Minitar MNWAPGR Bedienungsanleitung

MNWAPGR

Wireless 802.11g Access Point / Router

User Manual

The contents of this publication may not be reproduced in any part or as a whole, stored,

transcribed in an information retrieval system, translated into any language, or transmitted in

any form or by any means, mechanical, magnetic, electronic, optical, photocopying, manual, or

otherwise, without prior written permission.

Trademarks

All products, company, brand names are trademarks or registered trademarks of their

respective companies. They are used for identification purpose only. Specifications are subject

to be changed without prior notice.

FCC Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against radio interference in a commercial environment. This equipment can

generate, use and radiate radio frequency energy and, if not installed and used in accordance

with the instructions in this manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause interference, in which case

the user, at his own expense, will be required to take whatever measures are necessary to

correct the interference.

CE Declaration of Conformity

This equipment complies with the requirements relating to electromagnetic compatibility, EN

55022/A1 Class B.

Limitation of Liability

So far as the law permits Minitar Corporation and its distributors shall not be liable in any way

whatsoever for any indirect or consequential loss, or loss of profit or any liability for damage to

property or death of or injury to persons howsoever caused including, but not limited to, any

loss by reason of delay, defective or faulty Products or workmanship, negligence or any act,

matter or thing, done permitted or omitted by Minitar Corporation and its distributors.

The specification is subject to change without notice.

Table of Contents

Chapter 1 Introduction................................................................................4

Functions and Features.................................................................................................... 4

Packing List....................................................................................................................... 6

Chapter 2 Hardware Installation.................................................................7

2.1 Panel Layout............................................................................................................... 7

2.2 Procedure for Hardware Installation........................................................................... 9

Chapter 3 Network Settings and Software Installation ..........................10

3.1 Configuration of the Network Settings of Your Computer......................................... 10

Chapter 4 Configuring the Wireless Broadband Router........................11

4.1 Start-up and Log in.................................................................................................... 12

4.2 Status........................................................................................................................ 13

4.3 Wizard....................................................................................................................... 14

4.4 Basic Setting............................................................................................................. 15

4.4.1 Primary Setup – WAN Type, Virtual Computers ........................................... 15

4.5 Forwarding Rules...................................................................................................... 25

4.5.1 Virtual Server................................................................................................. 26

4.5.2 Special AP..................................................................................................... 27

4.5.3 Miscellaneous Items...................................................................................... 28

4.6 Security Settings....................................................................................................... 29

4.6.1 Packet Filter .................................................................................................. 29

4.6.2 Domain Filter................................................................................................. 34

4.6.3 URL Blocking................................................................................................. 35

4.6.4 MAC Address Control.................................................................................... 37

4.6.5 Miscellaneous Items...................................................................................... 39

4.7 Advanced Settings .................................................................................................... 40

4.7.1 System Time.................................................................................................. 41

4.7.2 System Log ................................................................................................... 42

4.7.3 Dynamic DNS................................................................................................ 43

4.7.4 SNMP Setting................................................................................................ 44

4.7.5 Routing Table ................................................................................................ 45

4.7.6 Schedule Rule............................................................................................... 47

4.8 Toolbox...................................................................................................................... 50

Appendix A TCP/IP Configuration for Windows 95/98...........................55

Appendix B 802.1x Setting .......................................................................60

Appendix C WPA-PSK and WPA..............................................................65

Appendix D FAQ and Troubleshooting ...................................................77

Reset to factory default settings ..................................................................................... 77

Chapter 1 Introduction

Congratulations on your purchase of this outstanding Wireless Broadband Router. This

product is specifically designed for Small Office and Home Office needs. It provides a

complete SOHO solution for Internet surfing and is easy to configure and operate even for

non-technical users. Instructions for installing and configuring this product can be found in this

manual. Before you install and use this product, please read this manual carefully to fully

explore the functions of this product.

Functions and Features

Router Basic functions

zAuto-sensing Ethernet Switch

Equipped with a 4-port auto-sensing Ethernet switch.

zWAN type supported

The router supports these WAN types, Static, Dynamic, PPPoE , PPTP , and Dynamic IP

with Road Runner.

zFirewall

All unwanted packets from outside intruders are blocked to protect your Intranet.

zDHCP server supported

All of the networked computers can retrieve TCP/IP settings automatically from this

product.

zWeb-based configuring

Configurable through any networked computer’s web browser using Netscape or

Internet Explorer.

zVirtual Server supported

Enable you to expose WWW, FTP and other services on your LAN to be accessible by

Internet users.

zUser-Definable Application Sensing Tunnel

User can define the attributes to support the special applications requiring multiple

connections, like Internet gaming, video conferencing, Internet telephony and so on,

then this product can sense the application type and open a multi-port tunnel for it.

zDMZ Host supported

Allows a networked computer be fully exposed to the Internet; this function is used when

the application sensing tunnel feature is insufficient to allow an application to function

correctly.

zWAN Statistics Supported

Enables you to monitor inbound and outbound packets

Wireless functions

zHigh speeds for wireless LAN connection

Up to 54Mbps data rate by incorporating Orthogonal Frequency Division Multiplexing

(OFDM).

zRoaming Support

Provides seamless roaming within the IEEE 802.11b (11M) and IEEE 802.11g (54M)

WLAN infrastructure.

zIEEE 802.11b compatible (11M)

Allowing inter-operation between multiple vendors.

zIEEE 802.11g compatible (54M)

Allowing inter-operation between multiple vendors.

zAuto fallback

- 54M, 48M, 36M, 24M, 18M, 12M, 6M data rate with auto fallback in 802.11g mode.

- 11M, 5.5M, 2M, 1M data rate with auto fallback in 802.11b mode.

Security functions

zPacket filtering

The Packet Filter allows you to control access to a network by analyzing the incoming

and outgoing packets, and letting them pass or halting them based on the IP address of

the source and destination.

zDomain Filtering

Let you prevent users using this device from accessing specific URLs.

zURL Blocking

URL Blocking can block hundreds of websites connection by simply a keyword.

zVPN Pass-through

The router also supports VPN pass-through.

zWPA, WPA-PSK and 802.1X support

With the WPA, WPA-PSK and 802.1X functions is enabled, the wireless user must

authenticate to the router first before using the Network service.

zSPI Mode Support

When the SPI Mode is enabled; the router will check every incoming packet to detect if it

is valid in relation to all current open connections.

zDoS Attack Detection

When this feature is enabled, the router will detect and log the all DOS attacks coming

from the Internet

Advanced functions

zSystem time

Allow you to synchronize the routers system time with a network time server.

zE-mail Alerts

The router can send its security information to you via an email alert.

zDynamic DNS Support

The router can contact popular Dynamic DNS providers to update your dynamic DNS

entry automatically At present,the router supports dyndns.org, tzo.com and dhs.org.

zSNMP Support

The router supports basic SNMP functions to allow external monitoring.

zStatic Routing Table

The router supports the manual addition of Static Routes

zScheduled Rule Support

Customers can control some functions, like virtual server and packet filters based off a

specific timing configuration

Other functions

zuPnP (Universal Plug and Play) Support

The router supports the uPnP protocol for dynamic configuration by applications such as

the Microsoft X-box and Msn Messenger.

Packing List

zWireless broadband router unit

zInstallation CD-ROM

zPower adapter

zCAT-5 UTP Fast Ethernet cable

Chapter 2 Hardware Installation

2.1 Panel Layout

2.1.1. Front Panel

Figure 2-1 Front Panel

LED:

LED Function Color Status Description

POWER Power

indicator Green On Power is being applied to this product.

System

status

indicators

Green Blinking Flashed once per second to indicate system is alive.

On The WAN port is linked.

WAN WAN port

activity Green Blinking The WAN port is sending or receiving data.

Wireless Wireless

activity Green Blinking Sending or receiving data via wireless

On An active station is connected to the corresponding

LAN port.

Link/Act.

1~4 Link status Green

Blinking The corresponding LAN port is sending or receiving

data.

10/100 Data Rate Green On Data is transmitting in 100Mbps on the

corresponding LAN port.

2.1.2. Rear Panel

Figure 2-2 Rear Panel

Ports:

Port Description

PWR Power inlet

WAN The port where you will connect your cable (or DSL) modem or

Ethernet router.

Port 1-4 The ports where you will connect networked computers and other

devices.

Reset The button to reset the units settings to factory defaults

2.2 Procedure for Hardware Installation

2. Decide where to place your Wireless Broadband Router

You can place your Wireless Broadband Router on a desk or other flat surface, or you can

mount it on a wall. For optimal performance, place your Wireless Broadband Router in the

center of your office (or your home) in a location that is away from any potential source of

interference, such as a metal wall or microwave oven. This location must be close to both

power and network connections.

2. Setup LAN connection

a. Wired LAN connection: connects an Ethernet cable from your computer’s Ethernet port

to one of the LAN ports of this product.

b. Wireless LAN connection: locate this product at a proper position to gain the best

transmit performance.

Figure 2-3 Setup of LAN and WAN connections for this product.

3. Setup WAN connection

Prepare an Ethernet cable for connecting this product to your cable/xDSL modem or

Ethernet backbone. Figure 2-3 illustrates the WAN connection.

4. Poweron

By connecting the power cord to the power inlet and turning the power switch on, this

product will automatically enter the self-test phase. When it is in the self-test phase, the

indicator M1 will be lit ON for about 10 seconds, and then M1 will be flashed 3 times to

indicate that the self-test operation has finished. Finally, the M1 indicator will be

continuously flashed once per second to indicate that this product is in normal operation.

Chapter 3 Network Settings and Software Installation

To use this product correctly, you have to properly configure the network settings of your

computers and install the attached setup program onto your MS Windows platform (Windows

95/98/NT/2000/XP).

3.1 Configuration of the Network Settings of Your Computer

The default IP address of this product is 192.168.123.254, and the default subnet mask is

255.255.255.0. These addresses can be changed if required, but the default values are used

in this manual. If the TCP/IP environment of your computer has not yet been configured, you

can refer to Appendix A for information on how to configure it. For example,

1. configure your computer’s IP as 192.168.123.1, subnet mask as 255.255.255.0 and

gateway as 192.168.123.254, or more easier,

2. configure your computer to load TCP/IP setting automatically, that is, via the DHCP

server of this product.

After installing the TCP/IP communication protocol, you can use the ping command to check if

your computer has successfully connected to this product. The following example shows the

ping procedure for the Windows platform. First open up a Command prompt (cmd in 2000/XP,

msdos in 95,98x). Second, execute the ping command

ping 192.168.123.254

If the following messages appear:

Pinging 192.168.123.254 with 32 bytes of data:

Reply from 192.168.123.254: bytes=32 time=2ms TTL=64

Then a communication link between your computer and this product has been successfully

established. Otherwise, if you get the following messages,

Pinging 192.168.123.254 with 32 bytes of data:

Request timed out.

There must be something wrong in your installation procedure. You have to check the following

items in sequence:

1. Is the Ethernet cable correctly connected between this product and your computer?

Tip: The LAN LED of this product and the link LED of the network card on your computer

must both be lit.

2. Is the TCP/IP environment of your computers properly configured?

Tip: If the IP address of this product is 192.168.123.254, the IP address of your

computer must be 192.168.123.X and default gateway must be 192.168.123.254 where

the X is any number between 1 and 253.

Inhaltsverzeichnis

Andere Minitar Drahtloser Zugangspunkt Handbücher

Minitar

Minitar MWGAR Bedienungsanleitung

Beliebte Drahtloser Zugangspunkt Handbücher anderer Marken

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Bedienungsanleitung

Ubiquiti

Ubiquiti NanoStation NSM2 Bedienungsanleitung

Cisco

Cisco Aironet 1550 Series Bedienungsanleitung

Aruba

Aruba IAP-335 Bedienungsanleitung

Advantek Networks

Advantek Networks AWN-AP-54MR Bedienungsanleitung

IP-COM

IP-COM AP355 Bedienungsanleitung

Buffalo

Buffalo AirStation WLA-L11G Bedienungsanleitung

EnGenius

EnGenius EnStationACv2 Bedienungsanleitung

D-Link

D-Link DAP-3662 Bedienungsanleitung

xG Technology

xG Technology xMax CN1300 Bedienungsanleitung

Widelink

Widelink ezWave WAP-1100 Series Bedienungsanleitung

Edimax

Edimax CAP1200 Bedienungsanleitung

Ubiquiti

Ubiquiti LBE-5AC-Gen2 Bedienungsanleitung

Aruba

Aruba AP-203R Bedienungsanleitung

LuXout Shades

LuXout Shades LUXSHADE MOTION Bedienungsanleitung

CreatComm

CreatComm TB5F Bedienungsanleitung

SineDigital

SineDigital MW-1500AP(H) Bedienungsanleitung

TP-Link

TP-Link AP9650 V1 Bedienungsanleitung