Wall Mounting Instructions
7
It is important that walls or plaster be completely dry before installing
a board, as any moisture may cause the panel inserts to warp.
Complete hanging hardware is included with each unit. If wall
construction prevents the use of hardware as furnished, it is the
responsibility of the customer to furnish the required fasteners.
REFER TO WALL MOUNTING DIAGRAM ON PAGE 8
1) Locate wall studs on which to attach mounting rail. Determine
desired mounting height, measuring from the floor to the top of the
unit. Snap a chalkline along the wall at the desired location for the top
edge of the Crest-Line unit.
2) Mark the hole locations along the mounting rail (long leg up) to
correspond with stud locations in the wall. NOTE: Minimum hole
locations is 6” in from each end of the mounting rail and at approxi-
mately 24” spacing along the length of the mounting rail). Drill 13/64”
holes at each location marked on the mounting rail.
3) Align mounting rail (long leg up) along chalkline and mark on the
wall the location of the holes drilled into the mounting rail. At each
hole location marked on the wall, drill 1/4” holes 1” deep for expansion
plugs.
4) Install the mounting rail with the long leg up. It may be necessary
to shim out the mounting rail on uneven or irregular walls.
5) Subtract 1-1/4” from overall height measurement of unit being
installed. Using this figure, measure down from top of mounting rail.
Install L-Clip screw at this point. Leave L-Clip in down position. L-Clips
should be installed 6” in from each bottom corner and evenly space
along length of board.
6) Hang unit on mounting rail. Make any slight adjustment to desired
position by sliding to left or right. Be sure unit is hanging level.
7) Tap L-Clips up against bottom of the unit and drill holes into alumi-
num trim (holes must be smaller than diameter of screws). Fasten clip
to trim with screw furnished.
READ INSTRUCTIONS COMPLETELY BEFORE INSTALLING.
