
Midea G06 Bedienungsanleitung
Midea
Midea MF710W Bedienungsanleitung
Midea
Midea MFC80-JS1403B/C14E-AU Bedienungsanleitung
Midea
Midea MA500W21/W Bedienungsanleitung
Midea
Midea MJ70N68P Bedienungsanleitung
Midea
Midea X8 Bedienungsanleitung
Midea
Midea DMWM55 Bedienungsanleitung
Midea
Midea MFL80-ES1200 Bedienungsanleitung
Midea
Midea MF200W70B/E Bedienungsanleitung
Midea
Midea DMWM55G2 Bedienungsanleitung
Midea
Midea MLH27N5AWWC Handbuch
Midea
Midea MF700S Bedienungsanleitung
Midea
Midea MFL80S14 Bedienungsanleitung
Midea
Midea MLV47C3AWW Handbuch
Midea
Midea MF200W100WB Series Bedienungsanleitung
Midea
Midea MFL70S12 Bedienungsanleitung
Midea
Midea DMWM80 Bedienungsanleitung
Midea
Midea MLV45N1BWWC Handbuch
